1247000-GB_v1.0
This is a tabletop, installer code management tool for distributors. It is supplied with
software for PCs and a USB communications cable.
1
1247000-GB_v1.0
TECHNICAL DATA
Frequency 868,35MHz
Power supply USB
Power consumption < 100mA
Radiated power <25mW
Working temperature -20ºC - +85ºC
Watertightness IP20
Dimensions 120x56x38mm
FUNCTIONS:
- Read, save and erase the installer code in transmitters
- Read, save and erase the installer code in the MASTER
- Erase the installer code in receivers
- List allocated installer codes
MINIMUM REQUIREMENTS
· Pentium III
· Windows 98 SE (second edition)
· 64Mbytes RAM memory
· 25Mbytes free space on hard drive
· CD-ROM read unit
· USB port
INSTALLATION
Insert the CD-ROM in the corresponding PC unit.
Connect the USB cable to the programmer and the PC. A screen will open on the PC with
the message “Found New Hardware” and the Windows assistant for new hardware found
will autorun. Follow the instructions that appear on the screen. During hardware
installation, the assistant will ask you to select the USB driver route. You should select the
CDROM unit.
Then start the Soft-TRAINER setup application from the CD-ROM and follow the
instructions that will appear on screen.
PROGRAMMER ACTIVATION
When running the programme for the first time, you must enter the activation code, which
will be provided over the telephone by the manufacturer. If the programme is installed on
another PC, the code must be re-entered.
USE OF THE PROGRAMMER
Place the transmitter horizontally, with the pilot light facing the part indicated as the work
area (1).
The manufacturer reserves the right to modify equipment specifications without prior
notice.
* For further information, please read the help in the Soft- TRAINER programme.
2
1247000-GB_v1.0
EC DECLARATION OF CONFORMITY
The manufacturer
JCM TECHNOLOGIES, S.A.
C/Bisbe Morgades, 46 Baixos
08500 VIC – Barcelona
SPAIN
declares herewith that the product designated below complies with the relevant
fundamental requirements as per Article 3 of the R&TTE Directive 1999/5/EG, insofar as
the product is used correctly, and that the following standards apply:
Product: Programmer 868,35MHz
Manufactured by: JCM TECHNOLOGIES, S.A.
Trade mark: JCM
Type: TRAINER
Environment of use: Residential, commercial and light industry
Standards:
• Telecommunication EN 300 220-1 v1.3.1 (2000-09), EN 300 200-3 v1.1.1 (2000-
09)
• Electromagnetic Compatibility EN 301 489-3 v1.3.1 (2001- 11), EN 301 489-1
v1.3.1 (2001-09)
• Low Voltage EN 60730-1 (2000)
Vic, 10/02/04
JUAN CAPDEVILA MAS
General manager
3
Loading...