Jenn-Air 8101P423-60 User Manual
p_
INSTALLATION
INSTRUCTIONS
Built-In 27"& 30" IJENN-AIR
ElectricWall Ovens [ WESTFOORTHS, EETNOR,H
11/4+Dia.ConduitAccessHob* 11/4"Dia.ConduitAccessHole*
5/8"PlyweedFloor(MustSupport142Ibs.) 5/8"PlywoodFloor(MustSupport142Ibo.) _ --_1
inches cm inches cm
A 27MIN 68.58 A 30MIN 76.20
B 24MIN 60.86 B 24MIN 60.96
D 231/2MIN 59.69 D 231/2MIN 59.69
E 251/2-:-1/16 64.77 E 283/36:L1/16 71.60
F 273/4 70.49 F 273/4 70.49
G 26 3/4 67.95 G 293/4 75.57
H 247/I 6 62.07 H 247/16 62.07
I 4to33 10.2to83.8 I 4t033 10.2to83.8 B "_,_ "4L- I
1114"Die.Condu__s Ho_* 1t/4"Die.Cor_unA=_Ho_* DOUBLEWALLOVEN
5/8"PlywoodFloor(MustSupport250Ibs.) 5/8_PlywoodFbor(MustSupport250Ibs.)
inchee cm inchee cm
DIMENSIONS DIMENSIONS
B 24MIN 60.96 B 24MIN 60.9_
C 495/8+_1/16 126.05 C 495/8+_1/16 126.05
D 231/2MIN 59.69 D 231/2MIN 59.69
E 251/2+ 1/16 6¢77 E 283/16+_.1/16 71.60
SINGLEWALLOVEN
/
H 247/36 62.07 H 247/16 62.07
I 4 to12 10.2to30.5 I 4to12 10.2to30.5 _.
1 1/4"Dla.ConduitAccessHole*
I
2 I 5/8" PlvwusdFloortMustSupport142Ibs.I 2
A 25 63.50 A 25 63.50
B 24MIN 60.96 B 24MIN 60.96 J ¥ Y'_ _
E 251/2.+.1/16 64.77 E 283/16 71.60
O 231/2MIN 59.69 O 231/2MIN 59.69 _ __ JI"e'-- I'1-"'_t
F 273/4 70.49 F 273/4 70.49
83/4 87.95 75.57
J5/8"PlywoodFleor(MustSupport142Ibo.)I -- -- " "
DIMENSIONS DIMENSIONS
inch, cm inches =m UNDERCOUNTERWALLOVEN
3/4 87.95 3/4 75.57
N 807 , 47/15 507
I 36 91.44 I 36 91.44
J tt/2 3.81 J 11/2 3.81 P"- _z
27" WALLOVEN 30" WALl
** COOKTOPS inches cm inches Donotblockairintakesbtsabngbottomofoven.
K 4BurnerGasGlassTop 21/8MIN 5.4MIN 21/8MIN 5.4MtN Gusorelactriccooktopomaybeinstalledoverovens.
K Electric 31/8MIN 7.9MIN 31/8MIN 7.9MIN
K Induction 31/8MIN 7.9MIN 31/8MIN 7.9MIN accessiblelocation.Cooktopandwagovenmustbeonseparate
K 4BurnerGusStampedTop 413/16MIN 12.2MIN 4 13/36MIN 12.2MIN 120/240or120/208volt60HzACcircuits.
NOTE: * Holemustbecutasclosetocornerofcabinetaspossible, 8101P423..60
** See dealer for approved cooktops, (10-01-00)
Seecooktopinstallationinstructior_forcutoutsize.
Electricalconnectionforelectdccooktopmustinadjacent
When installinga 27" wall oven under a 30" cooktop Installing Bottom Trim Piece
some interferencemay occur.The followingcutout
notching of the side trims will eliminate the interference of
the side trim to the burner box. After cutting, file the side
trim edges to eliminate burrs.
_"_-'-_ 1.,-
f Electrical Connections
' Unit to be propedycircuitprotectedandwired according
_ to local electrical code and National ElectricalCode.
It is advisable that the electrical wiring and hookup be
accomplished by a competent e(ectrician.
120/240VAC or 120/208 VAC 60 Hz. See serial plate on
front of unit for power requirements.
CAUTION The neutral of this unit is grounded to the frame through
For European style cabinets (flush front) the required the green or solid grounding wire. (The green and the
clearance for operation of the oven door is minimum white wires are twisted together at the termination of the
spacing of 718"between the cutout and the door, hinge conduit.) If used on new branch-circuit installations (1996
or drawer of the cabinet. NEC), mobile homes, recreationalvehicles, or in an area
Some built-in cabinets may notbe wide enough, dueto conductor, untwist or disconnect the green wire and
their construction, to allow this installation, connect thegreen wire to ground in accordance with local
1. Cut hole in cabinet to mount oven. Cutout in cabinet connectors. Use copper or aluminum wire. If aluminum
should be level and straight, wire is used, use connectors recognized for joining
NOTE: There are no provisions to level the unitafter it
is installed. An oven that is not level couldcause poor The chart below recommends the minimum circuit
baking results, protection and wire size if the appliance is the only unit on
2. Install plywood floor as shown, the circuit.
where local codes prohibit grounding through the neutral
code. Connect the white neutral to the service neutral.
Connect ail wires to the branch circuit with approved
aluminum to copper.
3. Attach unit to the cabinet with four No. 8 x 1" screws RECOMMENDEDMINIMUM
suppliedwithunit inside of envelopecontaining these ICW.RATING CIRCUITPROTECTION WIRESIZE
instructions. Pre-drill holes in cabinet for attachment ONSERIALPLATE INAMPERS (AWG)
screws using 1/8" drill. Oven mounting holes are 0 - 4.8 20 12
provided in side trim. 4.9 ° 6.9 30 10
4. See instructions at right for e_ectficalhook-up. 10.0- 1_9 50 8
5, See Use andCare Manual for operatinginstructions,
7.0- 9.9 40 8
12.0- 14.9 60 6
Service
Interruptthe sourceof electricityto the unitwhen
attemptingto repairor servicethe oven. Failuretodo this
couldresultin a dangerousoreven fatalshock.
IMPORTANT - SAVE FOR LOCAL ELECTRICAL INSPECTOR'S USE
Loading...