JETOP ICB284 User Manual
Bluetooth Speaker with Clock
User’s Guide for Model ICB284S v982-01
FCC Caution
This device complies with part 15 of the FCC Rules. Operation is subject to the following two
conditions: (1) This device may not cause harmful interference, and (2) this device must accept
any interference received, including interference that may cause undesired operation.
Any Changes or modications not expressly approved by the party responsible for
compliance could void the user’s authority to operate the equipment.
Note: This equipment has been tested and found to comply with the limits for a Class B
digital device, pursuant to part 15 of the FCC Rules. These limits are designed to provide
reasonable protection against harmful interference in a residential installation. This
equipment generates uses and can radiate radio frequency energy and, if not installed
and used in accordance with the instructions, may cause harmful interference to radio
communications. However, there is no guarantee that interference will not occur in a
particular installation.
If this equipment does cause harmful interference to radio or television reception, which can
be determined by turning the equipment off and on, the user is encouraged to try to correct
the interference by one or more of the following measures:
• Reorient or relocate the receiving antenna.
• Increase the separation between the equipment and receiver.
• Connect the equipment into an outlet on a circuit different from that to which the
receiver is connected.
• Consult the dealer or an experienced radio/TV technician for help.
FUNCTIONS AND CONTROLS
to cycle through preset radio stations. In o mode, press and
hold to adjust the clock. While paired to a Bluetooth device,
Source
Press to switch
between Radio,
Line In, and
Bluetooth
press to play or pause media from the speaker.
RF Warnings
The device has been evaluated to meet general RF exposure requirement. The device can be
used in portable exposure condition without restriction.
Additional Warnings
• The apparatus shall not be exposed to dripping or splashing and that no objects lled
with liquids, such as vases, shall be placed on apparatus.
• Do not place the unit on top of any soft, porous, or sensitive surfaces to avoid
damaging the surface. Use a protective barrier between the unit and surface to
protect the surface.
• Keep new and used batteries away from children. If the battery compartment does
not close securely, stop using the product and keep it away from children.
• If you think batteries might have been swallowed or placed inside any part of the
body, seek immediate medical attention.
• Do not mix old and new batteries.
• Do not mix alkaline, standard (carbon-zinc), or rechargeable
(ni-cad, ni-mh, etc) batteries.
• Batteries should be recycled or disposed of as per state and local guidelines.
With the Radio on, press it and TUN +/-
Mem/Clock
Power
Press to power the
radio on or o.
TUN +/-
Press to tune the radio, or set
the time for the clock/alarm.
Indicator Lights
Bluetooth
Alarm 2
Alarm 1
PM
LED Display
Press to snooze the alarm after it sounds.
Press and hold to dim the brightness of the LED display.
Snooze/Dimmer
Press to set the Sleep Timer.
Removable
Back Stand
Pair
Press to pair
Bluetooth devices
to the unit.
Volume +/- /AL1/AL2
Press to adjust the volume, or
to set Alarm 1 or Alarm 2.
Speaker
Battery Backup
The battery backup is intended for short power outages only. The clock radio’s primary functions
cannot run o of the battery backup alone. Requires 2, AAA-size, batteries (not included).
Bottom View
AAA
AAA
Power
Plug the AC/DC power adapter (included) into the DC Power Input on the unit, and a standard power
outlet. The unit can be used to charge mobile devices through a USB charging port in the rear, as seen
on the below (USB cable not included).
Line In
USB
Charging Port
DC Power Input
Rear View
Loading...