How it Works
Jenn-Air
Loading...
JMC2130WB01
Installation Guide
16 pgs1.04 Mb0
Owner’s Manual
64 pgs8.64 Mb0

Jenn-Air JMC2127WB01, JMC2127WS01, JMC2127WS02, JMC2130WB01, JMC2130WS01 Installation Guide

...
INSTALLATIONINSTRUCTIONS
27" (68.6 CM) AND 30" (76.2 CM) ELECTRICBUILT-IN
MICROWAVE OVEN
. INSTRUCTIONSD'INSTALLATION
FOURA MICRO-ONDES ENCASTREELECTRIQUE
DE27" (68,6 CM) ET30" (76,2 CM)
Table of Contents/Table des mati_res
BUILT-IN MICROWAVE OVEN SAFETY ....................................... 2
INSTALLATION REQUIREMENTS ................................................ 3
INSTALLATION INSTRUCTIONS .................................................. 5
SECURITE DU FOUR .&,MICRO-ONDES ENCASTRE ................ 8
EXIGENCES D'INSTALLATION ..................................................... 9
Specifications electriques .......................................................... 11
INSTRUCTIONS D'INSTALLATION ............................................. 11
Preparation du four a micro-ondes encastre ............................. 11
Installation du four a micro-ondes ............................................. 12
Achever I'installation .................................................................. 13
Models/ModUles JMC2130, JMC2127
W10284419B
BUILT-INMICROWAVE OVEN SAFETY
Your safety and the safety of others are very important.
We have provided many important safety messages in this manual and on your appliance. Always read and obey all safety
messages.
This is the safety alert symbol. This symbol alerts you to potential hazards that can kill or hurt you and others.
All safety messages will follow the safety alert symbol and either the word "DANGER" or "WARNING."
These words mean:
You can be killed or seriously injured if you don't immediately
follow instructions.
You can be killed or seriously injured if you don't follow instructions.
All safety messages will tell you what the potential hazard is, tell you how to reduce the chance of injury, and tell you what can happen if the instructions are not followed.
2
INSTALLATIONREQUIREMENTS
s :xnd
Gather the required tools and parts before starting installation. Read and follow the instructions provided with any tools listed
here.
Tools needed
• Phillips screwdriver •
• Flat-blade screwdriver •
• Measuring tape
• Level
Parts needed
• A UL listed or CSA approved conduit connector
• UL listed wire connectors
Parts supplied
• 6 screws
Check local codes. Check existing electrical supply. See "Electrical Requirements."
IMPORTANT: Observe all governing codes and ordinances.
• Cabinet opening dimensions that are shown must be used. Given dimensions provide minimum clearance with
microwave oven.
• Recessed installation area must provide complete enclosure around the recessed portion of the microwave oven.
• Grounded 3 prong outlet inside upper cabinet.
• Microwave oven support surface must be solid, level and flush with bottom of cabinet cutout. Floor must be able to
support a weight of 90 Ibs (41.0 kg).
IMPORTANT: To avoid damage to your cabinets, check with your builder or cabinet supplier to make sure that the materials used will not discolor, delaminate or sustain other damage. This oven has been designed in accordance with the requirements of UL and CSA International and complies with the maximum allowable wood cabinet temperatures of 194°F (90°C).
Drill (for wall cabinet installations) 1/8"(0.32 cm) drill bit (for wall
cabinet installations)
Product Dimensions
27" (68.6 cm) and 30" (76.2 cm) Microwave Ovens
E
27" (68.6 cm) models A. 25¼" (64.1 cm) recessed width
B. 19%" (48.6 cm) overafl height
C. 263/4'' (67.9 cm) overall width D. 227/16'' (57.0 cm) overafl depth
E. 16%" (42.5 cm) recessed height
30" (76.2 cm) models A. 28¼" (71.7 cm) recessed width
B. 19%" (48.6 cm) overafl height C. 293/4'' (75.6 cm) overall width
D. 227/16''(57.0 cm) overall depth
E. 16%" (42.5 cm) recessed height
Cabinet Dimensions
27" (68.6 cm) and 30" (76.2 cm) Microwave Ovens
A
1 (
E
B
C
27" (68.6 cm) models
A. 27" (68.6 cm) min. cabinet
width
B. 19¼" (48.9 cm) from bottom of
cutout to bottom of upper cabinet door
C. 40" (101.6 cm) bottom of
cutout to floor (recommended) D. 251/_"(64.8 cm) cutout width E. 11/_'' (3.8 cm) min. bottom of
cutout to top of cabinet door
F. 18¼" (46.4 cm) recommended
cutout height (will fit cutout
height from 17" [43.2 cm] to
18_" [46.4 cm])
G. 217/8''(55.5 cm) min. cutout
depth
30" (76.2 cm) models
A. 8G' (76.2 cm) min. cabinet
width
B. 19¼" (48.9 cm) from bottom of
cutout to bottom of upper cabinet door
C. 4G' (101.6 cm) bottom of
cutout to floor (recommended) D. 281/2"(72.4 cm) cutout width E. 11/_'' (3.8 cm) min. bottom of
cutout to top of cabinet door
F. 18¼" (46.4 cm) recommended
cutout height (will fit cutout
height from 17" [43.2 cm] to
18¼" [46.4 cm])
G. 21%" (55.5 cm) min. cutout
depth
NOTE: A microwave oven spacer kit is available from your dealer that will
allow the microwave oven to be installed in an 181¼'' (46.4 cm) to 197/le'' (49.4 cm) maximum cutout height. Match the color and size to the following kits:
Microwave Oven Spacer Kit 27" (68.6 cm) Black - Model JMCSK27WB 27" (68.6 cm) Stainless Steel - Model JMCSK27WS 30" (76.2 cm) Black - Model JMCSK30WB 30" (76.2 cm) Stainless Steel - Model JMCSK30WS To order, see the "Assistance or Service" section of the Use and
Care Guide.
