Jelly Belly Dual Ice Shaver User Manual

ELLY BELLY™ DUAL ICE SHAVER

Instruction Manual

www.registerfocus.com

Important Safeguards ............................................................................................... 2

Before Using for the First Time ................................................................................ 3

Using Your Ice Shaver ............................................................................................. 4

Cleaning Your Ice Shaver ........................................................................................ 5

Cool & Easy Treats .................................................................................................. 5

Warranty ................................................................................................................... 6

SAVE THIS INSTRUCTION MANUAL FOR FUTURE REFERENCE

™, ™,  2011 Jelly Belly Candy Company, Fairfield, CA 94533 USA

Manufactured and Distributed by Focus Electrics, LLC Authorized Licensee,

West Bend, WI 53095 USA

www.focuselectrics.com

IMPORTANT SAFEGUARDS

To prevent personal injury or property damage, read and follow all instructions and warnings.

When using electrical appliances, basic safety precautions should always be followed including:

• Read all instructions.

• To protect against fire, electric shock, and injury to persons do not immerse

cord, plugs, or other electric parts in water or other liquids.

• Close supervision is necessary when this appliance is used by or near children.

• Always unplug from outlet when not in use and before cleaning. Allow to cool

before putting on or taking off parts and before cleaning.

• Do not operate any appliance with a damaged cord or plug, after the appliance malfunctions, or has been damaged in any manner. For service information see warranty page.

• The use of accessory attachments not recommended by Focus Electrics may cause fire, electric shock, or injury.

• Do not use this appliance outdoors.

• Do not let cord hang over the edge of the table or counter, or touch hot surfaces.

• Do not place on or near a hot gas or electric burner, or in a heated oven.

• Plug cord into wall outlet. To disconnect, turn any control to “OFF,” then remove

plug from wall outlet.

• Do not use appliance for other than intended use.

• Extreme caution must be used when moving an appliance containing hot oil or

other hot liquids.

• Do not attempt to repair this appliance yourself.

• A short power-supply cord is provided to reduce risks resulting from becoming

entangled in or tripping over a longer cord.

• Longer extension cords are available, but care must be exercised in their use. While use of an extension cord is not recommended, if you must use one, ensure that the marked electrical rating of the extension cord is equal to or greater than that of the appliance. If the plug is of the grounded type, the extension cord must be a grounding-type 3-wire cord. To avoid pulling, tripping or entanglement, position the extension cord so that it does not hang over the edge of the counter, table or other area where it can be pulled on by children or tripped over.

• This appliance has a polarized plug (one blade is wider than the other). To reduce the risk of electric shock, this plug is intended to fit into a polarized outlet only one way. If the plug does not fit fully into the outlet, reverse the plug. If it still does not fit, contact a qualified electrician. Do not attempt to modify the plug in any way.

Exterior Bowl

Syrup Bottle with

Auger

• Do not use an outlet or extension cord if the plug fits loosely or if the outlet or extension cord feels hot.

• Avoid contact with moving parts.

• Blades are sharp. Use extreme caution during assembly, while operating,

disassembly and cleaning.

• Do not use if blades are broken, cracked or loose.

• Do not leave appliance unattended while it is operating.

• Do not run this appliance continuously for more than 5 minutes as overheating

may occur. Allow motor to cool down before repeat usage.

• Do not run machine without ice in the auger as damage to appliance may occur.

• Never place fingers or utensils into the feed or discharge areas to reduce the

risk of severe injury to persons or damage to the shaver.

• Always check auger and exterior bowl for presence of foreign objects before using.

• For household use only.

SAVE THESE INSTRUCTIONS

Lid

Blade Switch Knob

Removable Cup Holder

EFORE USING FOR THE FIRST TIME

Please check all packaging material carefully before discarding. Many accessory parts are contained within the packaging material.

Hand-wash the cup holder, syrup bottles, syrup bottle lids and pumps, exterior bowl, and auger in warm, soapy water. Rinse and dry thoroughly. Do not wash any parts in a dishwasher. CAUTION: Be careful of shaving blades in exterior bowl as the blades are very sharp.

NEVER IMMERSE THE MOTOR BASE IN WATER OR ANY OTHER LIQUID.

Fill syrup bottles with Jelly Belly™ premium flavored syrups. Place lid with pump in syrup bottle and tighten lid by turning clockwise. Do not overtighten. Be sure you have an adequate supply of ice cubes.

Securing Nut

Syrup Bottle Holders

Pump Lid

Ice Shaver Body

SING YOUR ICE SHAVER

1. If using paper cone cups, push cup holder into opening on front of ice shaver housing. If using regular cups, do not attach cup holder.

2. Place filled syrup bottles into the syrup bottle holders located on the side of the Ice Shaver Housing. Note: Keep the pump spouts turned in toward the front of the appliance when not in use to prevent accidental dispensing of syrup.

3. Place the auger inside the exterior bowl. Lock the auger in place with the securing nut by turning nut clockwise.

4. Line up the two outside tabs of the exterior bowl assembly with the matching grooves on the Ice Shaver Housing. Push gently in place to secure.

5. Select 1 or 2 snow cones by turning the Blade Switch Knob located on the side of the exterior bowl.

6. Place paper cone cups in cup holder. If using regular cups, place cups under the shaving blades in the circular indentations in the drip tray to ensure correct placement.

7. Add ice cubes to auger.

8. Plug the Ice Shaver into a 120-volt AC electric outlet only.

9. Place the lid on top of the exterior bowl. Turn the lid counter-clockwise until the large extended lid tab engages the interlock switch. The motor will start and the ice will begin shaving.

