JCM RS3 TGL868 User Manual
RS3 TGL868
User’s Manual GB
Introduction
RADIOSENS system is designed for Fast doors and Flat-slat rolling shutters in an Industrial, Commercial or Residential environment.
RADIOSENS is an impact detection system installed at the principal edge of the door. It works detecting any obstacle before the
strength exceeds regulations limits and then inverting door movement.
RADIOSENS is a wireless system based on an RF transmitter and a receiver card plugged in the control panel which permanently
monitors the status of the transmitter programmed.
The system complies with the EN ISO 13849-1 standard, category 2, PLc.
Technical data
Frequency Multifrequency system auto-adjustable 868 MHz
Standby / Operating consumption 0,1 mA / 12mA
Radiated power < 1mW
Range (in open field) 50m
Battery life (approx.) See battery life table
1248100_Rev1.0RS3T868 Page1/3
Table
Manoeuvres / day
Battery life in days
Manoeuvre time (s)
3 180 230 300 370 420 450 470 475
5 130 170 250 330 380 430 460 470
10 (n.r.) 104 170 250 320 410 440 450
15 (n.r.) (n.r.) 125 200 275 375 425 435
20 (n.r.) (n.r.) (n.r.) 170 250 350 410 420
25 (n.r.) (n.r.) (n.r.) 145 220
30 (n.r.) (n.r.) (n.r.) (n.r.) 200 300 375 390
(n.r.) = not recommended
(guide values, not tested, with alkaline batteries and at an ambient temperature of 25ºC).
300 200 100 50 25 10 5 4
325
385 410
Starting up
Mechanical installation
Install the transmitter following the steps and recommendations below. Pass the cables through the holes indicated (only if you use
the lock connection or an external power supply).
Install the transmitter in a horizontal position, at the middle of the last slat (it must have a tolerance of minimum 2mm of
movement). Avoid placing metallic surfaces between the receiver and the transmitter.
It is recommended to use limit switches in the installation and to have them properly connected, or to assure that the door will
stop always at the same point. The speed of the door must be uniform.
Options and sensibility selectors must be set before programming. Any later change will have no effect.
SWIPE TO OPEN COVER REMOVE PLASTIC DRILL DOOR SWIPE TO CLOSE COVER
Memorizing transmitter into receiver
Receiver only keeps a RS3 transmitter in memory at the same time. This is memorized always as security on closing.
PRESS RPROG PUSHBUTTON LED TURNS ON PRESS TRANSMITTER PROG ONE BEEP AND PROGRAMMED
PRESS RPROG PUSHBUTTON LED TURNS OFF AND END PROG
1248100_Rev1.0RS3T868 Page2/3
Loading...