Jenn Air 730-0163 Owner's Manual
STAINLESS STEEL NATURAL GAS GRILL
MODEL NO.: 730-0163 ITEM NO: 24193
Jenn-Air is a Trademark of the Maytag Corporation and is used under license to Lowe’s Companies, Incorporated.
FOR OUTDOOR USE ONLY
PLEASE CONTACT 1-800-554-5799 FOR ASSISTANCE
DO NOT RETURN TO PLACE OF PURCHASE
TABLE OF CONTENTS
SECTION ONE
Safety Instructions…………………………….
Placement of the Grill ………………………..
SECTION TWO
Side Burner & Side Shelf Assembly…………
Quick Connector Assembly………………….
Side Shelf Handle & Battery Assembly…….
Braking System Operations…………………
Installation of Natural Gas Regulator ………
SECTION THREE
Gas Hook Up & Leak Testing ……………….
Installer Final Check…………………………..
SECTION FOUR
Operating Instructions………………………
Lighting Instructions …………………….
To Match Light the Grill……………………..
Lighting Illustrations…………………………
Using the Side Burner………………………
Care and Maintenance of Side Burner……
Care and Maintenance of the Grill…………
Troubleshooting …………………………
WARNING
1-5
5
6
7
8
9
9
10
11
12
13
14
15
16
16
17
18
SECTION FIVE
Exploded View……………………………..
Parts List…………………………………….
SECTION SIX
Grilling Hints………………………………
Grill Cooking Chart………………………..
Grill Recipe Suggestions…………………
SECTION SEVEN
Limited Warranty………………………….
19
20
21
21-23
24-25
26
To reduce the risk of fire, burn hazard or other
injury, read this Care and Use Manual carefully
and completely before using your grill.
SAFETY INSTRUCTIONS
RECOGNIZED SAFETY SYMBOLS, WORDS AND LABELS
WARNING
WARNING – Hazards or unsafe
practices which COULD result in severe
personal injury or death.
CAUTION
CAUTION – Hazards or unsafe practices
which COULD result in minor personal
injury.
WARNING
Do not try lighting this appliance without first reading
the “LIGHTING INSTRUCTIONS” section of this
manual.
Spiders and insects can nest inside the burners of
the grill and disrupt gas flow. This very dangerous
condition could cause a fire behind the valve panel,
thereby damaging the grill and making it unsafe for
operation.
Inspect the grill at least twice a year.
WARNING
WARNING
1. The grill and its individual shut-off valve must be disconnected from the gas supply piping
system during any pressure testing of that system at test pressure in excess of ½ psi. (3.5
kpa).
2. The grill must be isolated from the gas supply piping system by closing its individual
manual shut-off valve during any pressure testing of the gas supply piping system at test
pressure equal to or less ½ psi. (3.5 kpa).
WARNING
Never attempt to use damaged or obstructed equipment. See your local liquid propane dealer for
repair.
WARNING
Check all gas supply fittings for leaks before each use. Do not use the grill until all connections
have been checked and do not leak.
Do not smoke while leak testing.
Never leak test with an open flame.
CAUTION
When using the rotisserie burner, remove the
warming rack. High heat from the burner
may cause the warming rack to bend.
WARNING
The rotisserie motor is equipped with a plug and should
be plugged directly into a properly grounded receptacle.
DO NOT cut or remove the grounding prong from this
plug.
Keep the rotisserie motor electric cord away from the
heated surfaces of the grill. When not in use remove and
store the motor in a dry location
WARNING
1. Attach the coupling half (socket) to
the gas supply line in accordance
with NFPA54/ANSI Z223.1FUEL gas
code.
2. Prior to inserting the plug, test the
connection for leaks following the
leak test instructions on page 10.
After the leak test is completed, rinse
the connection with clean water to
remove any corrosive residue.
3. Do not use open flame to test for
leaks.
1
SAFETY INSTRUCTIONS
WARNING
Do not use the grill if the odor of gas is
present. Contact customer service at 1800-554-5799.
When lighting, keep your face and hands
as far away from the grill as possible.
If you smell gas:
1. Shut off gas to the appliance.
2. Extinguish any open flame.
3. Open lid.
4. If odor continues, immediately call your
gas supplier or your fire department.
Do not store or use gasoline or other
flammable vapors and liquids in the
vicinity of this or any other appliance.
WARNING
WARNING
WARNING
CAUTION
When using a match to light the grill make
sure to use the attached lighting rod.
CAUTION
Before cleaning, make sure the gas supply
and control knobs are in the “OFF” position
and the burners have cooled.
WARNING
Failure to properly place the burner over
the orifice could cause a fire to occur
behind and beneath the valve panel,
thereby damaging the grill and making it
unsafe to operate.
WARNING
Do not leave the grill unattended while
cooking.
2
SAFETY INSTRUCTIONS
WARNING
Do not attempt to light the grill if gas odor is
present. Contact customer service at 1-800-554-
5799.
When lighting, keep your face and body as far
away from the burner as possible.
BEFORE LIGHTING
Inspect the gas supply hose prior to turning on the
gas. If there is evidence of cuts, wear, or abrasion,
it must be replaced prior to use.
Only the pressure regulator and hose assembly
supplied with the unit should be used. Never
substitute regulators for those supplied with the
grill. Contact customer service for proper
replacement.
