JETWAY G03-NMF93-F User Manual

USER'S MANUAL

Intel Q77 Express Chipset

Based

M/B for LGA 1155 Quad Core Ready

Intel Core Processor

No. G03-NMF93-F

Rev: 1.0

Release date: June 5, 2012

Trademark:

* Specifications and Information contained in this documentation a re furnis hed for i nforma tion use only , a nd are

subject to change at any time without notice, and should not be construed as a commitment by manufacturer.

ENVIRONMENTAL SAFETY INSTRUCTION...........................................................................iii

ENVIRONMENTAL PROTECTION ANNOUCEMENT..............................................................iii

USER’S NOTICE .......................................................................................................................iv

MANUAL REVISION INFORMATION.......................................................................................iv

ITEM CHECKLIST.....................................................................................................................iv

CHAPTER 1 INTRODUCTION OF THE MOTHERBOARD

1-1 SPECIFICATION.........................................................................................................1

1-2 LAYOUT DIAGRAM....................................................................................................2

CHAPTER 2 HARDWARE INSTALLATION

2-1 JUMPER SETTING.....................................................................................................5

2-2 CONNECTORS AND HEADERS................................................................................7

2-2-1 REAR I/O BACK PANEL CONNECTORS....................................................7

2-2-2 MOTHERBOARD INTERNAL CONNECTORS............................................8

2-2-3 HEADER PIN DEFINITION ...........................................................................10

CHAPTER 3 INTRODUCING BIOS

3-1 ENTERNING SETUP...................................................................................................16

3-2 BIOS MENU SCREEN ................................................................................................16

3-3 FUNCTION KEYS .......................................................................................................17

3-4 GETTING HELP ..........................................................................................................17

3-5 MENU BARS...............................................................................................................18

3-6 MAIN MENU................................................................................................................18

3-7 ADVANCED MENU.....................................................................................................19

3-8 CHIPSET MENU..........................................................................................................25

3-9 BOOT MENU...............................................................................................................28

3-10 SECURITY MENU.......................................................................................................29

3-11 SAVE & EXIT MENU...................................................................................................30

TABLE OF CONTENT

iii

Environmental Safety Instruction

z Avoid the dusty, humidity and temperature extremes. Do not place the product in

any area where it may become wet.

z 0 to 40 centigrade is the suitable temperature. (The figure comes from the request

of the main chipset)

z Generally speaking, dramatic changes in temperature may lead to contact

malfunction and crackles due to constant thermal expansion and contraction from the welding spots’ that connect components and PCB. Computer should go through an adaptive phase before it boots when it is moved from a cold environment to a warmer one to avoid condensation phenomenon. These water drops attached on PCB or the surface of the components can bring about phenomena as minor as computer instability resulted from corrosion and oxidation from components and PCB or as major as short circuit that can burn the components. Suggest starting the computer until the temperature goes up.

z The increasing temperature of the capacitor may decrease the life of computer.

Using the close case may decrease the life of other device because the higher temperature in the inner of the case.

z Attention to the heat sink when you over-clocking. The higher temperature may

decrease the life of the device and burned the capacitor.

Environmental Protection Announcement

Do not dispose this electronic device into the trash while discarding. To minimize pollution and ensure environment protection of mother earth, please recycle.

USER’S NOTICE

COPYRIGHT OF THIS MANUAL BELONGS TO THE MANUFACTURER. NO PART OF THIS MANUAL, INCLUDING THE PRODUCTS AND SOFTWARE DESCRIBED IN IT MAY BE REPRODUCED, TRANSMITTED OR TRANSLATED INTO ANY LANGUAGE IN ANY FORM OR BY ANY MEANS WITHOUT WRITTEN PERMISSION OF THE MANUFACTURER.

THIS MANUAL CONTAINS ALL INFORMATION REQUIRED TO USE THIS MOTHER-BOARD SERI ES AND WE DO ASSURE THIS MANUAL MEETS USER’S REQUIREMENT BUT WILL CHANGE, CORRECT ANY TIME WITHOUT NOTICE. MANUFACTURER PROVIDES THIS M ANUAL “AS IS” WITHOUT WARRANTY OF ANY KIND, AND WILL NOT BE LIABLE FOR ANY INDIRECT, SPECIAL, INCIDENTAL OR CONSEQUENTIAL DAMAGES (INCLUDING DAMAGES FOR LOSS OF PROFIT, LOSS OF BUSINESS, LOSS OF USE OF DATA, INTERRUPTION OF BUSINESS AND THE LIKE).

PRODUCTS AND CORPORATE NAMES APPEARING IN THIS MANUAL MAY OR MAY NOT BE REGISTERED TRADEMARKS OR COPYRIGHTS OF THEIR RESPECTIVE COMPANIES, AND THEY ARE USED ONLY FOR IDENTIFICATION OR EXPLANATION AND TO THE OWNER’S BENEFIT, WITHOUT INTENT TO INFRINGE.

