JBL MTC-PC60 Installation Guide

Installation Instructions for Control 60 Series Panel Covers

MTC-PC60 (for Control 65P/T, 67P/T, 67HC/T and 60PS/T**)
MTC-PC62 (for Control 62P)

*** Before installing the cover, please make sure you have
selected the proper tap for your application ***
**For Control 60PS/T wire access holes must be custom drilled to suit**

1) Run cable(s) through cover and attach in-line Euro-

block connector(s) [included with the speaker] to
cable(s). (Do NOT use the rubber connector-cover
boot that comes with the speaker.)

4) Press cover through hanging bracket to secure firmly.

2) Plug in-line Euro-block connector(s) to chassis-mount

input connector(s) on speaker.

3) Center cover to hanging bracket and gently pull wire.
Do not pull with too much forc e – it can cause
disconnection.

5) Attach suspension cable to speaker’s suspe nsi on
bracket and hang pendant speaker assembly.

6) Test speaker for proper functioning. Then use silicone
glue or other outdoor-capable sealant: a) around
hanging bracket, b) on holes that are for input cables,
and c) around outside rim of panel cover. If only one
wire is used (as shown), be sure to seal other wire hole.

C60 PC Instr 101208