JBL N24AWII, N26AWII, N24II User Manual

SPEAKER PLACEMENT
Proper pbacement of the speakers variations will not diminish your is an important step in obtaining listening pleasure
the most realistic soundstage All of [he Nor[bridge Series
possible These recommenda_ loudspeakers referred to in this
tions are fel [he optimal guide are video-shielded (except
placement of the loudspeakers models N24AWIIand N26AWII)
ii_ Usethese placement recom_ andcan safely beplaced near a
AsFrontSpeakers
....... k
400 609
As Surround Speakers
Note:Model NSPlll includES four N2411speakers and one
N-CENTERIIspeake_ Fora
complete home theater speaker system, add a JBL powered
subwoofer to this model
Note for alt-wea_er models:While the N24AWJl
and N26AWJl are weather- resistant, they are not designed to beimmersed Jn
waten Be selective in your _[tJoor pJacemen[ Placing
thes_ speakers under roof eaves or a patio awnh]g
will offer some shelter and
help contribute to years of
t_ouble4_ee pel formance When installed outdoors,
the speakers should be angled down slighUy,using
the mounting brackets that are included wkh models
N2411and N24AWll
5 6f[
See your JBL dealer
for the optional brackets
(WBN26WHT) available
for model N26AWII
N24 N24AWn,N26AW ,
The N-CENTERIIcenter channel loudspeaker is designod to complement all of the
Northddge Series loudspeakers. It is the ideal way to re-create the
cinematic experience ifl _your home¸
The supplied self:adhesive telt pads may be attached to the bottom corners of your speakers to plotect your furniture¸
SPEAKER CONNECTIONS
Speakers and electronics termhlals have corresponding (+)
and (-) [erminals I[ is impor[ant to connec[ both speakers
identically: (+) on the speaker to (+) on the amplifier and -) on the
speake o ) ollthe amplifier Widng "out o[ phase" results in
thin sound, weak bass and a pool
stereo image.
WiththeadventofmultJchanne[ surroundsoundsystems,
conneedng all of [he speakers in
yoursystemwiththecolrect
polarity remains equally importan[
RIGHT LEFT
Receiver
SpeakerOutputs
in order to preserve the proper ambience and directionality of [he program material
Touse the binding-post speaker terminals, unscrew the colorod
collar uedl [he pass4hrough hole in the cenlel post is visible under
the collar Inse_t the bare end of the wire through this hole; then
screw the collar down until the connection is tight The hole in
the center of each collar is intended for use with banana-
type connec[o_ s
CENTER
2
Ilecei_,er
SpeakerOutputs
Ver[ical Horizontal
The Nor[hddge Series speaker models indicated above may be
watbmounted The customer is
responsible for proper selection and use of mounting hardware, available through hardware stores,
[o properly and safely wall-mount [he speakers This product is not intended for ceiling mounting. A_ustable walbmounting blackets
are included with models N2411 and N24AWfl. Optional, a_ustable,
TROUBLESHOOTING
If there is no soundfrom any of the speakers:
Check that rece[ver/a mplif[er is on and that a source is playing¸
Review proper operation of your receiver/amplifien
If there is no sound coming from one speaker:
Check the "Balance" control on your receiver/a mplifier
Check all wires and connections between receivel/amplifier
and speakers¸ Make sure I1o
Wires are touching other wires or tel minals and creating a sholt
circuit¸
Make sure all wires are connected¸ Make sure None of
[he speaker wires are flayed, cut or punctured¸
In Dolby _ Digital or DTS '¸¸modem make sure that [he receiver/
processor is configured so thai [he speaker in question is
enabled.