Manual Revision Information

Reversion Revision History Date

1.0 First Edition June 5, 2012

Item Checklist

Motherboard

User’s Manual

DVD for motherboard utilities

Cable(s)

I/O Back panel shield

Chapter 1

Introduction of the Motherboard

1-1 Specification

Spec Description

Design

z u-ATX form factor; PCB size: 24.4 x24.4 cm

Chipset

z Intel Q77 Express Chipset

LGA1155 CPU Socket

z Supports 3rd and 2nd Generation Intel® Core™ i7, Core™ i5,

Core™ i3 series processor in LAG1155 Package

* for detailed CPU support information please visit our website

Memory Slot

z DDRIII RAM module slot x 4 z Supporting four DDRIII 1600/1333/1066MHz RAM Module

expandable to 32 GB (Maximum)

z Support dual-channel function

Expansion Slots

z 1 pcs* PCI-Express x16 slot z 1 pcs* PCI-Express x4 slot z 1 pcs* PCI-Express x1 slot z 1 pcs *32-bit PCI slot z 1 pcs* Full-size Mini-PCIE slot/MSATA slot

Storage

z Support two SATAIII ports and four SATAII ports with RAID

0/1/5/10 function

Dual LAN Chip

z Integrated Intel 82574L and 82579LM Gigabit Ethernet LAN chip

that supports Fast Ethernet LAN function of providing 10/100/1000Mbps Ethernet data transfer rate

HD Audio Chip

z Realtek ALC662 6-channel Audio Codec integrated z Audio driver and utility included

BIOS

z 64MB DIP Flash ROM

Multi I/O

z USB 3.0 port connector x2 z HDMI port connector x1 z Serial port connector x2 z DVI-D port connector x1 z VGA port connector x1 z USB 2.0 port connector x4 z RJ-45 port LAN connector x2 z Audio connector x3 (Line-in, Line-out, MIC) z Front panel audio header x1 z HDMI-SPDIF header x1 z PS/2 keyboard & mouse header x1 z Parallel header x1 z TPM 1.2 header x1 z GPIO header x1 z USB 2.0 header x2 (Support 4* additional USB 2.0 ports) z USB 3.0 header x1 (Support 2* additional USB 3.0 ports) z Front panel header x1 z POWER LED header x1 z Speaker header x1 z CIR header x1 z LANLED header x2 z SM_BUS header x1 z TX-RX COM header x 1 z COM port header x 8

1-2 Layout Diagram

Rear IO Diagram

Motherboard Internal Diagram

Note:

1.PE1

slot supports

PCI-Express 2.0 x16

specification when using Intel

Sandy Bridge CPU and supports

PCI-Express 3.0 x1

6 specification when using Intel

Ivy Bridge CPU;

mSATA slot

is selectable with

full size

MINI PCI-E

and share with SATA6;

RJ-45 LAN Ports

DVI-D Port

USB 3.0 Ports

Line-IN/

Optical SPDIF OUT

Line-OUT

MIC-IN

USB 2.0 Ports

Serial Port 1

VGA Port

ATX 12V

Power Connector

ATX Powe

Connector

LGA1155

CPU Socket

HDMI Port

Serial Port 2

Audio Connectors

USB 3.0 Ports

Over HDMI port

Serial Ports

(COM1 over COM2)

DVI –D Port

over VGA Port

RJ-45 LAN Port

Over USB 2.0 Ports

USB 3.0 Header

PCI Express x 16 Slot (PE1) *

PCI Express 2.0 x 4 Slot

PCI Ex

ress 2.0 x1 Slot

32-bit PCI Slot

Front Panel

Audio Heade

Parallel Header

TPM Header

TX-RX COM Header

Intel Q77

Chipset

USB 2.0 Headers

Front Panel Header

DDRIII

DIMM Slot x 4

Full-size Mini-PCIE

/MSATA Slot*

SYS FAN2 Header

GPIO Header

SYS FAN1 Header

KBMS Header

CPUFAN Header

SM_BUS Header

CIR Header

Serial Ports

(COM7/8/9/10)

SATAIII Ports

(SATA1/2)

SATAII Ports

(SATA3/4/5/6)

Serial Ports (COM3/4/5/6)

HDMI S/PDIF Header

LAN1LED Header

LAN2LED Header

WR LED Header

Speaker Header

RJ-45 LAN Port

Over USB 2.0 Ports

Motherboard Jumper Position

Jumper

Jumper Name Description

JBAT CMOS RAM Clear Function Setting 3-pin Block JP1 COM1 Ports Pin9 Function Select 6-pin Block JP2 Mini PCI-E Power VCC3.3V/3.3VSB Select 3-pin Block JP4 COM3 Header Pin9 Function Select 6-pin Block JP12 COM3 Header RS232/485/422 Function Select 6-pin Block JP8 COM4 Header Pin9 Function Select 6-pin Block Case_open Case Open Message Display Function Select 2-pin Block

