Jenn-Air JJW6024HM Installation Manual
INSTALLATION INSTRUCTIONS
SMALL STEAM AND BUILT-IN OVEN
INSTRUCTIONS D’INSTALLATION POUR PETIT
FOUR ENCASTRÉ AVEC INJECTION DE VAPEUR
Table of Contents / Table des matières
BUILT-IN OVEN SAFETY ................................................................1
INSTALLATION REQUIREMENTS .................................................2
Tools and Parts .............................................................................2
Location Requirements ................................................................2
Product Dimensions .....................................................................2
Minimum Dimensions...................................................................3
Electrical Requirements ...............................................................5
INSTALLATION INSTRUCTIONS ...................................................6
Install Oven ...................................................................................6
Complete Installation ...................................................................6
BUILT-IN OVEN SAFETY
SÉCURITÉ DU FOUR ENCASTRÉ ................................................7
EXIGENCES D’INSTALLATION .....................................................8
Outils et pièces .............................................................................8
Exigences d’emplacement ...........................................................8
Dimensions du produit .................................................................8
Dimensions minimales .................................................................9
Spécications électriques ..........................................................11
INSTRUCTIONS D’INSTALLATION .............................................12
Installation du four ......................................................................12
Terminer l’installation .................................................................. 12
IMPORTANT:
Save for local electrical inspector’s use.
IMPORTANT :
Conserver ces instructions à l’usage de l’inspecteur des installations électriques local.
W11260095A
INSTALLATION REQUIREMENTS
(83.8 cm)
AB
CD
Tools and Parts
Tools needed
Gather the required tools and parts before starting installation.
Read and follow the instructions provided with any tools listed
here.
■ Measuring tape
■ Pencil
®
■ PZ2
■ Electric drill
■ 5/64" (2 mm) drill bit
Pozidriv®✝ screwdriver
Parts Supplied
■ TKX 4x12 PZ2
■ Bottom trim
■ 4x25 PZ2
®
screws (2 for bottom trim)
®
screws (4 for oven installation)
Location Requirements
IMPORTANT: Observe all governing codes and ordinances.
■ Cabinet opening dimensions that are shown must be used.
Given dimensions provide minimum clearance with oven.
■ Recessed installation area must provide complete enclosure
around the recessed portion of the oven.
■ Grounded electrical supply is required. See “Electrical
Requirements” section.
■ Oven support surface must be solid, level and ush with
bottom of cabinet cutout. Floor must be able to support an
oven weight of 111 lbs (50 kg).
IMPORTANT: To avoid damage to your cabinets, check
with your builder or cabinet supplier to make sure that the
materials used will not discolor, delaminate or sustain other
damage. This oven has been designed in accordance with
the requirements of UL and CSA International and complies
with the maximum allowable wood cabinet temperature of
194°F (90°C).
Undercounter Installation (with cooktop installed above):
Ovens approved for this type of installation have an approval
label located on the top of the oven. Refer to undercounter
installation instructions for cutout dimensions and approved
oven cooktop combinations (separate sheet).
Top View
20³/₈"
(51.7 cm)
Product Dimensions
H
G
A. 237/16" (59.5 cm)
B. 185/16" (46.5 cm)
C. 14" (35.6 cm)
D. 131/8" (33.3 cm)
E. 13/16" (2 cm)
F. 3/8" (1 cm)
G. 203/8" (56.9 cm)
H. 2115/16" (55.7 cm)
E
BC
D
F
A
26¹/₄"
(51.7 cm)
19⁵/₈"
I
(49.7 cm)
✝PZ2 and POZIDRIV are registered trademarks of Phillips Screw Company.
2
33"
A. Oven
B. Non-ush receptacle
C. Flush receptacle
D. Non-ush receptacle located in
upper right or upper left corner
E. Oven door fully open
Minimum Dimensions
Cabinet Dimensions - Traditional Install
For proper installation, the following minimum clearances must exist above and below the cutout opening.
Installed in Cabinet
Front View Rear View
A
D
B
C*
E
g
g
Installed under Counter
(Without cooktop installed above)
A
f
B
C*
A. 235/8" minimum (60 cm) width of cabinet
B. 2115/16" (55.8 cm) width of cutout
C. 173/4" (45 cm) recommended height of cutout*
D. 1/2" (1.2 cm) top of cutout to underside of countertop
E. 1/2" (1.2 cm) bottom of cutout to oor
f. Recommended junction box location
*Will t cutout height from 175⁄8" (44.7 cm) to 1715⁄16" (45.6 cm).
F
D
f
E
A. 235/8" (60 cm) minimum width of cabinet
B. 2115/16" (55.8 cm) width of cutout
C. 173/4" (45 cm) recommended height of cutout*
D. 1/2" (1.2 cm) minimum top of cutout to bottom
of upper cabinet door
E. 1/2" (1.2 cm) minimum bottom of cutout to top
of lower cabinet door
F. 199/16" (49.7 cm) minimum depth of cutout
g. Recommended junction box location
*Will t cutout height from 175⁄8" (44.7 cm) to 1715⁄16" (45.6 cm).
3
Cabinet Dimensions - Flush Installation
ee
Installed in Cabinet
5/16" (0.8 cm)
Top Cleat*
A
B
C D
3/4" x 1" (1.9 x 2.5 cm)
width x min. thickness
Side Cleat*
3" x 1/2" (7.6 cm X 1.3 cm)
height X width
Spacer (entire depth
of cutout)
ee
Installed under Counter
(Without cooktop installed above)
5/16" (0.8 cm)
Top Cleat*
A
B
C
3/4" x 1" (1.9 x 2.5 cm)
width x min. thickness
Side Cleat*
3" x 1/2" (7.6 x 1.3 cm)
width x height
Spacer
(entire depth of cutout)
A. 2311/16" (60.2 cm) width of ush inset cutout (min.)
B. 22" (55.9 cm) width of opening (min.)
C. 199/16" (47.2 cm) height of ush inset cutout (min.)
E
D. 181/4" (46.4 cm) height of opening (min.)
e. Recommended junction box location
D
Top View
A. 2311/16" (60.2 cm) width of ush inset cutout (min.)
B. 22" (55.9 cm) width of opening (min.)
C. 199/16" (47.2 cm) height of ush inset cutout (min.)
D. 181/4" (46.4 cm) height of opening (min.)
E. 207/16" (51.8 cm) depth of cutout (min.)
Side Cleat* Side Cleat*
JJW6024HM: 13/16" (20.5 mm)
JJW6024HL: 27/32" (21.3 mm)
A. 207/16" (51.8 cm) depth of cutout (min.)
A
4
Loading...