10. To stop shaving ice, turn the lid clockwise to disengage the motor switch.

11. To dispense syrup, turn the pump spouts outward, away from the appliance. Place snow cone cup filled with shaved ice under the syrup dispenser spout and press down approximately 5 to 7 times. Note: The number of pumps depends on the amount of ice being used and the sweetness desired.

12. Turn the pump spouts toward the front of the appliance to secure. Note: syrup bottles may be removed from the ice shaver and stored separately in the refrigerator beween uses.

13. Unplug from power supply immediately after use. Note: There will always be a small amount of ice remaining in the exterior bowl after shaving. Discard the remaining ice.

CAUTION: Do not run ice shaver continuously for longer than 5 minutes as overheating may occur. Allow motor to cool down before repeat usage.

• A small amount of smoke and/or odor may occur upon use due to the

release of manufacturing oils – this is normal.

• Some minor expansion/contraction sounds may occur during use – this is

normal.

LEANING YOUR ICE SHAVER

1. Always unplug appliance before cleaning.

2. Hand wash parts in warm, soapy water. Rinse and dry thoroughly. CAUTION: Be extremely careful of shaving blades in exterior bowl as blades are very sharp. Note: Do not wash parts in a dishwasher.

3. Clean exterior of the appliance with a damp, soft cloth and wipe dry. Note: Do not immerse motor housing in water or other liquid.

NEVER ATTEMPT TO SHARPEN SHAVING BLADES AS INJURY MAY OCCUR.

OOL & EASY TREATS

Super Snow Cones – Shave ice directly into snow cone cups. Mound tops with

additional shaved ice if desired. Dispense your favorite Jelly Belly™ premium flavored syrup directly on top of the shaved ice. Combine different syrups to create your own unique flavors. Because the shaved ice is so fine, it absorbs the flavored syrup instead of letting it run to the bottom. This gives you a truly intense flavor sensation, all the way through! Tip: Use flavored ice cubes for unique snow cone tastes. Freeze fruit juice, soda, flavored yogurt, or flavored milk into cubes. Shave into cups. If desired, use Jelly Belly™ premium syrups for added flavor.

Slushes – Place shaved ice into serving cups or glasses. Add just enough Jelly Belly™ premium flavored syrup to totally absorb into the shaved ice. Try one of the following variations for a delicious, cool and refreshing treat. Garnish with sliced or diced fruit.

Soda – Use your favorite variety such as cola, root beer, and fruit flavors. Add a twist of lemon or lime for an added “burst” of flavor.

Fruit Juices – Natural flavorings that are both tasty and good for you. Try apple, grape, orange, grapefruit, and cranberry or any combination for a special treat.

Lemonade and Punch-Flavored Drinks – Cool and refreshing flavors are great for any occasion.

Rainbow Slush – A colorful and fun treat. Place a layer of shaved ice in the bottom of a tall, parfait style glass; add syrup flavor. Add a middle layer of ice; add a different syrup flavor. Add a top layer of ice and another syrup flavor. Garnish with fruit or paper umbrellas. A great party treat!

RODUCT WARRANTY

Appliance 1 Year Limited Warranty

Focus Electrics, LLC (“Focus Electrics”) warrants this appliance from failures in the material and workmanship for one (1) year from the date of original purchase with proof of purchase, provided the appliance is operated and maintained in conformity with the provided Instruction Manual. Any failed part of the appliance will be repaired or replaced without charge at Focus Electrics’ discretion. This warranty applies to indoor household use only.

This warranty does not cover any damage, including discoloration, to any non-stick surface of the appliance. This warranty is null and void, as determined solely by Focus Electrics if the appliance is damaged through accident, misuse, abuse, negligence, scratching, or if the appliance is altered in any way.

THIS WARRANTY IS IN LIEU OF ALL IMPLIED WARRANTIES, INCLUDING WARRANTIES OF MERCHANTABILITY, FITNESS FOR A PARTICULAR PURPOSE, PERFORMANCE, OR OTHERWISE, WHICH ARE HEREBY EXCLUDED. IN NO EVENT SHALL FOCUS ELECTRICS BE LIABLE FOR ANY DAMAGES, WHETHER DIRECT, INDIRECT, INCIDENTAL, FORSEEABLE, CONSEQUENTIAL, OR SPECIAL, ARISING OUT OF OR IN CONNECTION WITH THIS APPLIANCE.

If you think the appliance has failed or requires service within its warranty period, please contact the Focus Electrics Customer Service Department at (866) 290-1851, or e-mail us at service@focuselectrics.com. A receipt proving the original purchase date will be required for all warranty claims, hand written receipts are not accepted. You may also be required to return the appliance for inspection and evaluation. Return shipping costs are not refundable. Focus Electrics is not responsible for returns lost in transit.

Replacement parts, if available, may be ordered directly from Focus Electrics, LLC several ways. Order online at www.focuselectrics.com, e-mail service@focuselectrics.com, over the phone by calling (866)290-1851, or by writing to:

Focus Electrics, LLC Attn: Customer Service P. O. Box 2780 West Bend, WI 53095

To order with a check or money order, please first contact Customer Service for an order total. Mail your payment along with a letter stating the model or catalog number of your appliance, which can be found on the bottom or back of the unit, a description of the part or parts you are ordering, and the quantity you would like. Your check should be made payable to Focus Electrics, LLC.

Your state/province’s sales tax and a shipping fee will be added to your total charge. Please allow two weeks for processing and delivery.

This manual contains important and helpful information regarding the safe use and care of your new Focus Electrics product. For future reference, attach dated sales receipt for warranty proof of purchase and record the following information:

Date purchased or received as gift: _______________________________________________ Where purchased and price, if known: _____________________________________________ Item number and Date Code (shown bottom/back of product):___________________________

Valid only in USA and Canada

EPLACEMENT PARTS

L5824B 12/10 Focus Electrics, LLC. Printed in China

+ 14 hidden pages