JBAT

CASE_OPEN

JP4

Connectors

Connector Name

ATXPWR ATX Power Connector ATX12V1 ATX 12V Power Connector USB4 USB 3.0 Connector X2 HDMI High-Definition Multimedia Interface VGA Video Graphic Attach Connector DVI DVI-D Port Connector COM1(Top)/COM2(Bottom) Serial Port COM Connector X2 UL1(Middle & Bottom)/UL2(Middle & Bottom) USB 2.0 Port Connector X4 UL1(Top)/UL2(Top) RJ-45 LAN Connector X2 AUDIO1 Audio Connector X3 SATA1/SATA2 SATAIII Connector X2 SATA3/SATA4/SATA5/SATA6 SATAII Connectors X4

Headers

Header Name Description

FP_AUDIO Front panel audio Header 9-pin block HDMI_SPDIF HDMI_SPDIF Out Header 2-pin Block KBMS PS/2 Keyboard & Mouse Header 6-pin Block SPEAK Speaker Header 4-pin Block PWRLED Power LED 3-pin Block JW_FP (Front Panel Header)

PWR LED/ HDD LED/ /Power Button

/Reset

9-pin Block

CIR CIR Header 7-pin Block USB1 USB 3.0 Header 19-pin Block USB2/USB3 USB 2.0 Header 9-pin Block COM 3/4/5/6/7/8/9/10 Serial Port Header 9-pin Block TX-RXCOM RS 422/485 port header 4-pin block GPIO_CON GPIO Header 10-pin Block TPM TPM Header 19-pin Block PARALLEL Parallel Port Header 25-pin Block LAN1LED/LAN2LED LANLED Header 2-pin Block SM_BUS SMBUS Header 4-pin Block SYSFAN1 SYSFAN1 Header 3-pin Block SYSFAN2/CPUFAN FAN Header 4-pin Block

Chapter 2

Hardware Installation

2-1 Jumper Setting

(1) JBAT (3-pin): Clear CMOS

2-3 Short： Clear CMOS

JBAT

1-2 closed : Normal

;

CMOS Clear Setting

(2) JP1 (6-pin): COM1 Ports Pin9 Function Select

3-4 clos ed : +12V;

JP1

1-2 closed: RS232;

5-6 closed : +5V

(3)JP2 (3-pin): Mini PCI-E Power VCC 3.3V/3.3 VSB Select

2-3 closed: MINI PCI-E VCC= 3.3VSB

JP2

1-2 closed: MINI PCI-E VCC= 3.3V;

(4) JP4 (6-pin): COM3 Port Pin9 Function Select

3-4 clos ed : +12V;

JP4

1-2 closed: RS232;

5-6 closed : +5V

(5) JP12 (6-pin): COM3 Header RS232/485/422 Function Select

3-4 closed : RS485;

JP12

1-2 closed: RS232;

5-6 closed : RS422

(6) JP8 (6-pin): COM4 Port Pin9 Function Select

3-4 closed : +12V;

JP8

1-2 closed: RS232;

5-6 closed : +5V

(7) CASE_ OPEN (2-pin): Case Open Message Display Function Select

Pin 1-2 shorted: Case open display function enabled. Use needs to enter BIOS and enable ‘Case Open Detect’ function. In this case if you case is removed, next time when you restart your computer a message will be displayed onscreen to inform you of this.

2-2 Connectors and Headers 2-2-1 Rear I/O Back Panel Connectors

(1) USB 3.0 Port Connector: USB4

These USB 3.0 connectors are for user to connect USB 3.0 compatible devices to the system board.

(2) D-Sub 15-pin Connector: VGA

VGA connector is the 15-pin D-subminiature female connector; it is for the display devices, such as the CRT monitor, LCD monitor and so on.

(3) Digital Visual Interface: DVI

This interface standard designed to maximize the visual quality of digital display devices such as flat panel LCD computer displays and digital projectors.

(4) High-Definition Multimedia Interface: HDMI

This point-to-point interface is for audio and video signals designed as a single-cable solution for home theater and consumer electronics equipment.

NOTE! DVI and HDMI Connector can not be used at the same time.

RJ-45 LAN Ports

USB 3.0 Ports

Line-IN/

Optical SPDIF OUT

Line-OUT

MIC-IN

USB 2.0 Ports

Serial Port 1

VGA Port

DVI-D Port

HDMI Port

Serial Port 2

+ 23 hidden pages

JETWAY G03-NMF93-F User Manual

Specifications and Main Features

Frequently Asked Questions

User Manual