Leak check the piping and regulator connections
with a soap and water solution before operating
the grill (See “Leak Testing” instructions on page
10).
Do not turn “ON” the gas supply at the natural gas
shut off valve unless the Quick-Connect gas hose
is properly connected to the side burner gas pipe
system and all burner valves are in the “OFF”
position.
WARNING
Do not store or use gasoline or other flammable
vapors and liquids in the vicinity of this or any
other appliance.
USING THE SIDE BURNER
Inspect the gas supply hose prior to turning on
the gas. If there is evidence of cuts, wear or
abrasion, it must be replaced prior to use. Do
not use the side burner if gas odor is present.
Keep a spray bottle of soapy water near the
gas supply valve and check the connections
before each use.
ROTISSERIE DRIVE MOTOR
To ensure continued protection against electric
shock:
Connect to properly grounded outlets only.
Keep extension cord connections dry and off
the ground.
Do not expose to rain.
Do not use indoors.
WARNING
If you smell gas:
1. Shut off gas to the grill.
2. Open the top cover or lid.
3. Extinguish any open flames.
4. If the odor continues, immediately call your
gas supplier or local fire department.
3
SAFETY INSTRUCTIONS
WARNING
Do not try lighting this appliance without first
reading the “LIGHTING INSTRUCTIONS” section
of this manual.
TESTED IN ACCORDANCE WITH ANSI Z21.58
LATEST STANDARD and CSA 1.6 LATEST
STANDARD FOR OUTDOOR COOKING GAS
APPLIANCES.
Check your local building codes for the proper
method of installation. In the absence of local
codes, this unit should be installed in accordance
with the National Fuel Gas Code ANSI
Z223.1/NFPA 54, or CSA B149.1 Natural Gas and
Propane Installation Code, and the National
Electrical Code, ANSI/NFPA 70.
CALIFORNIA PROPOSITION 65-WARNING
The burning of gas fuel generates some byproducts, which are known by the State of
California to cause cancer or reproductive harm.
To minimize exposure to these substances,
always operate this unit according to the care and
use manual, ensuring you provide good
ventilation when cooking with gas.
SAFETY PRACTICES TO AVOID INJURY
When properly cared for, your grill will provide
safe, reliable service for many years. However,
extreme care must be used as the grill produces
intense heat that can increase accident potential.
When using this appliance basic safety practices
must be followed, including the following:
Do not repair or replace any part of the grill unless
specifically recommended in this manual. All other
service should be referred to a qualified
technician.
The grill is for outdoor use only.
The grill is not intended to be installed in or on
recreational vehicles and/or boats.
Children should not be left alone or unattended in
an area where the grill is being used. Do not allow
children to sit, stand or play on or around the grill
at any time.
Do not store items of interest to children around or
below the grill or cart. Do not allow children to
crawl inside the cart.
Never let clothing, pot holders or other flammable
materials come in contact with or too close to any
grate, burner or hot surface until it has cooled.
The fabric could ignite, causing serious personal
injury.
For personal safety, wear proper apparel. Loose
fitting garments or sleeves should never be worn
while using this appliance. Some synthetic fabrics
are highly flammable and should not be worn
while cooking.
Only certain types of glass, ceramic, earthenware
or other glazed utensils are suitable for grill use.
Other types of materials may shatter with sudden
temperature changes. Use only on low or medium
heat settings in accordance with the
manufacturer’s guidelines.
Do not heat unopened food containers as a buildup of pressure may cause the containers to burst.
Use a covered hand when opening the grill lid.
Never lean over an open grill.
When lighting a burner, always pay close
attention to what you are doing. Make certain you
are aware of which burner you are lighting so that
your body and clothing remain clear of open
flames.
4
SIDE BURNER & SIDE SHELF ASSEMBLY
Estimated Assembly Time: Approximately 10 minutes
Required Tools: Phillips Screwdriver
1. Remove both side burner and side shelf from inside grill cart.
2. The screws used to attach the side shelf and side burner are already screwed into the side
panels of the grill cart. Remove the screws from the side panels.
3. Align the holes in the left side shelf with the holes in the grill cart. Insert the screws and tighten.
Note: The top two screws insert from inside the fire box while the bottom two screws insert
from under the left side shelf.
4. Repeat steps 2 and 3 to attach the right side burner to the right side panel.
Secure the bottom two
screws below the side shelf.
Secure the top two screws
from inside the fire box.
Secure bottom screw from
below the side shelf front
and side burner
panel
control panel.
6
SIDE BURNER HOSE QUICK-CONNECT ASSEMBLY
Estimated Assembly Time: Approximately 5-7 minutes
No tools required for assembly.
1. Insert the side burner hose with male end of the quick-connect fitting through the side panel of
the cart (top drawing).
2. Push the sleeve of the female socket back and insert male end of the connector. Release the
sleeve.
3. Push the male end in until the female sleeve snaps forward to lock the fitting.
4. To disconnect the fitting, push the female sleeve back and pull the male end out (bottom
drawing).
WARNING
1. Attach the coupling half (socket) to the gas
supply line in accordance with NFPA54/ANSI
Z223.1FUEL gas code.
2. Prior to inserting the plug, test the connection
for leaks following the leak test instructions on
page 10. After the leak test is completed, rinse
the connection with clean water to remove any
corrosive residue.
3. Do not use an open flame to test for leaks.
7
Loading...