J.Burrows JB5TMTLSWE Assembly Instructions Manual

887W x 354D x 1826H mm

PARTS LIST

A. Posts (8)

B. Shelves (5)

C. Long Apron (10)

D

E. Plastic Floor
Protectors (8)

. Short Apron (10)

Assembly lnstructions for 5 Shelf Metal Shelving

Part No:JB5TMTLSWE

Important: Be sure to line up and match hole pattern
on all posts prior to assembly.

Place post upright, using cardboard or other safeguard
beneath post to protect floor. Insert tabs on long shelf
support apron into slots on post. Press on tabs with fingers
to guide into slots. Push down lightly to extend tabs
through slots. It is recommended that the bottom shelf
aprons be placed in the second and third slots from the
bottom. To ensure stability of the unit, do not place bottom
shelf aprons any higher than the sixth slot.

T

ool for assembly

1

2nd & 3rd slots

FOR SAFETY

2 people are recommended for assembly

BE CAREFUL of sharp edges when assembling.

DO NOT stand on this product or use as a ladder.

DO NOT alter this product in any manner that is

not intended. This may

cause product damage or

personal injury.

Position the product on a level surface.

The maximum loaded weight for each shelf is no more than 90kg. evenly
distributed.

When loading shelves please distribute items evenly with heaviest items
on the bottom shelf.

Fasten the unit to the wall whenever possible with proper fasteners

(not provided)

A

C

B

E

D

When moving assembled unit, always
handle by the lower half. Recheck all
apron tabs / slots being sure they are
securely seated.

Horizontal Assembly

First and second slots

reco

mmended

Optional Location

Second and third slots

recommended

Place shelves starting at the bottom as you
build each layer. Gently tap the top of the
shelf around each corner with a rubber
mallet until tabs are flush with slots.

Next, insert tabs of a short apron
into the front post, creating a
“tripod.” Then alternate insertion
of support aprons with posts.

2

3

lnside
View

Tabs

Tabs

Short Apron

Short Apron

Long Apron

Long Apron

Assembled
“Tripod”

This unit can be assembled upright (vertically) or side-by-side (horizontally).

4

5

A

B

C

D

Vertical Assembly

Optional Location

For vertical assembly the posts are attached using a shelf support apron at
the mid-level of the unit. To attach using the aprons, begin with a short apron.
First insert top apron tab into the bottom slot of the upper post section, as shown
in illustration A, and then insert the lower apron in the top slot of the lower
post section as shown in illustration B. Repeat this process at the other end of
the short apron. Insert a long apron by again inserting the lower tab into the top
slot of the lower post section and top apron tab into the bottom side of the upper
post section (illustrations C, D) If needed, the unattached end of the long apron
can be rested on the lower post section, joining of lower and upper post sections
using the aprons until all are installed.
When assembling your unit it is recommended that you place the top shelf aprons
in the first and second slots from the top.

To ensure

stability of the unit, do not place the top shelf aprons any lower than the

sixth slot. This applies to both vertical and horizontal assembly.

Fit the floor protectors
provided on the end of each leg.

For damaged or missing parts, please email [e-mail].