Jenn-Air A312 Owner's Manual

Read before operating your Rotiss-Kebab

All appliances - regardless of the manufacturer - have the poten-
tial through improper or careless use to create safety problems.

Therefore the following safety precautions should be observed:

1. Never use your appliance for warming or heating the room.

2. Children should not be left alone or unattended in area where
appliance is in use. They should never be allowed to sit or

stand on any part of the appliance.

3. Wear proper apparel. Loose-fitting or hanging garments
should never be worn while using the appliance.

4. Do not repair or replace any part of the appliance unless
specifically recommended in this manual. All other servicing

should bereferred toan authorized Jenn-Air Service Contractor.

5. Flammable materials should not be stored near surface units.

6. Do not use water on grease fires. Smother fire or flame or use
dry chemical or foam-type extinguisher.

7. Use only dry potholders. Moist or damp potholders on hot
surfaces may result in burns from steam. Do not let potholder

touch hot heating elements. Do not use a towel or other bulky
cloth.

8. Do not use the accessory for other than its intended use.

9. Caution should be used when inserting pointed spit or skewers

into food: protect your hand.

10. Keep cord of motor from touching the heating element.

11. Do not use aluminum foil to line surface unit drip pans or grill
basin. Installation of these liners may result in an electric

shock or fire hazard.

12. Do not soak or immerse removable heating elements in water.

13. CAUTION - Do not store items of interest to children in
cabinets above cooktop - children climbing on the cooktop to

reach items could be seriously injured.

14. Do not operate with damaged cooking element after any
product malfunction until proper repair has been made.

2

Additional Safety Precautions to Follow

When using Other Parts of Your Cooktop

1. Donot touchsurfaceunitsorareas nearunits. Surface unitsor

heatingelementmay be hoteven thoughthey are dark incolor.

Areas near surface units may become hot enough to cause

burns. Duringandafter use,do nottouchor letclothing or other

flammable materials contact these areas until they have had
sufficienttimeto cool. Other surfacesmaybecome hotenough

to cause burns - among these surfaces is the cooktop.

2. Neverleavesurface unitsunattendedat highheatsettings. Boil
over causes smoking and greasy spillovers that may ignite.

3. Glazed cookware - only certain types of glass, glass-ceramic,
ceramic, earthenware, or other glazed cookware are suitable

forcooktop surfacewithout breakingduetothe suddenchange

intemperature. Useonlysuch cookwareas you knowhasbeen

approved for this purpose.

4. Cookware handles should be turned inward and not extend

overadjacent surfaceheating elements to avoid burns,ignition

offlammablematerialsandspillageduetounintentionalcontact
with the cookware.

5. Keepall switches "OFF" when unit isnot in use.

3

1. Before installing grill components, be certain
surface controls are in the OFF position.

2. Placethetwogrill-rocksintoanemptygrillbasin //UtlLqRm IllUllll;
with theirhandles runningparallel to thefront of ,,,/,.--.--..--l'nmw UlUllll

the cooktop. These grill-rocks must be used / _/ilUllll'

since they support the grill element.

3. Positionthe grillelement with the terminal plug ___11 / _ Illl_||_1iiiiIiii 1
towards the terminal receptacle. Slide the

elementtowardsthereceptacleuntiltheterminal Fig.A
plug iscompletely engaged. (See Fig. A.)

4. The grill elementshould rest flat on the handles
of thegrill-rocks. Do notplace blackgrill grates

over grill element. ._f_

5. Unfold front and rear supports until each is
standing vertically. Next, lift the side panel and
engage the tabs at each end of side panel into

the slotsinthe frontand rearsupports. (See Fig.

B).

y

6. Set the accessory base intothe grill basin with Fig.B
the openside next to the air grille.

7. Attachmotor torear support by insertingthe two

motor mounting studs into the two keyhole-
shaped slots in the support. (See Fig. C.) The /

motor shouldbe positioned horizontally with the
powercord pointedupward.CAUTION: Position ,d

motor cord around the outside of the Rotiss-
Kebab to prevent motor cord from touching the
grill element. To turnon motor, plug cord intoan

outlet. /

8. Theaccessorycannow beassembledfor useas Fig.C
a rotisserie or for preparing kebabs.

!