Page 1
F 1 8 F18 DP
Page 2
F-18 / F
-
18DP INSTALLATION
This dishwasher must be installed on a level, rigid, nonflammable surface. Ensure that the machine is level by installing
the feet (shipped in the wash tank of the machine) and adjusting the leveling. Be sure to provide adequate space for water,
drain and electrical connections.
WATER SUPPLY
A 1/2" -140°F (60°C) hot water line with 30 PSI flow pressure and shut-off valve is required. A pressure reducing valve*
may be required. A 1/2" flexible supply hose* is recommended from the shut-off valve to the water fill valve on the
dishwasher to facilitate maintenance and servicing of the machine. A 90° elbow adapter for the water inlet valve is
furnished with the machine and can be found in the wash tank with the adjustable feet. The re should be sufficient hose
length to permit the machine to be pulled out for service.
DRAIN
• F-18: This dishwasher has a gravity drain. Maximum height of the floor drain should not exceed 6" (15cm). A 1.5" ED
flexible drain hose* is recommended to facilitate maintenance and servicing of the machine.
•F-18 DP: This dishwasher is equipped with an automatic drain pump that will pump the drain water to a maximum height
of 36" (0.9 meter). A 1" ED flexible drain hose* is recommended to facilitate maintenance and servicing of the machine. It
is important not to reduce the size of this hose. A 1" check-valve* is required on drain pump equipped models. Drain
pump equipped machines have a white button on the control panel beside the green power button.
DRAIN PUMP MODELS ARE FACTORY BUILT. GRAVITY DRAIN UNITS CANNOT BE CONVERTED
TO PUMPED DRAIN UNITS. There should be sufficient hose length to permit the machine to be pulled out for
service.
ELECTRICAL
A 208-240 volt, 60 Hz, Single Phase circuit is
required for this unit. Check the rating plate on the
machine for amp draw. In spite of the fact that the
rating plate shows 208 volts, the unit is designed
function properly on 208 volts to 240 volts. The top
& back panels must be removed for the electrical
hook-up. The terminal block is located inside the
back cover. Pass the cable through the cable strain
relief and connect the wires to the terminals LI
(brown wire), L2 (blue wire) & Ground (yellow &
green wire). Replace the top & back panels being
careful not to pinch or kink any wires or hoses.
There should be sufficient cable length to permit the
machine to be pulled out for service. DO NOT
TURN ON THE POWER TO THE MACHINE
UNTIL THE WATER SUPPLY & DRAIN LINES
HAVE BEEN CONNECTED.
IMPORTANT NOTE
Reasonable access to and around the machine for service must be provided. Disconnecting of hard plumbing or removal of counter tops or cabinets, etc.. for servicing is not
covered by warranty.
* - not supplied
Page 3
F-18 ELECTRICAL DIAGRAM
Page 4
F-18DP ELECTRICAL DIAGRAM
Page 5
F-18DP EXPLODED VIEW
JET-TECH F 18DP
Page 6
F-18DP EXPLODED VIEW
JET
-
TECH F
18DP
Page 7
F-18 / F-18DP PARTS LIST
10298 PUMP FILTER 12050 DOOR CATCH
10342 CONNECTOR DIAMETER 6,5 12051 SCREW
10347 CONNECTOR 12052 SPRING
10349 CONNECTOR 12054 DOOR CATCH BODY
10350 CONNECTOR 12055 SCREW
10351 CONNECTOR 12057 HANDLE SOCKET
10368 RINSE AID CONTAINER 12060 MOTOR MOUNT
10409 ROD 12072 NUT
