JBS Technologies OH 43952 User Manual

Creating A
Higher Standard
JBS Technologies produces the world's most innovative and reliable car alarms, remote starters, keyless entry systems and starter immobilizers.
JBS Technologies is not an importing or distribution company. Our products are designed with patented technology and produced in the United States with robotics to insure flawless performance and the highest quality control.
Look for our products and services on the world wide web where you'll find a highly trained support staff to provide assistance to get you on your way to a safer, more convenient driving experience.
INSTALLATION GUIDE
OWNER'S GUIDE
JBS Technologies
225 Technology Way Steubenville, OH 43952
Phone: 740-282-1212 Toll Free: 800-878-8007 Fax: 740-282-1201
www.jbstech.com
JBS TECHNOLOGIES
Creating A Higher Standard
Thank you for purchasing American made
products by JBS T echnologies.
To order additional transmitters or other
accessories, visit our
website at wwww.jbstech.com or contact
JBS T echnologies at
the following address:
JBS Technologies
225 Technology Way
Steubenville, OH 43952
FOR TECHNICAL ASSISTANCE
www.jbstech.com
1-800-878-8007
TO ORDER ACCESSORIES, CALL
1-800-659-0764
YOUR WARRANTY
Here's how your warranty works:
JBS Technologies warrants to the original customer, and the original car a limited lifetime warranty. Within 12 months of purchase, JBS Technologies will repair or replace, our option, any defective system at no charge. After 12 months from date of purchase, JBS Technologies will, at our option, repair or replace the system for a $20 shipping and handling fee.
Installation, labor, removal and reinstallation are not the responsibility of JBS Technologies. Registration must be completed and sent in within seven (7) days of purchase in order to validate the warranty. JBS Technologies makes no warranty against the theft of a vehicle or its contents. This warranty is not to be construed as an insurance policy against loss.
DISCLAIMER
JBS Technologies disclaims the warranty of merchantability and fitness for any particular use. This disclaimer shall be effective as to all claims of any kind made by or through any wholesaler, retailer, consumer or any other person or entity. Some states do not permit the disclaimer of implied warranties in some sales. Hence, this disclaimer may not apply to you.
LIMITATION OF REMEDIES
Consumer's remedy is limited to repair or replacement of the unit, and in no event shall exceed the purchase price. Incidental, consequential an/or indirect damages are expressly disclaimed. NO person or entity is authorized to alter, amend or increase this limited warranty.
WARRANTY VALIDATION
PLEASE FILL OUT THIS FORM AND MAIL IT IN TO REGISTER YOUR WARRANTY
Your Name ________________________________________ Address ________________________________________ ________________________________________ Email Address _________________________________ Dealer Name ____________________________________ Address ________________________________________ ________________________________________ Date of Purchase ___/___/___ Model # __________ Make/Model of Car ______________________________ Year of Car _____ V.I.N. # ____________________ Final Quality Check By _________________________
225 Technology Way • Steubenville, OH 43952
PROGRAMMING FUNCTIONS FOR YOUR WALLET OR GLOVE BOX
We urge you to immediately place this card in your wallet.
Adding Additional Remotes Press and hold brake. Next, press and hold Button #1 on the working remote until the parking lights flash once. Release. Press and release Button #4 on the new remote. The parking lights will flash three (3) times confirming that the new remote was learned. Cold Start On and Off (Degree Select) Press and hold brake. Press and hold Button #2 until the parking lights flash twice. Release. Press and hold Button #2. Each parking light flash is a progression in degrees. Flash #1 is -40ºF, flash #2 is -30ºF, flash #3 is -20ºF, flash #4 is -10ºF, flash #5 is 0ºF, flash #6 is +10ºF, flash #7 is +20ºF. Two quick parking light flashes is Cold Start Off. Release the brake, the parking lights will flash three (3) times. NOTE: Factory setting is OFF. Tach Mode - ON Press and hold brake. Press and hold Button #3, the parking lights will flash three (3) times. Release. Press and release Button #4, the parking lights will flash twice. The Tach Start is programmed ON. Release the brake, the parking lights will flash three (3) times. Tachless Mode - ON Press and hold brake. Press and hold Button #3, the parking lights will flash three (3) times. Release. Press and release Button #4, the parking lights will flash once. The Tachless Start is programmed ON. NOTE: Factory setting is Tachless Start ON. Release the brake, the parking lights will flash three (3) times.Programming Runtime with Brake not Pressed Press and hold Button #4. The parking lights will flash once for every five (5) minutes you want to program. Release button at desired runtime. Maximum length, 15 minutes.
