After-sales Service Guide......................................... 37
Safety Notice
Safety Notice
For safely and efficiently use the product, please
strictly abide by the rules, otherwise the danger will
happen.
Do not put the product under the direct ray of sunlight,
and use or put it in the extra high and low temperature
environment. If you do these otherwise, that will cause
the distortion of the product and damage of the
electronic component and battery.
Do not put or use it in humidity environment. Do not
let liquid immerge into the product, affected with water
and damp will cause the malfunction of operation of
the internal circuit.
Put the product on a stable place, violently shake or fall
off will cause the damage of the product and its
electronic component.
Do not heavily press the display or put heavy on the
display, prevent the display from breaking or hurting
people.
Safety Notice
Do not put the product in the dust, dirty place and the
place full of erodent air.
Do not use chemical solvent to clean the surface of the
product. Please use the soft cloth to wipe up the dust
from the surface of the screen or the cover. You can use
a little distilled water to erase the dirty on the screen or
the cover.
Do not privately disassemble the product. Only the
qualified maintenance man of our company or
authorized maintenance center can assemble the
product.
Please pay attention to put the product or its fittings on
the place, which the children cannot reach.
Do not put the product near the magnetic field; prevent
it from disturbing of the magnetic field.
Please use the authorized fittings, do not use
unmatched components.
Safety Notice
Battery:
* Do not use the rechargeable battery with damaged
surface.
* If battery leaks liquid, please clean the product and
put the new battery. If the liquid drops on your
body, please carefully clean it.
* Please properly dispose the old and waste batteries.
This product is CE approved.
Structure
N
N
N
g
Structure
Indicator
Screen
Previous Pa
ext Page
umber key
1~5/Bookmark
Bookmark/6
e
Go to index/ 7
Zoom/ 8
Previous Page/9
OK /Menu
Exit
ext Page/0
Front View
Structure
p
Back View
Side View
Reset
Vo l u m e
Up/Down
Rechargeable
Battery
Power On/Off
SD Slot
USB PortEarphone Jack
To
View
Bottom View
Operation
b
Operation
Installing Battery
Open the battery cover on the back of the device.
Charge
Install the battery
according to the
instructions on the
attery slot.
* The Power supply of this product is by rechargeable
battery.
* The battery should be charged at least twelve hours
when firstly use. It's better to recharge it after its power
Operation
completely exhausted. Please do the above-mentioned
process in the first three times use.
* It can be charged by USB cable①. Use one port of
the USB cable to connect the PC, the other port
connects the device. It takes approximately three hours
to charge the battery. The orange light will flash while
the battery is charging and green light will shine steady
when the battery is fully charged.
* It can be also charged by power adapter.② Connect
the device with the power adapter, and plug the power
adapter in the socket (please see the voltage scope on
the adapter ). It takes approximately three hours to
charge the battery. The orange light will flash while the
battery is charging and green light will shine steady
when the battery is fully charged.
* Do not remove the battery while charging.
* Battery volume icon is on the bottom right corner,
when the icon shows one grid volume or system
informs low battery volume, please charge the battery.
Full Lack
* The device can be used while charging, but the
charging time will be increased.
Operation
,
b
* When the battery is charged at beginning period, if
the indicator is still green, this means the power is not
enough for startup and no response for now, please
wait for a moment and pull out the USB cable, then the
device can be start working.
* Do not use unauthorized battery and charger.
* Do not constantly remove the battery.
Installing SD card
Insert the SD
card with the
label facing up
y the arrow
directed.
After insert SD card,
bookshelf interface will
be automatically
displayed. To remove the
SD card, push in the SD
card until you hear a
click
then release it.
Operation
r
Switch On/Off
Switch on:
Press switch on/off button to power on.
Power
On/Off
Power off LOGO
Automatically
ente
Bookshelf
Operation
y
p
Switch off:
Long press switch on/off button for power off.
Long press
ower on/off
An
interface Power off interface
Power off
Loading...
+ 30 hidden pages
You need points to download manuals.
1 point = 1 manual.
You can buy points or you can get point for every manual you upload.