10415 NUT FOR DOOR SWITCH 12073 PLUG
10421 LEFT HINGE 12076 MANIFOLD
10425 NUT 12077 HANDLE SOCKET
10431 NUT 12084 WASH/RINSE ARM
10433 NUT 12129 DISK
10435 NUT 12130 BRACKET
10446 RINSE AID FILTER 12131 RUBBER-CARRIER
10458 NUT 12194 SQUARE
10469 SPRING 12425 F 18 (98) JET-TECH DECAL
10470 SPRING 12426 F 18DP (98) JET-TECH DECAL
10471 SPRING 15006 PIVOT
10472 SPRING 15016 PIVOT SUPPORT CF 50
10473 SPRING 15017 OVERFLOW PIPE
10475 SPRING 15019 KIT SUPPORT + EXTENSION
10479 BUFFER 15021 TENSION ROD DOOR
10484 FAIR LEAD 15022 GUIDE TENSION ROD DOOR
10489 PIVOT 15023 BLOCK TENSION ROD DOOR
10493 PIVOT 15030 KIT SUPERIOR SUPPORT ARM
10502 ADJUSTABLE FOOT 15545 TUBE
10523 HANDLE SOCKET 15546 TUBE
10528 AIR TRAP 15547 SPACER FOR PIVOT
10529 TUBE 15576 SQUARE
10545 TUBE 15585 BOOSTER TANK
10556 FAIR LEAD 15632 TUBE
10565 HANDLE SOCKET 15633 TUBE DP
10569 DISK 15634 TUBE DP
10576 NUT + RUBBER -- CARRIER SOLENOID V. 15705 SQUARE MICROSWITCH
10591 WASHER 15706 SQUARE RIGHT GUIDE
10598 RIGHT HINGE 15707 SQUARE LEFT GUIDE
10609 SPACER 15735 ELEMENT COVER
11351 BUSHING 15767 CONTROL PANEL
11902 FILTER 15768 CONTROL PANEL DP
11998 NUT 15900 WASH TANK
12007 SUPPORT 15901 DOOR
12008 SUPPORT 15902 BASE
12009 HUB 15903 HANDLE
12010 PLUG 15905 RIGHT LAT. PANEL
12011 RIGHT RINSE ARM 15906 LEFT LAT. PANEL
12012 SUPERIOR RINSE ARM 15907 BACK PANEL
12013 PLUG 15908 TOP
12014 RINSE JET 15909 RIGHT BASKET GUIDE
12015 RINSE JET INSERT 15910 LEFT BASKET GUIDE
12016 WASH ARM 15966 KICK PANEL
12017 PIVOT 15967 PLATE FOR TERMINAL FV 110 - FV 77
12019 PLATE 20010 LENS
12020 NUT 20017 FIXING CABLE
12021 CONNECTOR 20018 FILTER
12048 PIVOT 20025 TIMER BRACKET
12049 DOOR HOOK 20035 DOOR MICROSWITCH
Page 8
F-18 / F-18DP PARTS LIST
20042 LIGHT 60119 SCREW
20044 POWER SWITCH 60130 SCREW
20058 PRESSURE SWITCH 60132 SCREW
20067 RELAY 12A 230V 60135 SCREW
20080 BOOSTER ELEMENT 400V 6000W 60137 SCREW
20088 TANK ELEMENT 230V 2800W 60139 SCREW
20105 CONTACTOR 220/240V 50/60Hz 60160 SCREW
20108 THERMOMETER DOUBLE SCALE 60161 SCREW
20119 RINSE THERMOSTAT 60162 SCREW
20132 TERMINAL 60164 SCREW
20133 PLATE 249 -- 116 60166 SCREW
20134 TERMINAL 281 - 313 60191 SCREW
20135 STAPLE 60200 NUT
20199 RINSE AID PUMP 60201 NUT
20500 POWER SWITCH DP 60202 NUT
20518 TIMER 3'22" 60HZ 60203 NUT
20519 CYCLE START BUTTON 60204 NUT
20532 TERMINAL BLOCK CF 50 400V 60205 NUT
20548 DOOR MICROSWITCH UL F 18 60208 NUT
20567 CAPACITOR 16MF 240 UL 60210 NUT
20569 SOLENOID VALVE 1A 240V 60Hz UL 60212 NUT
20570 WASH THERMOSTAT 60215 NUT
20582 TERMINAL FV 110 60231 WASHER
21343 WIRING HARNESS F 18 JET-TECH 60232 WASHER
21345 WIRING HARNESS F 18DP JET-TECH 60233 WASHER
30049 PEG RACK 20" X 20" 60234 WASHER
30105 OPEN RACK 20" X 20" 60235 WASHER
40229 DRAIN PUMP 60HZ 60238 WASHER
40240 MOTOR PUMP 220V 60Hz 0.75HP 60242 WASHER
60003 GASKET 60243 WASHER
60004 GASKET 15x10x2 60244 WASHER
60008 GASKET 60245 WASHER
60009 GASKET 60258 BALL
60010 0 RING 60555 HOSE
60012 GASKET 60563 HOSE
60017 GASKET 60565 HOSE
60018 GASKET
60050 0 RING
60055 0 RING
60060 0 RING
60061 0 RING
60071 0 RING
60072 0 RING
60073 0 RING
60074 0 RING
60076 0 RING
60078 CLAMP
60079 CLAMP
60081 CLIP
60083 CLIP
60084 CLIP
60089 CLIP
60102 SCREW
60103 SCREW
60107 SCREW
60109 SCREW
60115 SCREW 4MAX30
Loading...