Jizhida Technology JT20 User Manual

FCC Caution

Any Changes or modifications not expressly approved by the party responsible for compliance could
void the user's authority to operate the equipment.

This device complies with part 15 of the FCC Rules. Operation is subject to the following two conditions:
(1) This device may not cause harmful interference, and
(2) this device must accept any interference received, including interference that may cause undesired operation.

To maintain compliance with the FCCʼs RF exposure guidelines, hold the transmitter and antenna at

least 1 inch (2.5 centimeters) from your face and speaker in a normal voice, with the antenna pointed
up and away from the face.
This equipment complies with FCC radiation exposure limits set forth for an uncontrolled environment.

In order to compliance with the FCCʼs RF exposure requirements, the antenna installation must

comply with following:
Users must be fully aware of the hazards of the exposure and able to exercise control over
their RF exposure to quality for the higher exposure limits.

Your wireless hand-held portable transceiver contains a low power transmitter.
This product sends out radio frequency (RF) signals when the Push-to-Talk (PTT) button is pressed.
The device is authorized to operate at a duty factor not to exceed 50%

Specific Absorption Rate (SAR) information

SAR tests are conducted using standard operating positions accepted by the FCC with the device transmitting

at its highest certified power level in all tested frequency bands, although the SAR is determined at the highest

certified power level,the actual SAR level of the device while operating can be well below the maximum value.

Before a new model is a available for sale to the public, it must be tested and certified to the FCC that

it does not exceed the exposure limit established by the FCC,

tests for each product are performed in positions and locations as required by the FCC.

For body worn operation, this device has been tested and meets the FCC RF exposure guidelines

when used with an accessory designated for this product or when used with an accessory that contains no metal.

ISEDC warning

This device contains licence-exempt trans mitter(s)/receiver(s) that comply with Innovation, Science and

Economic Development Canada licence-exempt RSS(s).

Operation is subject to the following two conditions:

1. This device may not cause interference.

2. This device must accept any interference, including interference that may cause undesired operation of

the device.Lʼémetteur/récepteur exempt de licence contenu dans le présent appareil est conforme aux CNR
dʼInnovation, Sciences et Développement économique Canada applicables aux appareils radio exempts de licence.

Lʼexploitation est autorisée aux deux conditions suivantes :

1. Lʼappareil ne doit pas produire de brouillage;

2. Lʼappareil doit accepter tout brouillage radioélectrique subi, même si le brouillage est susceptible
dʼencompromettre le fonctionnement.

This equipment complies with ISEDC RF radiation exposure limits set forth for an uncontrolled environment.

This transmitter must not be co-located or operating in conjunction with any other antenna or transmitter.

Cet équipement est conforme aux limites d'exposition aux rayonnements RF de l'ISEDC définies pour
un environnement noncontrôlé.

Cet émetteur ne doit pas être situé ou fonctionner conjointement avec une autre antenne ou un autre émetteur.