Jingwah Information Technology W808G User Manual

MODEL: RT-1708
USER MANUAL
Preface
Thank you for buying this MID. Please read and retain all the operating instructions before operating the unit.
I. Note
1. Avoid the unit being dropped. Avoid the display been shaken seriously, or the display will be damaged unusually.
2. Do not use metal object to touch the device to prevent it from
1
7. volume+/ volume-
8. Rear Camera
9. Reset
10. Speaker
11. Power on/of
short circuit.
3. Please backup your data in case your important data is lost, especially before you upgrade the firmware.
4. Do not disassemble. Do not wipe the surface of the unit by alcohol, thinner or benzene.
5. Do not disconnect the unit while it is formatting or uploading/downloading, or the procedures may lead to errors.
6. Avoid water or foreign objects enter the unit.
7. Do not use the unit in places that are extremely hot, cold, dusty, or humid.
8. Specifications are subject to change and improvement without notice.
II. Introduction of cover
1. TP
2. Front Camera
3. Earphone Jack Micro
4. (SD)TF-CARD interface
5. Micro USB interface
2
III. Operation Instruction
1. Basic Operation
1.1. Power On/Power Off Power On;
Press and hold the power button for 5 seconds then release; the unit will display the start-up logo and enters in working mode.
Power Off;
Press and hold the power button for 3 seconds to turn the unit off.
Sleep;
While the device is at working status, press the power button once, it will enter in sleeping mode and the screen will be off. Press the power button again; it will shift back to the normal mode. You may use this function when you don’t’ use the device temporary to save power.
1.2. Charging
When the device prompts “low battery”, please charge it with
provided power charger.
Please connect the USB charger to “port 5
In general, it takes 4 to 5 hours charging from 0% to 100% when the screen is powered off, it will take longer to charge when screen is on. For safety, we do not recommend overcharge more than 12 hours.
3
Note: To improve the longevity of the battery, you may charge for another 15 minutes after it prompts the battery is full.
1. Settings
Click “Settings” in the main interface to enter the setting interface. Click the corresponding setting items to operate. Here you can make adjustments for example; change display settings, adjust date & time, set password under Security, adjust sound and notifications, set data limits, check battery performance, set users, and much more.
4
1.1Date and Time Setting
Click on “Date & time” in the setting interface, to make date and time adjustments. You may set the date, time zone, time, time format and date format etc. in the menu.
1.2. Brightness
Select “Display” in the setting interface. Click on “Brightness” to enter and slide the bar to adjust the brightness.
5
1.3. Wi-Fi connection
Click “Settings” in the main interface. Click on Wi-Fi to turn on the WIFI, it will lists the open networks in that area. Click the name of the network; it will display a password window. You may connect it to WIFI according to the prompts. You need to input the user name and password if networks are encrypted.
Loading...
+ 11 hidden pages