
1
Index
Pag 2 Introduction
Pag 2 Warning
Pag 3 Description
Pag 4 Operating instructions
Pag 4 Specification
Pag 5 Cleaning process
Pag 6 Disposal of electronic devices
Pag 6 Smaltimento dei dispositivi elettronici
PACK CONTENTS
65ml universal cleaning
solution

2
INSTRODUCTION
Ultrasonic cleaner is on based of cavitation effect caused by high frequency
ultrasonic wave vibration signal in fluid. Microscopic bubble are formed and they
implode violenty that cause cavitation, which gives out great impact of the cleaning
subject and provides an intese scrubbing action on the surface of cleaning subject.
Additional, the bubbles are small enough to penetrate even microscopic crevices,
cleaning them thoroughly and consistley.
Observe and follow the operation manual
This instrument has been designed for the ultrasonic treatment of items in liquids
only. Don’t operate without liquids.
This product must be operated by qualified staff only.
Connect the unit to a grounded shockproof socket only!
Do not open the unit! Maintenance must be done by authorised personal only!
Use this product in a stable and dry work place!
Use only distilled water!
Pull the mains plug in case of any malfunctions!
Do not operate the unit with flammable cleaning media!
Do not put any acids or chlorides into the stainless-steel tank!
Do not place any items directly on the tank floor, but use the basket!
Do not reach inside the cleaning liquid or touch sound carrying parte (tank, basket,
cleaning items, etc.) during operation.
Ultrasonic cleaner unit can produce annoying sound.
Exclusion of liability; the manufacturer cannot be held liable for damages on
persons, equipment or cleaning items caused by improper use and non-observance
of the Operating Instructions. The operator is responsible for the instructions of the
operating staff.
For any queries please contact your supplier or the manufacturer

Open the lid, and fill the stainless steel tank with water
The item should be immerged well into the water. However,
do not exceed the “MAX-” mark.
Close the lid, and plug in.
Touch”SET” key and select from 5 optional working cycles
freely: 180s -> 280s -> 380s -> 480s -> 90s
Touch"ON"key to start cleaning,and the indication light is
on. The timer will be displayed on the screen.
When reach the time of “000”, the uni twill auto stop, the
light will turn off. If another cleaning is needed, just repeat
the above steps.During cleaning,if you want to stop, just
touch"OFF"key.Touch”ON”key again, the unit will
implement the remainder program to continue the
cleaning. Furthermore, you can touch “SET” key to return
working cycles
When cleaning process is finished, unplug it.
Ultrasonic
frequency
(kHz)
External size
(L x W x H) mm

5
CLEANING PROCESS
Please observe any national safety regulations that may apply in addition to the present instructions.
Observe the general safety warnings.
The operator is responsible for the control of the cleaning result.
Take the warming of the cleaning liquid into consideration when cleaning temperaturesensitive items.
Ultrasound can damage sensitive surfaces when operated over a prolonged period of
time and particularly when operated at low cleaning frequencies.
If required for the cleaning operation by hand, pre-heat the liquid (in units of heating).
Immerse the cleaning items into the cleaning liquid. Do not place any items or containers
directly onto the tank floor. Use either a cleaning basket, a becker (filled with water +
cleaning chemical) or hang the items into the liquid.
Set the cleaning time – switch on the ultrasound.
Monitor the cleaning process: Check the cleaning result by visual inspection. Repeat the
cleaning process if necessary.
Rinse the cleaned items after the cleaning and dry if necessary.

Caution! Pull the mains plug before you carry out any maintenance and care works! Do not put the unit under water!
For repair return the unit to your supplier or to the manufacturer.
Electrical safety: Regularly check the housing and the mains cable for damage to avoid electrical accidents.
Care of transducer tank: The deposits in the stainless-steel tank can be removed gently, e.g. by mild decalcifies. Do
not use any scouring media!
Care of housing: Depending on their kind contaminations can be removed with a mild household cleaner or decalcifier
(wipe with wet cloth).
Disinfection: If the unit is operated in the medical and sanitary sector it is necessary to disinfect the transducer tank
and the surfaces regularly for hygienic purposes (standard surface disinfectants).
DISPOSAL OF ELECTRONIC DEVICES
The electrical and electronic equipment marked with this symbol cannot be
disposed of in public landfills.
According to the UE Directive 2002/96/EC, the European users of electrical
and electronic equipment can return it to the dealer or manufacturer upon
purchase of a new one.
The illegal disposal of electrical and electronic equipment is punished with
an administrative fine.