JESMAY ELECTRONICS CO., LTD
ROOM 1004, STANHOPE HOUSE,
738 KING’S ROAD,
QUARRY BAY, HONG KONG
TEL: (852) 2563 4292, 2562 6212
FAX: (852) 2565 7026, 2516 9417
E-mail: info@jesmay.com.hk
Web Site: http://www.jesmay.com.hk
433MHz Wireless Remote Rotating Pannier
OWNER’S MANUAL
(
PLEASE READ BEFORE USE )
JESMAY ELECTRONICS CO., LTD
0
336
!
¦ Important-Safety Precautions
• To prevent fire or shock hazard, do not expose this product
to rain or moisture. Do not use near a bathtub, wash bowl,
kitchen sink, or laundry tub, in a wet basement, or near a
swimming pool.
• To avoid electrical shock, do not open this product.
• This product should be operated to use the power supply
must have the same voltage as the local area.
• Do not overload wall outlets and extension cords as this
can result in the risk of fire or electrical shock.
• Refer servicing to qualified personnel only.
Caution: Changes or modifications not expressly
approved by the Party responsible for compliance could
avoid the user’s authority to operate the equipment.
¦ Note:
This equipment is designed to provide reasonable protection
against harmful interference in a residential installation. This
equipment generates, uses and can radiate radio frequency
energy, if not installed and used in accordance with the
instruction, it may cause harmful interference to radio
communications. However, there is no guarantee that
interference will not occur in a particular installation. If this
equipment does cause harmful interference to radio or
television reception, which can be determined by turning the
equipment off and on, the user is encouraged to try to
correct the interference by one or more of the following
measures:
• Reorient or relocate the receiving antenna.
• Increase the separation between the equipment and
receiver.
1
• Connect the equipment into an outlet on a circuit different
from that to which the receiver is connected.
• Consult the dealer or an experienced radio technician for
help.
¦ GENERAL:
Thanks for purchasing this 433MHz wireless Remote
Rotating Pannier, which cooperates with 2.4GHz Wireless
Monitoring products. Using SAW resonator results in a more
stabilized frequency than LC resonator; Signals are received
by advanced microstrip line and ASK with low power
consume, better in anti-jamming and more sensitive than
super-regeneration receiver; Compile large number of codes
in three status and ten bits of tri-state address(or310),
drastically reducing any code collision ; Monitoring transmitter
is economically powered by DC output with no additional
AC/DC adaptor; Shaped in figure of MUSE(a goddess in
ancient Greek), this product provides an omni-direction safety
for you and your residential area.
¦ Features:
l Work with Wireless Monitoring product indoor.
l Two types of rotating: automatism and remote control.
l Synchronously motor driven by ASK receiving decode
and power by AC15V.
l Two buttons for power on/off and clockwise/contra
rotation.
l Red LED indicating effective pressing
l 59049 sets of security code.
l AC15V power supply, security circuit insuring safety.
l Omni-direction rotation(370° rotating range).
l Remote distance: up the 50m(at open site).
l Easy for installation
2
A. Checking Contents of Box
Check to ensure all of the components shown as below are included
with your wireless IR remote control extender system. If something
is missing, please contact your dealer as soon as possible.
1.RemoteTransmitter × 1
(Model: 4642T)
2.Rotating Pannier × 1
(Model: 4642R)
3.Power adapter (optional) × 1
? (230VAC50Hz to15VAC400mA) or
? (120VAC60Hz to 15VAC400mA)
4.Nylon gel × 3
Bolt × 3
5.Mounting bracket × 1
6.Owner’s manual × 1
3
The following illustrations show the names of each
component on the Remote Transmitter and Rotating Pannier.
4642Rx(PANNIER)
4642Tx(REMOTE)
4
B. Panel Controls and Features of Universal Type
Rotating Pannier
Ant.
AC15V Plug to Adaptor
DC12V Plug to Monitor Transmitter
Adjust Bolt
Clockwise/contra Rotation Button
On/Off Button
Remote Transmission
Embed Battery
Ant.
