JCM RSEC3 User Manual

RSEC3

User’s Manual GB

Introduction

RADIOSENS system is designed for Fast doors and Flat-slat rolling shutters in an Industrial, Commercial or Residential environment.
RADIOSENS is an impact detection system installed at the principal edge of the door. It works detecting any obstacle before the
strength exceeds regulations limits and then inverting door movement.
RADIOSENS is a wireless system based on an RF transmitter and a receiver card plugged in the control panel which permanently
monitors the status of the transmitter programmed.
The RadioBand system is designed of domestic, commercial and industrial door applications where a safety edge is used.
The system complies with the EN ISO 13849-1 standard, category 2, PLc.

Technical data

Frequency Multifrequency system auto-adjustable 868 MHz
Memory RS3: 1 transmitter;

RB3: 6 transmitters (3 on closing, 3 on opening)
Standby / Operating consumption Max 90mA
Radiated power < 1mW
Size 82 x 190 x 40 mm
Range (in open field) 50 metres















1248099_Rev1.0RSEC3 Page1/4

Starting up

Mechanical installation

Connect the receiver to the control panel without power supply.

Memorizing transmitter into receiver

RS3 and RB3 systems are not compatible, so it cannot be stored in the same receiver.
In addition, a transmitter may be memorized only in one receiver.

Memorizing RS3

Receiver only keeps a RS3 transmitter in memory at the same time. This is stored always as security on closing.

PRESS RPROG PUSHBUTTON LED TURNS ON PRESS TRANSMITTER PROG ONE BEEP AND PROGRAMMED

PRESS RPROG PUSHBUTTON LED TURNS OFF AND END PROG

Memorizing RB3

The receiver can memorize up to 6 transmitters RB3 (3 for security on closing and 3 for security on opening).

Before memorizing, place the options selectors in the desired position. Any subsequent changes will entail reprogramming.
Press PROG button and keep pressed until desired mode selected. Then follow the steps above.

Memorizing of one safety transmitter (IN1 input)

Mode Configuration of transmitter memorizing in the receiver.

1 Safety edge activates relay 1 on the receiver ON OFF
2 Safety edge activates relay 2 on the receiver OFF ON
3 Safety edge activates the two relays 1 and 2 at the same time

Memorizing of two safety transmitters (IN1 and IN2 input)

Mode Configuration of transmitter memorizing in the receiver.

4 Safety edge in IN1 activates relay 1 and safety edge in IN2 activates relay 2

(with switch SW1: 2 to OFF, the IN2 input is not tested)

Note: If you change the options selectors and the sensitivity after memorizing the safety devices, you must return to memorize these
devices for the changes to take effect.

Led R1 Led R2

ON ON

Led R1 Led R2

Flashing Flashing

1248099_Rev1.0RSEC3 Page2/4