JCM Activa-Go User Manual

COD. 1247003-GB / 1.1

Power supply

12V dc (9Vdc-21Vdc)

Frequency

868,35MHz

Consumption standby / operating

14mA/36mA

Operating temperature

-20ºC to +85ºC

Watertightness

IP54 (with glands IP65)

Dimensions

82x190x40mm

Terminals

+ 12V dc supply

- 12V dc supply S / D0 Decoded signal output (DCS) D / D1 Decoded signal output (BUS-L)

ACTIVA-GO

This unit allows to enhance the receiver area and receiving points when a wider range is necessary (for MOTION and DCS receivers).

1. DESCRIPTION OF THE MOTHER BOARD

TECHNICAL CHARACTERISTICS

2. INSTALLATION AND CONNECTIONS

Attach the rear part of the chassis to the wall using the plugs and screws supplied. Pass the cables through the bottom of the receiver. Connect the power cables to the terminals marked in the mother board, as indicated. Mount the receiver front and pass the cables and the antenna through it.

COD. 1247003-GB / 1.1

RECEIVERS

TRANSMITTERS

DCS

MOTION

DCS

Manual programming

Programming via radio

Programming via programmer

Programming via PIN

ACTIVA-GO

3. COMPATIBILITY WITH PROGRAMMING MODES OF MOTION AND DCS RANGES

This unit allows to integrate MOTION line transmitters on an existing DCS equipped facility. The following tables show the compatibilities between the different programming modes depending on the different receivers and transmitters.

Note: To operate with an installer code: Bridge the PROG pins, the LED will turn ON. Activate the transmitter up to the point that the LED goes OFF and indicates that the installer code is inserted correctly.

4. GROUPS

Interfaces can be configured with a group (from 0 to 7) so that there is no interference when working near each other. Useful for working with the system FREE.

+ 1 hidden pages