J Communications Co GMRS2200XTM Users Manual

3.2 Description of Icon

3.2.1 LCD ICON

1) VOX (Voice Activated Transmission) Indicator

- Appears when VOX is activated.

2) Auto Scan Indicator

- Icon appears when the Normal scan channel mode and Priority scan channel

mode is activated.

3) Alarm Indicator

- Appears when the alarm mode is on .

4) Weather Alert Indicator

- Appears when the Weather alert is selected .

5) Received Signal Strength Indicator

- Appears when carrier is detected in the two way mode .

6) Key Lock Indicator

- Appears when the key lock mode is activated.

-

7) Channel Position Indicator

CH - Appears when the two way mode is displayed.

8) CTCSS (Coded Tone Controlled Squelch System) Indicator
CODE - Appears when the two way mode is displayed.

9) Battery Level Indicator

- Icon indicates the battery charge strength with three level.

-

Data is not read and written when warning signal is listened and Icon is blink.

10) RF Po wer AUTO / LOW Indicator

< SETUP MANU >

PWR AUTO - In the use of default When the power on state.

(1~7CH,GMRS:2W /8~14CH,FRS:0.5W /15~22CH,GMRS:2W)

PWR LOW - In the use of Only 0.5W for manual.
(1~22CH,GMRS/FRS:0.5W )

3.2.2 Description of Button function

1. Power Button(1)

- To turn the Unit ON, press and hold the Power Button(1).

- To turn the Unit OFF, press and hold the Power Button(1) for more than 1, 2
second.

2. UP (5) or DOWN(6) Button

- Pressing the UP(5) or DOWN(6) Button in stand by mode, Volume is increased and
decreased.

- Pressing the UP(5) or DOWN(6) Button in Menu mode allow you to change the
setting of menu.

3. Mode(4) Button

- Pre ssing the Mode(4) Button allow you to change the mode.

- If you press the Mode(4) Button during approximately two second, Lock
function for menu button is operated and Key Lock Indicator is displayed in
LCD monitor.

- To release lock function, press and hold Mode(4) Button for more than 2
second.

4. Menu(2, 3) Button

- Pressing the Menu(2, 3) Button allow you to select next menu in f unction
edit mode.

But this Button function is different in Stopwatch mode. It’s functions are

Start/Stop/Clear.

5. PTT (Push-To -Talk) Button(8)

- Pressing the PTT Button(8), Voice signal is transfer to the other unit,
Red LED above LCD monitor(13) and Transmission icon(T) in LCD monitor(13)
is lighted.

- Removing your finger, the unit stops transmiss ion and return to the
receiving stand by mode.

- You can transmit a call signal and unit name by double I PTT Button(8)
Keying.
Unit name is changed in SETUP Mode.

6. Monitor Button (7)

- Pressing the Monitor Button(7) allow you to hear received signal in the
current channel.

- Pressing the Monitor Button(7) for more than 3 second allow you to hear beep
tone and received signal in the present channel continuously.

And Pressing the Monitor Button(7) releases the auto monitoring.

7. EXTERNAL Mic/Speaker(9)