Page 1
Installing Control 50S/T Subwoofer
Using Included Wall Bracket
CAUTION: Installation must be
done by qualied persons using
safe rigging standards
The installer is responsible for proper selection
and use of mounting hardware, to properly and
safely wall-mount the speakers
1. The Control 50S/T comes with the speaker plate of the wall
bracket pre-attached to the speaker. Ensure that that screws
holding this plate to the speaker are tight.
2. Run the wiring from the power amplier to the location
desired for mounting the JBL Control 50S/T subwoofer. Also
run the wiring that will connect the subwoofer to the Control
52 satellite speakers.
3. Using a level, secure the wall plate of the mounting
bracket to the wall. Be sure to use appropriate wall anchors
for attaching the bracket plate. Use all ve screw holes for
maximum integrity and safety.
.
.
4. Attach a safety cable (not included) to the 6 mm insert on
the back of the Control 50S/T cabinet using the included 6
mm screw. Prepare to attach the other end of the cable to a
secondary attachment point on the wall.
6 mm screw and insert point for
secondary safety cable
5. Position Control 50S/T subwoofer toward wall, in the
orientation shown, slightly higher than the on-wall plate, then
slide the Control 50S/T subwoofer downward while maintaining
pressure toward the wall until the two bracket plates engage.
Make sure the retaining spring latches securely into place.
(Tapping screws shown. Actual hardware and anchors
utilized may differ, depending on the requirements
of the wall material and structure. Secure and safe
attachment is the responsibility of the installer.)
6. Remove the input terminal cover, connect wiring and set
the tap selector rotary switch. Replace input terminal cover,
routing wires through the side opening, dressing the wiring
toward the the back side of the cabinet.
Page 2
Removing from Wall -- If there is a need to remove the
151 [6.0]
147 [5.8]
43 [1.7]
43 [1.7]33 [1.3]
64 [2.5]
58 [2.3]
10 [0.4]
6.4[0.25] dia (x5)
116 [4.5]
subwoofer, insert an object such as long-shaft screwdriver
from the top. Leverage the handle of the screwdriver away
from the wall in order to press the spring latch toward the wall
to disengage the latch. While maintaining pressure on the
latch in this manner, lift the subwoofer upward to remove it
from the wall bracket.
(viewed from top)
Wall Bracket Dimensions
JBL Professional
8500 Balboa Boulevard, P.O. Box 2200
Northridge, CA 91329 USA
C50 Inst 6/09
Loading...