Jiffy J-1, J-2, J-200 User Manual
Jiffy®
J-1/J-2/J-200 Model Steamer
FEATURES
•
Cast
aluminum
• High
impact
• Lightweight, flexible
utilizes a
•
Shatterproof
brass
• Safety wiring feature
accidentally
• Comfortable, easy-to-grip handle
• Removes wrinkles
conventional ironing
• Easy-roll casters for mobility (casters
J-1 series)
• Numerous steam
• 120 Volt
• Backed
or
by
steamer need repair, send it to
the unit within 24 hours from its arrival to our plant
housing for
polymer
hat
nozzle)
water
bottle
housing (Model J-200)
hose-
durability
Models J-2/J-200 (J-1 series
temporarily
runs
dry
up
to five times faster
head
attachments
230 Volt units available
Jiffy®'s renowned
customer
us
and
(Models J-1
turns
the
unit
than
not
included with
available
service--should
we will repair and ship
off
and
if
J-2)
it
your
INCLUDES:
Water
Bottle
Owner's
Rod
(not
included with
J-1
Set
series)
Manual
Assembly~
Wrench
Hat Nozzle
(J-1
Models)
Jiffy®
1.
J-1/J-2/J-200
For J-2/J-200 models, attach hose firmly with included
assembly wrench, which
of
the bottom
hose hanger rod set. See page 9 for assembly instructions.
J-1
For
attached. There
the unit (figure #1). Assemble and attach
models, the brass hat nozzle should already
is
no rod set for
Model
is
magnetized and located on
J-1
Steamer
models.
Directions
be
2. Invert bottle
proper voltage outlet,
and you will have steam within minutes. Never substitute the
Steamer water bottle.
Figure 2
of
fresh tap
or
distilled water,
turn
switch to lighted
3.
For
easy operation, mount optional
or
door
For
Steamboard, simply install
of
steamer's rod set as shown
lightly with steaming head and wrinkles will vanish
instantly. The combined touch
the direct steam is very important. Some articles can be
steamed better from the underneath side. Speed and
efficiency is accomplished with a little practice. Always
steam with hose
condensation is free to flow back into steamer.
steaming
out frequently to keep clear
condensation.
STEAMER
4.
wall to hold clothing while steaming (figure #2).
hanging garments without optional
a doorway
or
in
a low position near floor, extend hose up and
DO
TO
Hang
steam head
position in the hose hanger section
when
not in use and
OFF (figure #3).
plug
into
ON
position
an
eye screw
directly onto a wall
in
figure 3. Touch material
of
in
an upright position, so any
of
NOT
ALLOW
RUN
DRY.
in
an
upright
turn
switch to
Ji~
Ji~
Steamboard to
Ji~
or
or
you
the steaming head and
Figure
nail to inside
may use
If
1
Periodically, pour old water out
5.
steamer to avoid sediment buildup and
maintain proper water level (figure
#4). Remove hard water deposits
Figure 4
NOTE:
begins to cut
heating unit needs the sediment cleaned out.
No
two water supplies have the same mineral content.
on
and
Cleaner. See page 28 for complete cleaning
instructions.
off
during normal use , the thermostat is indicating the
of
with
If
Figure 3
JiffY
® Liquid
your steamer
Loading...