Page 1
JBL Incorporated, 8500 Balboa Boulevard, P.O.Box 2200, Northridge, California 91329 U.S.A.
JBL VP7210/95DPC REV C
11-11
Technical Manual
JBL VP7212/95DPC
SPECIFICATIONS
ACOUSTIC & ELECTRICAL SPECIFICATIONS:
• Frequency Response: 65 Hz - 18 kHz (±3 dB)
• Frequency Range: 55 Hz - 20 kHz (–10 dB)
• Maximum Peak Output: 134 dB SPL 1m
• Coverage Pattern: 90º x 50°
• Directivity Factor (Q): 12.6
• Directivity Index (DL): 11 dB
TRANSDUCER SECTION:
• Cabinet: Enclosure (Not for Sale)
• Grille: 365659-001
• Low Frequency Driver: 2262FF, 304mm (12 in) dia., 76mm
(3 in) Dual Coil neodymium Differential
Drive
®
,
Direct Cooled
• Bandpass Nominal Impedance: 2 x 2 ohms
• High Frequency Driver: 2452H-SL, 100mm (4 in) titanium
damped diaphragm, 1.5 in exit,
• Bandpass Nominal Impedance: 8 Ohms
SYSTEM:
• DPC1 Internal Amplification 1750W Peak, 875W Continuous
Output (at nominal load):
• DPC1 Output: 750 LF/125 HF Watts (Continuous
IEC shaped pink noise into rated load
impedance)
• DPC1 Output Section: LF: Dual Bridged Technology™, Class D
HF: Bridged Class D
SYSTEM CONT’D:
• Audio Input Connector: XLR with loop-through
• User Controls: 80 Hz Subwoofer High Pass Filter.
Enable / Disable 0-16 dB input
Attenuator w/ 32 precision 0.5 dB steps
• Signal Processing: DSP based, resident in Input Module
• System Management: DSP based limiters for mechanical
and thermal protection
• AC Power Operating Range: 90-132 VA C/216-264 VAC, 50/60 Hz
• AC Line Voltage: 50/60 Hz, User Selectable;120V/240V
(-15%, +10%)
• AC Input Connector: Neutrik PowerCon (NAC 3MPA)
• AC Look-thru: Neutrik PowerCon (NAC 3MPB)
• AC Current Requirement: 6A per system at 120V, 3A/system at
240V
AURAL SWEEP TEST SPECIFICATIONS:
A.
System Aural Sweep Test:
150mV Input, 20 Hz to 20 kHz
Volume control clockwise
B. L.F. Aural Sweep Test: 7V Input, 10 Hz to 1 kHz
C. H.F. Aural Sweep Test: 2.5V Input, 300 Hz to 20 kHz
PHYSICAL SPECIFICATIONS:
• Enclosure Dimensions: 533 x 358 x 334 mm
(Height x Width x Depth) 21.0 x 14.1 x 13.1 in
• Net Weight: 47 lb (21.3 kg)
WARRANTY INFORMATION:
• Refer to Warranty Statement packed with each product.
Warranty 59660
Owners Manual
363642-003
Carton (1)
365664-001
Top/Bottom Set Filler (2)
365662-001
Face Pad Filler
365663-001
PKG, Microfoam (4)
49790P
Power Cord Assy Pack
355040-002
PACKAGE WIRING DIAGRAM
SCHEMATIC
Driver, Low Freq.
2262FF
(363946-001X)
Cone Repl
C2X2R2262
Wire Harness
363640-001
Driver, High Freq.
2452H-SL
(352328-003X)
Diaph Repl
D8R2452-SL
Yel/Blk
Yel
Blu/Blk
Grn
Blu
Grn/Blk
Page 2
Waveguide
338650-001
Gasket
351577-001
Screw (10)
804-41110-20
10-32 x 1 1/4
PAN,PH,BLK ZINC,
LCS
Low Freq, Driver
2452H-SL
(352328-003X)
Diaph Kit
D8R2452
Stud (4)
75815
#1/4-20 x 1.5 LG
Washer (4)
845-00110-08
#5/16 x .08
FLT PLREGBLK,
ZINC,CS
Nut (4)
834-30010-00
1/4-20 Keps
BLK ZINC, LCS,
RIGHT
Handle Assembly (2)
363366-001
Small
T-Nut (8)
61860
8-32x11/32
T-Nut (32)
61861
10-32x7/16
Step Barrel
Mounting Support (6)
381-00023-01
90 Degrees 2x M10
Screw (8)
883-41110-08
8 x 1/2
PAN,PH,PB,BLK
ZINC,LCS
Bolt (9)
352051-001
M10 x 25MM
HEX, BLK
Rear Mounting Bracket (2)
363926-001
Screw (4)
883-41110-08
8 x 1/2
PAN,PH,PB,
BLK ZINC,LCS
Amp Board
w/Modulator PCB
5009380
Input Board
5009382
Interface PCB
5009381
Screw (10)
804-51110-12
10-32 x 3/4
OVAL, PH, BLK
ZINC,LCS
Wire Harness
363640-001
Screw (2)
883-11100-08
8 x 1/2
FLT,PH, PB,CLR
ZINC, LCS
Amplifier T rim
363560-001
Screw (20)
803-51010-16
8-32 x 1
OVAL, PH,BLK
ZINC, LCS
Handle Backing
Plate (4)
363614-001
Screw (8)
883-11100-08
8 x 1/2
FLT,PH,PB,CLR
ZINC,LCS
T-Nut (4)
804-90003-00
1/4-20
Short Barrel
Pole Mount
365645-001
Screw (4)
806-61010-16
1/4-20 x 1
FLAT 100, PH,
BLK ZINC
Grille Support (2)
365653-001
Driver, Low Freq.
2262FF
(363946-001X)
Cone Repl
C2X2R2262
Gasket
339391-001
Rear 12”
Screw (8)
804-01110-16
10-32 X 1
FIL,PH, BLK ZINC,LCS
Dome
71646-001
Grille Assembly
365659-001
Screw (4)
804-51110-40
10-32 x 2 1/2
OVAL,PH,BLK ZINC,
LCS
COMPONENT EXPLODED VIEW
JBL VP7212/95DPC
JBL VP7212/95DPC
Enclosure Assembly
VP7212-95DCP
(Not Available for Sale)
Page 3
JBL VP7212/95DPC
AMPLIFIER ASSEMBLY
363679-006
JBL VP7212/95DPC
Amp Board
w/Modulator PCB
5009380
Input Board
5009382
Interface PCB
5009381
Crown Amp Logo Badge
362969-001
Input Label
364074-001
Top Label
365638-001
Knob,Volume,dbx
DPIP Horiz
355039-002
Warning Label
362965-001
Loading...