CS2104
CS2105
CS2106
CS2164
CS3108
CS3110
CS3196
CS4196
MULTIELEMENTS
OWNER’S MANUAL
www.jbl.com
The Official Brand of Live Music.
THANK YOU
for purchasing JBL CS Series
automotive speakers. We’ve
organized this manual to make
your installation as simple and
trouble-free as possible. Please
read it thoroughly before
proceeding. Remember to keep
your sales receipt and this manual
in a safe place so both are available
for future reference.
INSTALLATION WARNINGS AND TIPS
ABOUT THESE
INSTRUCTIONS
Installation of automotive stereo
components can require extensive
experience with a variety of
mechanical and electrical
procedures. Although these
instructions explain how to install
CS Series multielement speakers in
a general sense, they do not show
the exact installation methods for
your particular vehicle. If you do not
feel you have the experience, do not
attempt the installation yourself, but
instead ask your authorized JBL car
audio dealer about professional
installation options.
LOUD MUSIC
AND HEARING
Playing loud music in an automobile
can hinder your ability to hear traffic
as well as permanently damage
your hearing. The maximum volume
levels achievable with JBL
speakers, combined with high
power amplification, may exceed
safe levels for extended listening.
We recommend using low volume
levels when driving. JBL accepts
no liability for hearing loss, bodily
injury, or property damage as a result
of use or misuse of this product.
REAR DECK
PRECAUTION
In some cars, fuel tanks may be
located directly beneath the rear
deck. Before installation, make sure
there is adequate speaker basket
clearance before considering this
location!
INSTALLATION TIPS
• Always wear protective eyewear
when using any tools.
• Turn off all audio components and
other electrical devices before you
start. Disconnect the (–) negative
lead from your vehicle’s battery.
• Keep speakers in their package
until final installation. When moving
a speaker, always rest it with the
cone or dome facing up. Never use
force to install any speaker.
• Check clearances on both sides of
a planned mounting surface before
drilling any holes or installing any
screws. Remember that the screws
can extend behind the surface.
• At the installation sites, locate
and make a note of all fuel lines,
hydraulic brake lines, vacuum
lines and electrical wiring. Use
extreme caution when cutting or
drilling in and around these areas.
• Before drilling or cutting holes, use
a utility knife to remove unwanted
fabric or vinyl, to keep material
from snagging in a drill bit or saw.
• For door installations, check the
clearance with the windows
throughout the range of the
window’s travel, and verify that a
mounted speaker will not interfere
with the window crank or power
window mechanism.
• If mounting speakers elsewhere,
check for clearance around rear
deck torsion bars, glove box or
other structural elements.
• Do not mount speakers where they
will get wet.
2
INSTALLATION
Figure 1. Mounting the speaker
(except CS2164) using the supplied
grilles.
Figure 3. Mounting the CS2106
using the supplied grille.
Figure 5. Mounting the CS2106 in a
standard speaker location.
Figure 2. Mounting the CS2164.
NOTE: The CS2164 is designed to
be installed under a factory grille.
Consequently, no grilles are
packaged with this model.
Figure 4. Mounting the CS2106 in a
165mm speaker location.
NOTE: The CS2106 uses an
adaptor to fit a variety of different
6" openings. Select an appropriate
adaptor ring and secure it to the
vehicle using the sheet-metal
screws provided, then attach
the speaker to the ring with the
machine screws.
3
SPECIFICATIONS
Type 4" 5-1/4" 6-1/2" 4" x 6" 165mm 8" 10" 6" x 9" 6" x 9"
Speaker 4 ohms 4 ohms 4 ohms 4 ohms 4 ohms 4 ohms 4 ohms 4 ohms 4 ohms
Impedance
Power 90W Peak, 90W Peak, 120W Peak, 90W Peak, 120W Peak, 210W Peak, 270W Peak, 210W Peak, 210W Peak,
Handling 30W RMS 30W RMS 40W RMS 30W RMS 40W RMS 70W RMS 90W RMS 70W RMS 70W RMS
Sensitivity 90dB 91dB 91dB 90dB 91dB 91dB 92dB 91dB 91dB
(2.83V, 1m)
Frequency 85Hz – 20kHz 70Hz – 20kHz 55Hz – 20kHz 75Hz – 20kHz 55Hz – 20kHz 50Hz – 20kHz 45Hz – 20kHz 50Hz – 20kHz 50Hz – 21kHz
Response
Mounting 1-7/8" 2-1/4" 2" 1-11/16" 2-3/8" 3" 4-3/16" 3" 3"
Depth (48mm) 2-1/4" (51mm) (43mm) (61mm) (77mm) (107mm) (77mm) (77mm)
Cut-Out 3-5/8" 4-11/16" 5-1/8" 5-3/4" x 3-5/16" 5-11/16" 7-3/16" 9-3/16" 8-13/16" x 6" 8-13/16" x 6"
Diameter (91mm) (120mm) (131mm) (147mm x 85mm) (145mm) (183mm) (234mm) (224mm x 153mm) (224mm x 153mm)
GENERAL CARE
The loudspeaker grilles may be cleaned with a damp cloth. Do not use any cleaners or solvents on the grilles or the speaker cones.
A valid serial number is required for warranty coverage.
Features, specifications and appearance are subject to change without notice.
JBL Consumer Products
250 Crossways Park Drive, Woodbury, NY 11797 USA
516.255.4JBL (4525) www.jbl.com
© 2005 Harman International Industries, Incorporated. All rights reserved.
JBL and Harman International are trademarks of Harman International
Industries, Incorporated, registered in the United States and/or other countries.
Part No. CSMEOM7/05
CS2104 CS2105 CS2106 CS2164 CS2165 CS3108 CS3110 CS3196 CS4196
two-way two-way two-way two-way two-way three-way three-way three-way four-way
Declaration of Conformity
We, Harman Consumer Group International
2, route de Tours
72500 Chateau du Loir
France
declare in own responsibility that the products described in this owner’s
manual are in compliance with technical standards:
EN 61000-6-3:2001
EN 61000-6-1:2001
Klaus Lebherz
Harman Consumer Group International
Chateau du Loir, France 7/05
www.jbl.com
Loading...