Jenn-Air 720-0100-NG User Manual
STAINLESS STEEL GAS GRILL
MODEL NO.: 720-0100-NG ITEM NO: 109476
Jenn-Air is a Trademark of the Maytag Corporation and is used under license to Lowe’s Companies, Incorporated.
FOR OUTDOOR USE ONLY
PLEASE CONTACT 1-800-554-5799 FOR ASSISTANCE
DO NOT RETURN TO PLACE OF PURCHASE
TABLE OF CONTENTS
SECTION ONE
Safety Instructions………………………….
Placement of the Grill………………………
SECTION TWO
Side Burner & Side Shelf Assembly………
Side Burner Lid & Handle Assembly ……..
Battery, Spice Tray & Brake Assembly……
Installation of Natural Gas Regulator...……
SECTION THREE
Gas Hook Up & Leak Testing … … … … …
Installer Final Check……………………….
SECTION FOUR
Operating Instructions……………………..
Lighting Instructions………………………..
To Match Light the Grill…………………….
Easy Lighting Illustrations………………….
Using the Side Burner ……………………..
Care and Maintenance of Side Burner…....
Care and Maintenance of the Grill…………
Troubleshooting……………………………..
To reduce the risk of fire, burn hazard or
other injury, read this Care and Use
Manual carefully and completely before
using your grill.
1-3
3
4
5
6
7
8
9
10
11
12
13
14
14
15
16
SECTION FIVE
Exploded View……………………….…..
Parts List …………………………………
SECTION SIX
Grilling Hints ……………………………..
Grill Cooking Chart ………………………
Grill Recipe Suggestions ……………….
SECTION SEVEN
Limited Warranty …………………………
17
18
19
19-21
22-23
24
SAFETY INSTRUCTIONS
PRECAUTIONS
WARNING
Do not attempt to light the grill if gas odor is
present. Contact customer service at 1-800554-5799.
When lighting, keep your face and body as far
away from the burner as possible.
BEFORE LIGHTING
Inspect the gas supply hose prior to turning on the
gas. If there is evidence of cuts, wear, or abrasion,
it must be replaced prior to use.
Only the pressure regulator and hose assembly
supplied with the unit should be used. Never
substitute regulators for those supplied with the
grill. Contact customer service for proper
replacement.
Leak check the piping and regulator connections
with a soap and water solution before operating
the grill (See “Leak Testing” instructions on page
8).
LP GAS CYLINDER WARNING
1. Do not store or use gasoline or other
flammable vapors and liquids in the vicinity
of this or any other appliance.
USING THE SIDE BURNER
Inspect the gas supply hose prior to turning on
the gas. If there is evidence of cuts, wear or
abrasion, it must be replaced prior to use. Do
not use the side burner if gas odor is present.
Keep a spray bottle of soapy water near the
gas supply valve and check the connections
before each use.
ROTISSERIE DRIVE MOTOR
To ensure continued protection against electric
shock:
Connect to properly grounded outlets only.
Keep extension cord connections dry and off
the ground.
Do not expose to rain.
Do not use indoors.
WARNING
If you smell gas:
1. Shut off gas to the grill.
2. Open the top cover or lid.
3. Extinguish any open flames.
4. If the odor continues, immediately call your
gas supplier or local fire department.
1
SAFETY INSTRUCTIONS
WARNING
Do not try lighting this appliance without first
reading the “LIGHTING INSTRUCTIONS” section
of this manual.
TESTED IN ACCORDANCE WITH ANSI Z21.58b
LATEST STANDARD and CGA 1.6b LATEST
STANDARD FOR OUTDOOR COOKING GAS
APPLIANCES.
Check your local building codes for the proper
method of installation. In the absence of local
codes, this unit should be installed in accordance
with the National Fuel Gas Code ANSI
Z223.1/NFPA 54, Storage and Handling of
Liquefied Petroleum Gases, ANSI/NFPA 58 or
CSA B149.1 Natural Gas and Propane Installation
Code, and the National Electrical Code,
ANSI/NFPA 70.
CALIFORNIA PROPOSITION 65-WARNING
The burning of gas fuel generates some byproducts, which are known by the State of
California to cause cancer or reproductive harm.
To minimize exposure to these substances,
always operate this unit according to the care and
use manual, ensuring you provide good
ventilation when cooking with gas.
SAFETY PRACTICES TO AVOID INJURY
When properly cared for, your grill will provide
safe, reliable service for many years. However,
extreme care must be used as the grill produces
intense heat that can increase accident potential.
When using this appliance basic safety practices
must be followed, including the following:
Do not repair or replace any part of the grill unless
specifically recommended in this manual. All other
service should be referred to a qualified
technician.
The grill is for outdoor use only.
The grill is not intended to be installed in or on
recreational vehicles and/or boats.
Children should not be left alone or unattended in
an area where the grill is being used. Do not
allow them to sit, stand or play on or around the
grill at any time.
Do not store items of interest to children around or
below the grill or cart. Do not allow children to
crawl inside the cart.
Never let clothing, pot holders or other flammable
materials come in contact with or too close to any
grate, burner or hot surface until it has cooled.
The fabric could ignite, causing serious personal
injury.
For personal safety, wear proper apparel. Loose
fitting garments or sleeves should never be worn
while using this appliance. Some synthetic fabrics
are highly flammable and should not be worn
while cooking.