LED Window
C. the Using Attention
1. Not power or remote the facility in fulminous area.
2. Away from strong sunlight or sunshine to prevent poweroff from increased temperature. of inner mechanical.
3. Insure sufficient power supply from local electric system.
4. In some situation, there are two or more equipment is
used within 50 meter at the same time, perhaps the
equipment may not work well.
5. Transmitter using SAW in UHF, cannot be slapped or
plunged heavily, otherwise resonator would stop working.
6. Take care of your transmitter, keep it out the reach of
kids, who may break antenna or get hurt unexpectedly.
7. Only for Transmitter show use, the red LED window
shouldn’t be pressed heavily.
8. Rotating Pannier can be rotated only after the power
button switched on for normal power supply in any case.
9. Replace with specified battery when remote distance
become nearer.
10. Don’t let the antenna of rotating Pannier circle around
power cord, let it stretch away from that.
11. Tied the power cord of 2.4GHz wireless monitoring
transmission to the installing rack for easy rotation.
12. Battery will be saved if you press on button for about
continuous 2 seconds.
5
4642Rx(PANNIER)
4642Tx(REMOTE)
Application and Installation Type :
1) Work with 2.4GHz wireless surveillance system.(for
example:2176T ect.
2) Work with 2.4GHz wireless surveillance with video
security-code encryption system. (for example: 2276ST
ect .
6
Ñ
Ñ
Need 1M at least
D. How to Use the 433MHz Wireless Remote Rotating Pannier
1. This Rotating Pannier can be either ceiling mounted or
standing fixed on a platform. After plug to the power,
switch left button on and Pannier start rotating with red
LED lights on.
2. After turning on left button, the pannier will rotate
clockwise/contra automatically.
3. Pressing right button at any time can change the rotating
direction.
4. If you want to turn on/off the rotating pannier, please
press on the left button.
5. To make the remote transmitter face to the antenna of
Rotating Pannier, and the remote distance should be in
the Specifications range.
6. Two types of installation: fixed on the horizontal plane put
or on the ceiling upside-down.
7. The power cable connecting with DC12V monitoring
transmission must be preserved 25CM at least.
8. Firstly, punch the Nylon gel into the place you want to
install, then screw the bolts with pedestal on it.
7
¾
How to Installation:
1)Take out pannier 2)Adjust
bolt
3) Take out
bracket
4) Installation bracket 5)Screw 6)Adjust angle
7) Fixed DC Cable 8)Screw Bolt 9) Screw Ceiling
8
2176T
2276ST
About 20cm
About 25cm
About 25cm
About 20cm
Ceiling
E. Troubleshooting, Care and Maintenance
Please read this owner's manual carefully and follow the
steps described in it. If you still have difficulties, consult the
following table. It will guide you though the most common
problems and their solutions.
Problem Possible solution
Remote control
dose not work
1. Code of 4642T/R Partnership right?
2. Battery of 4642T enough?
3. If antenna is pulled out or if LED lights
4. Make sure that the receiving antenna not
circle around power cord.
5. If powered by nominal AC15V.
6. Adjust the length of DC12V power cord
7. Pull out AC15V power reinsert plug
Note: Clean the outside plastic packaging with a soft cloth
lightly moistened with mild soap and water. Never use
any abrasive scouring powder or solvent.
9
F. Specifications
Remote Transmitter: 4642T
RF Output Power 3dBm± 3dBm
RF Transmitter Frequency 433.92MHz
Battery 12VDC(GP23A 1PCS)
Transmitter Current 40mA
Maintain Current 40nA
Dimension 95mm× 48mm× 28mm
Weight 40g
Rotating Pannier: 4642R
RF Receiver Sensible -80dBm(excel)
RF Receiver frequency 433.92MHz
Auto/Remote scanning angle 370
o
Manual Adjust angle 75o Max
Speed of Scanning 50 seconds /change
Max load 650g
Noise (away 30cm unload) Less Than 40db
Power Supply 15VAC 400mA
Output Power 12VDC 200mA
Dimension 100mm× 100mm× 100mm
Weight 320 g
System: 4642T and 4642R
Operation temperature range 0? ~50?
Remote control range Up to 50meter (line of sight)
•All specification subject to change without notice
10
Loading...