Jenn-Air JFC2290VPF1, JFC2290VPY1, JFC2290VTB1, JFC2290VTB10 Installation Guide

Decorator Panel mensions an Installation.

mi = B

Suggested Panel Assembly Methods

17-3/4"

Thickness

* For ease of installation cut backer panel corners at

45o_ 1,,x 1,,

(451mm)

44-1/8"

(1121mm)

24"

(610mm)

35-3/4"

(908mm)

3/4" max

(19mm)

16-3/4"

(425mm)

43-3/16"

(1097mm)

23"

(584mm)

34-3/4"

(883mm)

1/16"

(2mm)

1" (25.4mm)

Typ.

17-3/8"

(441mm)

43-13/16" (1113mm)

23-9/16"

(599mm)

35-5/16"

(897mm)

(6mm)

I I

WEIGHT REQUIREMENTS FOR PANEL INSERTS

• individualrefrigerator door panels should not exceed 15 Ibs. (7 kg).

• Freezer drawer panel should not exceed 15 Ibs. (7 kg).

1/4"

Three Panel Method

Trim Frame

Surrounding Door

Refrigerator Door

Routed Raised Panel Method

Trim Frame

Surrounding Door

Front Panel ( 3/4" Max.)

Spacer Panel (1/16")

Backing Panel (1/4")

Routed Area

Front Panel ( 3/4" Max.)

Backing Panel (1/4")

i ]

12884405 06/08

Decorator Panel Installation

Excessive Weight Hazard

Use two or more people to move and install refrigerator.

Failure to do so can result in back or other injury.

Backing Panel

Spacer Panel

Trim

Front Panel

1. Lift upper locking trim from the door.

Door Panel

Door

Installation common with all panels.

NOTE: Consult your cabinetmaker for creation of decorator panels. Customer to provide own

handles.

See user guide for door removal if necessary.

NOTE: For ease of assembly and to familiarize

yourself with the installation process, add the

custom panel to the lower freezer drawer first.

Before removing backing from adhesive tape assure the decorator panel fits the

door.

2. Remove side trim from either side of door. Remove backing from adhesive tape.

o O

3. Align the bottom edge of the decorator panel to the lower fixed trim and center the panel with

the door.

Front Panel

4. Assure the side trim clip locates to the inside corner of the lower fixed trim.

7. Align the upper locking trim with the clips on

top of the side trim.

StDE TRtM

CLIP

8. Assure the upper locking trim grooves engage the rivets on the door panel while

simultaneously seating into the decorator panel groove.

5. Rotate one piece of the side trim to seat into the decorator panel groove.

9. Apply firm pressure to the upper locking trim to hold panel in place.

SIDE CLIP

10. Fully seated top trim is close to flush with top

of door and completely covers clips of side trim.

6. Repeat procedure for opposite side of door.

+ 7 hidden pages