26
Mail to: JBS Technologies
ATTENTION:
CONTENTS
System Features .......................... 4
System Components........................ 5
Required Tools ........................... 5
Technical Assistance .................... 5
Before You Begin....................... 5-6
Precautions .............................. 6
Testing Your Wires....................... 7
Making Connections .................... 7-8
Locating & Making Connections ....... 9-11
Neutral Safety Switch .................. 12
Connecting 18-Pin Harness.............. 13
Connecting 4-Relay Harness............. 13
Antenna Placement....................... 14
Anti-Theft System....................... 14
Optional Connections ................ 15-18
Operator Programming Instructions.. 18-19
How to use Your Remote Transmitter.... 20
Vehicle Anti-Theft Chart............ 21-24
FCC ID Notice ........................... 24
Important Functions ................. 25-26
Warranty Validation .................... 26
Your Warranty ........................... 27
Protected by one or more of the following patents:
Patent #08528768 Patent #5477090 Patent #55459447 Patent #5677664 Patent #60087174 Patent #60097821 Patent #5886622 Patent #5942988 Other patents pending.
RS700
3
REMOTE CONTROL STARTER
SYSTEM FEATURES
Four-Button Remotely start your car to run the heater or air Extended Range conditioning from an extended distance. Remote Control
Keyless Entry Remotely locks and unlocks your power door locks.
Trunk Release Remotely opens your trunk with a push of a
Remote Programmable Remotely program your vehicle to run 5 to 15 Run Time minutes.
Run Time Lets you check the run time that the unit is Confirmation programmed for.
Tach/Tachless A programmable feature that lets you choose from the Option easy to install tachless operation or the standard
Parking Light Confirms that your vehicle has received a remote Confirmation signal and will remain on if the engine is remotely
Dome Light Never walk up to a dark vehicle again. When unlocking Supervision the vehicles doors by remote control the dome light will come on and stay on for 1 minute, or until you activate the ignition
Cold Start Remotely program your car to start at a preset
Pit Stop Mode Allows you to exit the vehicle while the engine
Extended Range Allows you to operate your system from up to 400 feet Antenna away. (800 feet for E Models)
Code Learning Allows your remote starter to learn new remotes,
Limited Lifetime Guarantees life-long protection. Warranty
button. (Optional part #775 required)
wire-in, tach operation.
started.
switch. (Optional part #775 required)
temperature. Automatically starts your car in freezing temperature so you never have a dead battery.
remains running.
should you want to add remotes, or if remotes are lost.
1-800-878-8007
www.jbstech.com
MADE IN AMERICA, GUARANTEED FOREVER
OPERATING FUNCTIONS FOR YOUR WALLET OR GLOVE BOX
We urge you to immediately place this card in your wallet.
