Jenn-Air 740-0165-LP, 750-0165 User Manual

0 (0)
STAINLESS STEEL BUILT-IN GAS GRILL
MODEL #s: 740-0165 (LP) / 750-0165 (NG) LOWE’S ITEM #s: 144510/157618
Jenn-Air is a Trademark of the Maytag Corporation and is used under license to Lowe’s Companies, Incorporated.
FOR OUTDOOR USE ONLY
PLEASE CONTACT 1-800-554-5799 FOR ASSISTANCE DO NOT RETURN TO PLACE OF PURCHASE

TABLE OF CONTENTS

SECTION ONE Safety Instructions……………………………. Placement of the Grill…………………………
SECTION TWO Model Specifications…………………………. Island Construction…………………………… Front View for Built-In Opening……………… Side View for Built-In Opening……………….
SECTION THREE Battery Installation……………………………. LP Gas Hook-Up……………………………… Propane Regulator Hook-Up……………….. Installation of NG Regulator………………… Natural Gas Hook-Up………………………..
SECTION FOUR Leak Testing………………………………… Installer Final Checklist…………………… Operating Instructions……………………. Lighting Instructions……………………….. Lighting Illustrations……………………….. To Match Light the Grill……………………. Care and Maintenance…………………… Troubleshooting…………………………….
1-4 4
5 6 7 8
9 10 11 12 13
14 15 16-17 18 19 20 21 22
SECTION FIVE Exploded View Model 740-0165………….. Parts List Model 740-0165……………….. Exploded View Model 750-0165………….. Parts List Model 750-0165………………..
SECTION SIX Grilling Hints……………………………….. Grill Cooking Chart………………………… Grill Recipes…………………………………
SECTION SEVEN Warranty Information………………………
23 24 25 26
27 27-29 30-31
32
WARNING
To reduce the risk of fire, burn hazard or other injury, read this Care and Use Manual carefully and completely before using your grill.
SAFETY INSTRUCTIONS
RECOGNIZED SAFETY SYMBOLS, WORDS AND LABELS
SAFETY SYMBOLS
COMMON CAUTIONS AND WARNINGS
WARNING
Hazardous or unsafe practices that could result in severe personal injury or death.
INSECT WARNING
Spiders and insects can nest inside the burners of this and other grills, which could disrupt gas flow. This dangerous condition could cause a fire behind and beneath the valve panel, damaging the grill and making it unsafe to operate.
Inspect the grill at least twice a year.
ELECTRICAL GROUNDING WARNING
The rotisserie motor should be plugged directly into a properly grounded receptacle.
Do not cut or remove the grounding prong from this plug.
Keep the rotisserie motor electric cord away from the heated surfaces of the grill.
When not in use, remove and store the motor in a dry location.
LP GAS CYLINDER WARNING
The LP Gas Cylinder must be fitted with an Overfill Protection Device (OPD).
For Your Safety:
1. Do not store spare LP-gas cylinders under or near this appliance.
2. Never fill the cylinder beyond 80 percent capacity.
3. If the information above is not followed exactly, a fire resulting in death or serious injury could occur.
Hazardous or unsafe practices that could result in minor personal injury.
CAUTION
WARNING
Do not use the grill if gas odor is present. Contact customer service at 1-800-554-5799.
WARNING
Do not try lighting this appliance without first reading the “LIGHTING INSTRUCTIONS” section of this manual.
WARNING
If you smell gas:
1. Shut off gas to the appliance.
2. Extinguish any open flame.
3. Open lid.
4. If odor continues, immediately call your gas supplier or your fire department.
WARNING
Cylinder must be stored outdoors out of the reach of children and must not be stored in a building, garage or any other enclosed area.
1
SAFETY INSTRUCTIONS