Turn off all electronics and switch the speaker in question
with one of [he other speakers [ha[ is working correctly. _um everything back on, and
determine whethel the problem [s [nthe same place, in, the speaker that was working pl eviously now has no sound and the speaker that was no[ working
now sounds fine; or whether it has moved, ie, the speaker that
was not working stiff has no sound and the speakel that was wol king is still fine If the problem isin the same place, the source of the problem is most likely with your recewer or amplifier, and you
should consult [he owner's manual for that product for furlher
informabon ]f the plobJem has followed the speaker, consult your
dealer for further assistance o_, if that is not possible, visit our Web
site at www:jbl corn for further
information
If the system plays at low volumesbut shuts off as volume
is increased:
Check all wires and connections between receiver/ampfifier and speakers¸
Make sure all wires are
connected¸ Make sure none of
the speakel wires are flayed, cut or punc[uled
wall-mounting brackets are available l_om JBL for model
N26AWll Contact .your deale_
or call 800-336-4JBLfor a dealer near you, and order model no
WBN26WHT
If more than one pak of main speakers is being used, check the
mirllmum impedance requirements
ofyour receiver/amplifiel
If there is no (or low) bass output:
Make sure the polaribes _ and -) of the Jeffand right
"Speaker Inputs" are connected properly.
Consider adding a powered subwoofor to your system
If there is no sound from the center speaker:
Check aft wires and connections between receiver/amplifier and speaken Make sure all wires are
connected. Make sure none of the speaker wires are frayed, cut
el punctured¸
If your receiver/processol is set in Dolby Pie Logic* mode, make sure [he center speaker is not in phantom mode¸
If your receiver/processol is set in Dolby Digital or DTS
mode, make sure [he receiver/ pl ocessor is configured so that
the center speaker is e_labled
N2411 N26AWll N-CENTERII
Description: 2-Way 4" bookshe[f_ 2-Way 6"booksheff, 2-Way dual 5"center
plastic plastic, weatheI-resistant
N24AWII
2-Way 4" bookshelf,
Maximum
plastic, weathePresistant
Recommended
Amplifier Powerff* 100W 125W 150W
Nominat
Impedance: 8 Ohms 8Ohms 8 Ohms
Sensitivity (2,83V/lm): 86dB 88dB 90dB
Frequency
Response(-3riB): 75Hz - 20kHz 55Hz- 20kHz 80Hz- 20kHz
Cr_sover
Frequency: 3000Hz 3000Hz 3500Hz
High-Frequency
Transducer: 3/4" Titaniumdaminate 3/4"Titanium laminato 314"Titanium-laminate
dome, shielded (not dome domer shielded shielded on modebN24AWg)
Low-Frequency
Transducer: 4" PolyP]as,TM shfelded 6"WeatherPlas _ Dual 5" PolyP]as,_ shfeided
(Model N24AWl] uses an unshie]ded WeatherPias TM woofer)
Finish: Dark gray (N2411) Offlwhite Dark gray
Off:white (N24AWg)
Grille Dolor: Gray cfeth (N2411) Off-white mesh Gray cloth
Dimensions
(H x Wx D): 9-1/2"x6-1/4"x4-3/4" 14-1/2_x 10-3/4"x 7-3/4" 6-1/2"x20-1/2"xS-1/2"
Off:white mesh (N24AWlI)
241mm x 15gmmx 368mmx 273mm x 165mmx 521mm x
121mm 197mm 216mm
Weight
Per Speaker: 45 Ib/21kg 83 Ib/3 8kg 10 Ib/4 6kg
*lrademarks of Dolby Laboratories
DTS is a registered trademark of Digital Theater Systems, Inc
**The maximum recommended amplifier power rating will ensure proper _stem
headroom to allow for occasional peaks¸ We do not recommend sustained operation at these maximum power levels¸
All features and specifications are subject to change without notice.
UB_PRO SOUND
COMES HOME"
JBL Cu_l_u_c f p_oduct_ 250 C_osswa_ _ar_ D_@ W{}ud_u_y _ 1§7
8500Balboa Boz_E_-w_dNor th_ dge CA 91329 80_336 4JBL 14525) (USA {_nly]
wwwjtllr{_m
JBL is a r_gi_te_ed _r a_t_n_T_ol JBL In_orlx)_at_d Part N(xai615_
N AHmTm_Inaeraoder_J_pm_
We _arman C_n_umerI_tern_ional
2 r_ute de T_ Rance
declare in_n re_pon_i_il_y__hat_hepr_ducm
L_cE G_da_
HarmanC_nsume_l_ter_a_i_nal
Loading...