Starting with the Remote Transmitter Press and release button #1. The parking lights will flash once, confirming the car starter received the signal. The car will then start and the parking lights will remain on while the vehicle is running. To shut off the engine before the preset time, press button #4 or press the brake pedal. NOTE: If your car does not start on the first crank it will automatically attempt to start 2 more times (in tachless mode). While in tachless mode, parking lights will wait approximately 10 seconds before turning on. Pit Stop: Exiting the Car with the Engine Running Make sure the transmission is in park and press button #1 before turning the ignition switch off. Keyless Entry Operation Press button #2, the parking lights will flash once and the doors will lock. Press button #2 again, the parking lights will flash twice, the doors will unlock, and the parking lights will remain on for one minute or until you turn the ignition on or press the brake. Dome Light Option (optional) The dome light will remain on for one minute or until you turn the ignition on or press the brake. Trunk Release Output Optional output modules are available to do one of the following: open the trunk, roll up the windows, close the sun roof etc. This output will pulse .75 seconds when pressed and released. In instances where a continuous signal is needed such as sun roof and power windows, hold down button #3 as long as the signal is needed. The parking lights will remain on as long as this button is being pressed. Confirmation Press and release Button #4. The parking lights will begin to flash. Each flash equals 5 mnutes of runtime.
ATTENTION:
Runtime
4 25
VEHICLES WITH FACTORY ANTI-THEFT SYSTEMS (CONT.)
Manufacturer Make/ Year Anti-theft PONITAC BONNIEVILLE 89+ VATS
FIREBIRD 88+ VATS GRAND AM 96-98 PASSLOCK 1 GRAND AM 99+ PASSLOCK 2 GRAND PRIX 92-96 VATS MONTANA 99+ TRANSPONDER SUNFIRE 96-99 PASSLOCK 1
SUNFIRE 2000+ PASSLOCK 2 PORSCHE ALL 97+ TRANSPONDER SAAB ALL 97+ TRANSPONDER SATURN ALL 97+ FACTORY
2000+ TRANSPONDER TOYOTA AVALON 98+ TRANSPONDER
CAMRY 98+ TRANSPONDER
LAND CRUISER 98+ TRANSPONDER
SOLARIA 99+ TRANSPONDER
SUPRA 98+ TRANSPONDER VOLKSWAGON BEETLE 98+ TRANSPONDER
GOLF 98+ TRANSPONDER
PASSAT 98+ TRANSPONDER
VOLVO ALL 98+ TRANSPONDER
SYSTEM COMPONENTS
Your system includes: 1-Installation & Operation Guide 1-Main Control Module 1-Four Button Remote Transmitter
with Slide Protector 1-(4) Relay Harness with Relays 1-18-Pin Wire Harness 1-Hood Pin Switch 1-Extended Range Antenna (E Models Only)
2-Window Clips
(E Models Only)
1-Warranty 1-Warning Sticker for Under the Hood 2-Bulldog Window Decals
REQUIRED TOOLS
You will need a computer-friendly test light and a 5/16 inch drill bit when mounting the hood pin switch. In most cases no additional tools are required, however if the bottom of your dash on the driver’s side will come off you must remove it. In this case a screwdriver or socket set may be needed.
TECHNICAL ASSISTANCE
Should you need help. First check our website at www.jbstech.com or call our toll-free Tech Support Hotline Monday through Friday 9AM-8PM and Saturday 10AM-4PM EST at 800-878-8007.
You must give the following information:
• Name
• Telephone Number with Area Code (Fax number if applicable)
• Year, Make, and Model of the vehicle
• The model number of the system you are installing
• The type of assistance you are requesting
If you give the above information you will be called back as soon as possible, usually within 10 minutes.
BEFORE YOU BEGIN
Congratulations, you have purchased one of the most advanced remote starter systems ever made. Your new remote starter is a technological breakthrough utilizing the most advanced, state­of-the-art technology and components. It is computer controlled
FCC ID: J3STXJS1194
This device complies with part 15 of the FCC Rules, Operation is subject to the following two conditions: (1) This device may not cause harmful interference, and (2) This device must accept any interference received, including interference that may cause undesired operation.
24 5
and manufactured in the U.S.A. The dependability and variety of features make Bulldog Security the leader in the industry. Enjoy your new remote starter for years to come!
This remote system is designed to start your vehicle by sending a command signal from the remote transmitter or by programming automatic temperature or timed start. It is required that your installation be done in a well-ventilated area. It is the responsibility of the owner to ensure that the remote system is not used to start the vehicle in an undesired location.
Loading...
+ 9 hidden pages