WARNING

Do not attempt to use damaged or obstructed equipment. See your local LP gas dealer for repair.
WARNING Do not install this unit into combustible enclosures. There should be a minimum clearance of at least 24 in. from all sides to combustible materials.
WARNING
Do not use the grill until all connections have been checked and do not leak.
Do not smoke while leak testing. Never leak test with an open flame.
WARNING Always check for leaks after every LP tank change.
CAUTION
Burner adjustments should only be performed after the burners have cooled.
CAUTION
Do not leave the grill unattended while cooking.
CAUTION
Remove the warming rack when using the rotisserie burner. High heat from the burner may cause the warming rack to bend.
WARNING While lighting, keep your face and body as far from the grill as possible.
CAUTION
Before cleaning make sure the burners are cool, and the gas supply and knobs are in the “OFF” position.
CAUTION
Failure to ensure proper placement of the burner over the valve assembly can cause a fire to occur behind and beneath the valve panel, thereby damaging the grill and making it unsafe to operate.
WARNING
Storage of an outdoor cooking gas appliance indoor is permissible only if the cylinder is disconnected and removed from the outdoor cooking gas appliance.
Model 750-0165 Natural gas Grill
WARNING
1. The outdoor cooking gas appliance and its individual shutoff valve must be disconnected from the gas supply piping system during any pressure testing of that system at test pressure in excess of ½ psi (3.5 kpa).
2. The outdoor cooking gas appliance must be isolated from the gas supply piping system by closing its individual manual shutoff valve during any pressure testing of the gas supply piping system at test pressures equal to or less ½ psi (3.5 kpa).
Model 740-0165 LP Gas Grill
WARNING
1. Do not store spare LP gas cylinders under or near this appliance.
2. Never fill the cylinder beyond 80 percent capacity.
3. If the information above is not followed exactly, a fire resulting in death or serious injury could occur.
2
SAFETY INSTRUCTIONS
WARNING Do not try lighting this appliance without first reading the “LIGHTING INSTRUCTIO
When using the grill, do not touch the grill rack, burner grate or immediate surroundings as these areas become extremely hot and could cause burns. Use only dry potholders. Moist or damp potholders on hot surfaces may cause steam burns. Do not use a towel or bulky cloth in place of potholders. Do not allow potholders to touch hot portions of the grill rack.
Grease is flammable. Let hot grease cool before attempting to handle it. Do not allow grease deposits to collect in the grease tray at the bottom of the grill’s firebox. Clean the grease tray often.
GRILL SPECIFICATIONS
Description 740-0165 and 750-0165
Cutout Width 38 3/4 in. (98.43 cm) Cutout Depth 21 3/4 in. (55.25 cm) Cutout Height 10 7/8 in. (27.63 cm)
Natural Gas: Standard residential 1/2 in. (1.3 cm) ID gas service line. Natural gas hose/regulator assembly included with quick­connect fitting for attachment to house natural gas line.
Gas Requirements
Liquid Propane: Supplied with hose/regulator assembly for connection to standard 5 gal, 20 lb. liquid propane gas cylinder with Type 1, QCC-1 connection.
Grill Burners
BTU Ratings
Approximate Shipping Weight
4 Cast brass main burners. Infra-red rear rotisserie burner. 1 Sear burner.
Main burners 52,000 BTU/Hr. Rear burners 16,000 BTU/Hr.
Sear burners 23,000 BTU/Hr. Total 91,000 BTU/Hr.
196 lbs.
5
ISLAND CONSTRUCTION
WARNING Do not install this unit into combustible enclosures. There should be a minimum clearance of at least 24 in.(60.96cm) from all sides to combustible materials.
5 in.(12.70cm)
FRONT VIEW FOR BUILT-IN OPENING
3 in.(7.62cm)
8 in.(20.32cm)
38 1/4 in.(97.16cm)
400
500
300
200
150
250
600
200
100
300
50
350
C¡ã
¡ã
700F
100
9 in.(22.86cm)
10 7/8 in.(27.63cm)
1 7/8 in.(4.76cm)
The following are minimum dimensions necessary to install the 4 burner + 1 sear burner built-in grills: Width of grill head: 38 1/4 in.
Depth for grill control panel: 10 7/8 in. Combustion Gap below control panel: 1 7/8 in.
A minimum of 6 in. clearance is needed from the right side of the grill firebox to non-combustible
materials. The rotisserie motor is located on the left side of the grill firebox.
A minimum of 8 in. clearance is required between the grill lid and any surrounding material to
allow for proper functioning of the rotisserie motor.
6 in.(15.24cm)
7
SIDE VIEW FOR BUILT-IN OPENING
26 3/8 in.(66.99cm)
24 3/4 in.(62.87cm)
25 3/8 in.(64.45cm)
12 3/4 in.(32.38cm)
10 7/8 in.(27.63cm)
8 3/8 in.(21.27cm)
9 in.(22.86cm)
To ensure proper combustion.1 7/8 in.(4.76cm) space is needed between the bottom of the qrease tray andthe island material.
The following are minimum clearances necessary around the Jenn-Air built-in 4 burner +1 sear burner grills: Rear Clearance: 3 in. to non-combustible materials
24 in. to combustible materials Combustion gap below control panel: 1 7/8 in.
A minimum of 7.875 in.(20.00cm) is required between the back of the grill and any non-combustible material. A minimum of 24 in.(60.96cm)is required between the back of the grill and any combustible material.
8

BATTERY INSTALLATION

1. To inst all the battery, remove the ignition button housing.

2. Insert the battery into the housing with the positive terminal facing outward.

3. Replace the ignition button housing after the battery has been installed (See the image below).

9
Loading...
+ 23 hidden pages