Only certain types of glass, ceramic, earthenware,
or other glazed utensils are suitable for grill use.
Other types of materials may shatter with sudden
temperature changes. Use only on low or medium
heat settings in accordance with the
manufacturer’s guidelines.
Do not heat unopened food containers as a buildup of pressure may cause the containers to burst.
Use a covered hand when opening the grill lid.
Never lean over an open grill.
When lighting a burner, always pay close
attention to what you are doing. Make certain you
are aware of which burner you are lighting so that
your body and clothing remain clear of open
flames.
2
SAFETY INSTRUCTIONS
When using the grill, do not touch the grill rack,
burner grate or immediate surroundings as these
areas become extremely hot and could cause
burns. Use only dry potholders. Moist or damp
potholders on hot surfaces may cause steam burns.
Do not use a towel or bulky cloth in place of
potholders. Do not allow potholders to touch hot
portions of the grill rack.
Grease is flammable. Let hot grease cool before
attempting to handle it. Do not allow grease
deposits to collect in the grease tray at the bottom
of the grill’s firebox. Clean the grease tray often.
Do not use aluminum foil to line the grill racks or
grill bottom. This can severely upset combustion air
flow or trap excessive heat in the control area.
For proper lighting and performance of the burners,
keep the burner ports clean. It is necessary to clean
them periodically for optimum performance. The
burners will only operate in one position and must
be mounted correctly for safe operation.
Clean the grill with caution. To avoid steam burns,
do not use a wet sponge or cloth to clean the grill
while it is hot. Some cleaners produce noxious
fumes or can ignite if applied to a hot surface.
INSECT WARNING
Spiders and other insects can nest inside the
burners of this and other grills, which could disrupt
gas flow. This dangerous condition could cause a
fire behind and beneath the valve panel, damaging
the grill and making it unsafe for operation.
Inspect the grill at least twice a year.
Never use a dented or rusty propane tank.
PLACEMENT OF THE GRILL
CLEARANCE
Non-Combustible Construction
A minimum of 3 in. clearance from the back of
the grill to non-combustible materials are required
for the lid to open fully.
WARNING
Do not install this unit into combustible
enclosures. There should be a minimum
clearance of 24 in. from all sides to combustible
materials.
Turn off all control knobs and make certain the grill
is cool before using any type of aerosol cleaner on
or around it. The chemical that produces the
spraying action could, in the presence of heat,
ignite or cause metal parts to corrode.
Do not use the grill to cook excessively fatty meats
or other products which promote flare-ups.
Do not operate the grill under unprotected
combustible constructions. Use only in well
ventilated areas. Do not use in buildings, garages,
sheds, breezeways or other such enclosed areas.
This unit is intended for outdoor use only.
Keep the areas surrounding the grill free from
combustible materials, fluids, trash, and vapors
such as gasoline or charcoal lighter fluid. Do not
obstruct the flow of combustion and ventilation air. If
the unit is stored indoors, make sure it is cool.
Do not use briquettes of any kind in the grill.
The 720-0100-NG grill is designed for optimum
performance without the use of briquettes. Do not
place briquettes on the flame tamers as this will
block the vent to the grill burners. Adding briquettes
can damage ignition components and knobs, thus
voiding the warranty.
Keep the back of the cart free and clear from
debris. Keep electrical supply cords and the
rotisserie motor cord away from heated areas of the
grill.
Never use the grill in extremely windy conditions. If
located in a consistently windy area (oceanfront,
mountaintop, etc.), a windbreak will be required.
Always adhere to the clearance specifications.
LOCATION
When determining a suitable location take into
account concerns such as exposure to wind,
proximity to traffic paths, and keeping gas supply
lines as short as possible.
Place the grill in well-ventilated areas. Never place
the grill in a building, garage, breezeway, shed or
other such enclosed areas. During heavy use, the
grill will produce a lot of smoke.
3
SIDE BURNER & SIDE SHELF ASSEMBLY
1. Open the grill lid and remove the side burner from the fire box (Top drawing).
2. The screws used to attach the side shelf and side burner are already screwed into the side of
the grill cart (Top drawing). Remove the screws from the side panels.
3. Align the holes of the left side shelf with those in the grill cart, insert the screws and tighten.
The top two screws insert from inside the fire box while the bottom two screws insert from
under the left side shelf.
4. Repeat steps 2 and 3 to install the right side burner onto the right side panel.
5. Secure the side burner hose with the two clips located under the side burner shelf (bottom
drawing).
Step 1
Secure top two screws
from inside the fire box.
Secure bottom two
under the left side
shelf.
Step 5
4
SIDE BURNER LID ASSEMBLY
1. Open the lid and cut the plastic tie.
2. Remove the screws from the handle and re insert them through the side burner lid.
3. Tighten the screws.
SIDE BURNER HANDLE ASSEMBLY
1. Remove the four handle screws from the side of the burner shelf.
5
BA TTER Y ASSEMBLY
1. Remove the ignition button housing.
2. Insert the battery into the housing with the positive side facing outward.
3. Replace the ignition button housing after the battery has been installed.
SPICE TRAY & BRAKE ASSEMBLY
6
INSTALLATION OF NATURAL GAS REGULATOR
Connect the PVC Gas Hose
to the house gas line using
the quick-connect fitting.
The Natural Gas regulator has
been factory installed. Insert the
PVC Gas Hose through the hole
in the rear cart panel and attach
to the regulator.
7
Loading...