Jenn-air DRAWERPANS Installation

JENN-AIR ELECTRIC WARMING DRAWER PAN KIT

INSTALLATION

G U I D E

JENN-AIR ELECTRIC WARMING DRAWER PAN KIT

Specifications subject to change without notice.

This kit contains supports and pans to fit your new Warming Drawer.

PARTS SUPPLIED:

One full size pan with lid, 21" long x 13" wide x 4" deep

Two half size pans with lids, 21" long x 6

Two quarter size pans with lids, 101/2" long x 61/2" wide x 4" deep

One set of side-to-side support rails

/2" wide x 4" deep

Front to Back Support Rails

30" Models

Filler Panel

ASSEMBLY

1. Remove the packaging and separate parts.

2. Open the drawer fully.

3. Drop one side-to-side rail (with slots in the top) into the

slots at the rear and one in the front of the drawer. Note that slots fit only one way, with the wide interlocking tabs on the right sides.

4. Drop filler panel into the right side.

5. Drop one or two front to back rails into matching slots.

6. Arrange pans to suit food storage needs.

Wide Slots Towards Rear

30" Models

Wide Slots Towards Inside

Small Slots Towards Front

Drop Rail Into Small Slots

Combinations with

full size pan

Combinations without

full size pan

IMPORTANT NOTES:

• Use the pan lids to keep foods moist.

• Do not use plastic wrap! Plastic wrap could melt and damage the interior of your warming drawer.

• Do not place water in the bottom of the warming drawer pan. Moisture can form on cabinets or drip below.

+ 2 hidden pages