Minimum Installation Clearances
For proper installation the following minimum clearances must exist above and below the cabinet opening.
Installation Above Single Built-In Oven
E ¸ _ _I_,_,_ / i'¸ _'
Electrical Shock Hazard
Plug into a grounded 3 prong outlet. Do not remove ground prong.
Do not use an adapter. Do not use an extension cord.
Failure to follow these instructions can result in death,
fire, or electrical shock.
A......... Ol O
1"
2.5 cm)
1 "
2.5 cm)
S .......
A. Upper cabinet
B.Lower single oven*
*Approved models: JJW3430, JJW2430, JJW2427, JJW2330,
JJW2327
GROUNDING iNSTRUCTiONS
[] For all cord connected appliances:
The microwave oven must be grounded. In the event of an electrical short circuit, grounding reduces the risk of
electric shock by providing an escape wire for the electric current. The microwave oven is equipped with a cord
having a grounding wire with a grounding plug. The plug must be plugged into an outlet that is properly installed
and grounded.
WARNING: Improper use of the grounding plug can
result in a risk of electric shock. Consult a qualified electrician or serviceman if the grounding instructions are
not completely understood, or if doubt exists as to whether the microwave oven is properly grounded.
Do not use an extension cord. If the power supply cord is too short, have a qualified electrician or serviceman install
an outlet near the microwave oven.
SAVE THESE iNSTRUCTiONS
Electrical Connection
Microwave oven must be connected to the proper electrical voltage and frequency as specified on the model/serial number
rating plate. The model/serial number rating plate is located on the left-hand side trim.
A
A. Model/serial number plate
Observe all governing codes and ordinances. Required:
A 120 Volt, 60 Hz, AC only, 15- or 20-amp electrical supply with a fuse or circuit breaker.
Recommended: A time-delay fuse or time-delay circuit breaker.
A separate circuit serving only this microwave oven.
INSTALLATIONINSTRUCTIONS
Excessive Weight Hazard
Use two or more people to move and install microwave oven.
Failure to do so can result in back or other injury.
1. To avoid floor damage, set the microwave oven onto cardboard prior to installation. Do not use handle or any portion of the front frame for lifting.
2. Remove the shipping materials and tape from the microwave oven.
3. Remove and set aside racks and other items from inside the microwave oven.
4. Remove the hardware package from inside the bag containing literature.
5. Move the microwave oven and cardboard close to the microwave oven's final location.
n Mc n
1=
Center bottom trim over the lower edge of the cabinet cutout. Using an 1/8"(0.32 cm) drill bit, predrill pilot holes through the bottom trim.
NOTE: If a spacer kit has been installed, do not install the bottom trim.
2=
Fasten the bottom trim using 2 screws provided. Do not overtighten the screws.
_. J -J- ....
Electrical Shock Hazard
Plug into a grounded 3 prong outlet.
Do not remove ground prong. Do not use an adapter.
Do not use an extension cord. Failure to follow these instructions can result in death,
fire, or electrical shock.
3. With the microwave oven near the opening, plug the microwave oven into the grounded 3 prong outlet.
NOTE: The display will light briefly, and the Welcome Guide should appear in the display. See "Welcome Guide" section
of the Use and Care Guide for more detailed information. If the display does not light, please reference the "Assistance or
Service" section of the Use and Care Guide or contact the dealer from whom you purchased your microwave oven.
4. Using 2 or more people, lift microwave oven partially into cabinet cutout. If a spacer kit has been installed, lift the
microwave oven over it. NOTE: Open microwave oven door and push against seal
area of microwave oven front frame when pushing microwave oven into cabinet. Do not push against outside edges.
5. Push against the front frame of the microwave oven to push oven into cabinet. Push microwave oven completely into
cabinet and center in cabinet cutout.
A. Two screws
Loading...
+ 11 hidden pages
Buy Points How it Works FAQ Contact Us Questions and Suggestions Privacy Policy Cookie Policy Terms of Use