Jebao RW4, RW8, RW20, WP25, RW15 User Manual

Wireless Controller for Wave Maker

User’s Manual

Matched Models, RW4/8/15/20 and WP10/25/40/60

Company：Jebao(Zhongshan)Electrical Appliance Co.Ltd

Address：Tongmao Industrial Park, Dongsheng Town, Zhongshan city.
Guangdong Pro. China

Tel.: [phone]/21 Fax: [phone]

E-Mail: [e-mail] Website: www.jebao.com

Jebao wave makers are intended to simulate the natural waves and
whirlpools found in a marine environment.
Before installing and using the controller, please read through these
instructions to familiarise yourself with the correct operation of the device.

Features:

1. Unique wireless multi- mode controller to allow adjustment of the
wave maker to suit the users requirements.

2. Use of low-voltage, low power, DC variable-speed pump for safe
operation.

3. Easy adjustment & operation.

4. Wireless communication with other Wireless Controllers

Installation Instructions:

1. Accessories: Intelligent controller, power adaptor, mains cable, double

sided tape, instruction manual.

2. Assembly: Remove one side of the double-sided tape and stick to the

rear of the controller. Remove the other side of the double-sided tape and
affix the controller in a suitable location.

3. Attach the 3-pin waterproof connector from the pump to the controller.

Then attach the DC plug to the controller. And attach the AC cable of the
adaptor.

Fig 1: assembly and operation

Fig. 1

Fig.2

III. Operation and Function

Functions:

MODE/NIGHT: Press the “MODE” button to cycle through the

different modes. Long press to enter into Night mode.
SPEED/FEED: Press the button to adjust the pump flow rate. Long

press to enter/exit the 10 minute feed mode.

Wi-Le/ LOCK: Press the button to set controller to Master /Slave or
independent mode (slaves are syncronised with “master controller”).

Lock the setting by long press of the button.
DIAL: Rotate the dial to adjust different wave periods and patterns in
W1 mode. Adjusts the flow speed in W2 and ELSE mode. Adjusts the
on/off time in mode C.

MASTER Control：Press “Wi-Le” once and enter into Master mode-
“Master” indicator light will be lit.
Master controller mode will operate all the functions for controllers set
to slave mode. In Slave mode, all operations are disabled except
adjusting flow rate by rotating the dial.

With two or more wave makers, set one as the Master and the others

as Slave. You can achieve the same function and operation for all the

pumps by adjusting only the Master controller.

Introduction of each mode