J.Burrows JBGL310 Instruction Manual

Page 1
1
/4
Instruction Manual
J.Burrows A3 Paper Guillotine
JBGL310
Version: 201709
Read all instructions before use. Keep for future reference.
Paper Stop
Transparent Blade-guard
Handle
Page 2
2
/4
J.Burrows Guillotine
Model
JBGL310
Max. paper size
A3
Cutting length
460mm
Max cutting capacity
(80gsm paper)
8
Cutting table
380x460mm
Dimensions
510x450x60mm
Weight
3.60kgs
INSTRUCTION
Before starting to use this paper guillotine, install the handle by rotating as shown in
image below.
Place the guillotine on a stable flat surface. Lift the blade up to its maximum position.
Place the paper on the guillotine underneath the transparent blade-guard, and then
lower the blade.
Page 3
3
/4
Note: Place the paper into the position as shown in images below to start cutting
paper.
MAINTENANCE
Clean guillotine with a dry cloth. Never use solvents or water. To prolong the life
of the blade, it is recommended to regularly wipe it down with silicone fluid, liquid
Vaseline or other rust-preventative oil.
Should the blade loosen, follow the 2 below steps to tighten the blade:
[A] Use a screwdriver to dismantle the grey part as shown in the image below.
[B] Use a hex screwdriver to tighten the screw bolt with one hand, while using a
wrench to hold the nut in place with the other hand. See image below.
Page 4
4
/4
NOTE
When not in use, the guillotine blade should be placed down (in horizontal
position).
Using more than the recommended amount of paper could cause permanent
damage to the blade.
This product is intended for cutting of paper. Do not use the product for any
other purpose.
This product is not intended for use by children. Keep product out of reach of
children.
To avoid damage to the product:
Remove paper clips and staples from paper before cutting paper.
Do not expose product to humidity, water or other liquids.
During use, the protective black coating of the blade may wear off over time.
To avoid possible severe personal injury:
Always operate the product on a flat, level and steady surface to avoid
overturning.
Always operate the guillotine with the transparent blade-guard in place.
Never carry the guillotine by the blade.
Never carry the guillotine by the cutting handle.
Loading...