Jingwah Information Technology M11550 User Manual

Science and

(2) Cet appareil doit accepter toutes les interférences, y compris celles susceptibles de provoquer un fonctionnement indésirable.

FCC Caution:

Any Changes or modifcations not expressly approved by the party responsible for compliance could void the user's authority to operate the equipment.

This device complies with part 15 of the FCC Rules. Operation is subject to the following two conditions: (1) This device may not cause harmful interference, and (2) this device must accept may cause undesired operation.

Note: This equipment has been tested and found to comply with the limits for a Class B digital device, pursuant to part 15 of the FCC Rules. These limits are designed to provide reasonable protection against harmful interference in a residential installation. This equipment generates uses and can radiate radio frequency energy and, if not installed and used in accordance with the instructions, may cause harmful interference to radio communications. However, there is no guarantee that interference will not occur in a particular installation. If this equipment does cause harmful interference to radio or television reception, which can be determined by turning the equipment off and on, the user is encouraged to try to correct the interference by one or more of the following measures:

—Reorient or relocate the receiving antenna. —Increase the separation between the equipment and receiver. —Connect the equipment into an outlet on a circuit different from that to which the receiver is connected. —Consult the dealer or an experienced radio/TV technici

Speciﬁc Absorption Rate (SAR) information

SAR tests are conducted using standard operating positions accepted by the FCC with the device transmitting at its highest certified power level in all tested frequency bands, although the SAR is determined at the highest certified power level, the actual SAR level of the device while operating can be well below the maximum value. Before a new device is a available for sale to the public, it must be tested and certified to the FCC that it does not exceed the exposure limit established by the FCC, tests for each device are performed in positions and locations as required by the FCC. Non-compliance with the above restrictions may result in violation of RF exposure guidelines.

Nonÿcompliance with the above restrictions may result in violation of RF exposure guidelines.

ISEDC Warning

This device contains licence-exempt transmitter(s)/receiver(s) that comply with Innovation, Economic Development Canada’s licence-exempt RSS(s). Operation is subject to the following two conditions: (1) This device may not cause interference, and (2) This device must accept any interference, including interference that may cause

the device.

Cet appareil contient des émetteurs / récepteurs exemptés de licence conformes aux RSS (RSS) d'Innovation,

Sciences et Développement économique Canada. Le fonctionnement est soumis aux deux conditions suivantes: (1) Cet appareil ne doit pas causer d’interférences, et (2) Cet appareil doit accepter toutes les interférences, y compris celles susceptibles de provoquer un

fonctionnement indésirable.

any interference received, including interference that

an for help.

Science and

undesired operation of

7.1.4 Radio Apparatus Containing Digital Circuits (ICES-003)

Radio apparatus containing digital circuitry which can function separately from the operation of a transmitter or an associated transmitter, shall comply with ICES-003. In such cases, the labeling requirements of the applicable RSS apply, rather than the labeling requirements in ICES-003. Waring

：

Class B digital apparatus: This Class B digital apparatus complies with Canadian ICES-003. Cet appareil numérique de la classe B est conforme à la norme NMB-003 du Canada.

5GWIFI 5150-5250MHz shall be indoor use only.

ISEDC SAR Waring :

The device has been tested and compliance with SAR limits, users can obtain Canadian in Le présent appareil est conforme Après examen de ce matériel aux conformité aux limites DAS et/ou aux limites d’intensité de champ RF, les utilisateurs pe uvent sur l’exposition aux radiofréquences et la conformité and compliance d’acquérir les informations correspondantes

SAR tests are conducted using standard operating positions accepted by the ISEDC with the device transmitting at its highest certiﬁed power level in all tested frequency bands, although the SAR is determined at the highest certiﬁed power level, the actual SAR level of the device while operating can be well below the maximum value.

tested and certiﬁed to the ISEDC that it does not exceed the exposure limit established by the ISEDC, tests for each device are performed in positions and locations as required by the ISEDC.

Non‐compliance with the above restrictions may result in violation of RF exposure guidelines.

Les tests SAR sont effectués à l'aide de positions de fonctionnement standard acceptées par l'ISEDC, l'appareil transmettant à son niveau de puissance certiﬁé le plus élevé dans toutes les bandes de fréquences testées, bien que le SAR soit déterminé au niveau de puissance certiﬁé le plus élevé. bien en dessous de la valeur maximale.

Le non‐respect des restrictions ci‐dessus peut entraîner une violation des consignes d'exposition aux RF.

rmation on RF exposure

and compliance