JCM Maestro User Manual

1246001-GB_v2.0

This is a tool which allows to insert in a wireless way an installer code into a transmitter.

TECHNICAL DATA

Frequency 868,35 MHz
Power supply 3Vdc CR2032
Power consumption 12 mA
Radiates power < 25mW
Working temperature -20ºC - + 55ºC

1

1246001-GB_v2.0

OPERATION

Place the MAESTRO and the transmitter that should be added an installer code on a non­metal surface so that their pilot lights are in front of each other and proceed as indicated
below.
Press simultaneously during 1 second both buttons on the MAESTRO. The pilot will light
up for 10 seconds. Within these 10 seconds you should press buttons 1 and 2 at the
same time on the transmitter to program. Blinking twice on the MAESTRO will indicate the
successful programming. At this moment the programming time on the MAESTRO will be
initialised again for 10 seconds.

LOW BATTERY INDICATION

The pilot light will flash during some seconds after pressing the transmitter.

EC DECLARATION OF CONFORMITY

The manufacturer
JCM TECHNOLOGIES, S.A.
C/Bisbe Morgades, 46 Baixos
08500 VIC – Barcelona
SPAIN

declares herewith that the product designated below complies with the relevant
fundamental requirements as per Article 3 of the R&TTE Directive 1999/5/EG, insofar as
the product is used correctly, and that the following standards apply:

Product: Transmitter programmer 868,35MHz
Manufactured by: JCM TECHNOLOGIES, S.A.
Trade mark: JCM
Type: MAESTRO
Environment of use: Residential, commercial and light industry

Standards:

- Telecommunication EN 300 220-1 v1.3.1 (2000-09) – EN 300 220-3 v1.1.1 (2000-

09)

- Electromagnetic Compatibility EN 301 489-3 v1.3.1 (2001-11) - EN 301 489-1 v1.3.1
(2001-09)

- Low Voltage EN 60730-1:2000

Vic, 10/02/04

JUAN CAPDEVILA MAS
General manager
A, B, CH, D, E, F, GB, GR, I, IRL, IS, L, NL, P

2