JBL CONTROL 2.4G User Manual

English

CONTROL®2.4G

JBL®ON AIR

OWNER’S GUIDE

34199_Control_2_4G_Eng 02/08/07 14:07 Side 1

This equipment has been tested and found to comply with the limits for a Class B digital device, pursuant to Part 15 of the FCC Rules. These limits are designed to provide reasonable protection against harmful interference in a residential installation.

This equipment generates, uses and can radiate radio frequency energy and, if not installed and used in accordance with the instructions, may cause harmful interference to radio communications. However, there is no guarantee that interference will not occur in a particular installation. If this equipment does cause harmful interference to radio or television reception, which can be determined by turning the equipment off and on, the user is encouraged to try to correct the interference by one of the following measures:

• Reorient or relocate the receiving antenna.

• Increase the separation between the equipment and receiver.

• Connect the equipment into an outlet on a circuit different from that to which the receiver is connected.

• Consult the dealer or an experienced radio/TV technician for help.

FCC Caution: To assure continued compliance, any changes or modifications not expressly approved by the party responsible for compliance could void the user's authority to operate this equipment. (Example - use only shielded interface cables when connecting to computer or peripheral devices).

FCC Radiation Exposure Statement

This equipment complies with FCC RF radiation exposure limits set forth for an uncontrolled environment. This equipment should be installed and operated with a minimum distance of 20 centimeters between the radiator and your body.

This device complies with Part 15 of the FCC Rules. Operation is subject to the following two conditions: (1) This device may not cause harmful interference, and (2) This device must accept any interference received, including interference that may

cause undesired operation.

FEDERAL COMMUNICATIONS COMMISSION INTERFERENCE STATEMENT

Declaration of Conformity

We, Harman Consumer Group Inc.

2, route de Tours 72500 Chateau du Loir

France declare in own responsibility that the products described in this owner’s manual are in compliance with technical standards: EN 61000-6-3:2001 EN 61000-6-1:2001

Laurent Rault

Harman Consumer Group Inc.

Chateau du Loir, France 8/07

Declaration of Conformity

Laurent Rault

Harman Consumer Group Inc.

Chateau du Loir, France 8/07

We, Harman Consumer Group Inc.

2, route de Tours 72500 Chateau du Loir

France declare in own responsibility that the product described in this owner’s manual is

in compliance with technical

standards:

EN 55013:2001+A1:2003 EN 55020:2002+A1:2003 EN 61000-3-2:2000 EN 61000-3-3:1995+A1:2001 EN 60065:2002 EN 301489-1 V 1.6.1:2005 EN 301489-17 V 1.2.1:2003 EN 300328 V 1.6.1:2004

34199_Control_2_4G_Eng 02/08/07 14:07 Side 2

English

READ FIRST! Important Safety Precautions!

1. Read these instructions.

2. Keep these instructions.

3. Heed all warnings.

4. Follow all instructions.

5. Do not use this apparatus near water.

6. Clean only with a dry cloth.

7. Do not block any ventilation openings. Install in accordance with the manufacturer’s instructions.

8. Do not install near any heat sources such as radiators, heat registers, stoves or other apparatus (including amplifiers) that produce heat.

9. Do not defeat the safety purpose of the polarized or grounding-type plug. A polarized plug has two blades with one wider than the other. A grounding-type plug has two blades and a third grounding prong. The wide blade or the third prong is provided for your safety. If the provided plug does not fit into your outlet, consult an electrician for replacement of the obsolete outlet.

10. Protect the power cord from being walked on or pinched, particularly at plugs, convenience receptacles and the point where they exit from the apparatus.

11. Only use attachments/accessories specified by the manufacturer.

12. Use only with the cart, stand, tripod, bracket or table specified by the manufacturer or sold with the apparatus. When a cart is used, use caution when moving the cart/apparatus combination to avoid injury from tip-over.

13. Unplug this apparatus during lightning storms or when unused for long periods of time.

14. Refer all servicing to qualified service personnel. Servicing is required when the apparatus has been damaged in any way, such as power-supply cord or plug is damaged, liquid has been spilled or objects have fallen into the apparatus, the apparatus has been exposed to rain or moisture, does not operate normally, or has been dropped.

15. Do not use attachments not recommended by the product manufacturer, as they may cause hazards.

16. This product should be operated only from the type of power source indicated on the marking label. If you are not sure of the type of power supply to your home, consult your product dealer or local power company. For products intended to operate from battery power or other sources, refer to the operating instructions.

17. If an outside antenna or cable system is connected to the product, be sure the antenna or cable system is grounded so as to provide some protection against voltage surges and built-up static charges. Article 810 of the National Electrical Code, ANSI/ NFPA 70, provides information with regard to proper grounding of the mast and supporting structure, grounding of the leadin wire to an antenna discharge unit, size of grounding conductors, location of antennadischarge unit, connection to grounding electrodes, and requirements for the grounding electrode. See Figure A.

18. An outside antenna system should not be located in the vicinity of overhead power lines or other electric light or power circuits, or where it can fall into such power lines or circuits. When installing an outside antenna system, extreme care should be taken to keep from touching such power lines or circuits, as contact with them might be fatal.

19. Do not overload wall outlets, extension cords, or integral convenience receptacles, as this can result in a risk of fire or electric shock.

20. Never push objects of any kind into this product through openings, as they may touch dangerous voltage points or short-out parts, which could result in a fire or electric shock. Never spill liquid of any kind on the product.

21. The apparatus shall not be exposed to dripping or splashing, and no objects filled with liquids, such as vases, shall be placed on the apparatus.

22. Do not attempt to service this product yourself, as opening or removing covers may expose you to dangerous voltage or other hazards. Refer all servicing to qualified service personnel.

23. When replacement parts are required, be sure the service technician has used replacement parts specified by the manufacturer or that have the same characteristics as the original part. Unauthorized substitutions may result in fire, electric shock or other hazards.

24. Upon completion of any service or repairs to this product, ask the service technician to perform safety checks to determine that the product is in proper operating condition.

25. The product should be mounted to a wall or ceiling only as recommended by the manufacturer.

Figure A. Example of Antenna Grounding as per National ElectricalCode ANSI/NFPA 70

34199_Control_2_4G_Eng 02/08/07 14:07 Side 3

For more than 60 years, JBL has been involved in every aspect of music and film recording and reproduction, from live performances to the recordings you play in your home, car or office.

We’re confident that the JBL system you have chosen will provide every note of enjoyment that you expected – and that when you think about purchasing additional audio equipment for your home, car or office, you will once again choose JBL.

Please take a moment to register your product on our Web site at www.jbl.com. It enables us to keep you posted on our latest advance-ments, and helps us to better understand our customers and build products that meet their needs and expectations.

The JBL

On Air Control®2.4G is an advanced wireless loudspeaker system that allows you to enjoy your favorite music in remote locations around your home, or to add surround speakers to your home theater system without running wires to the back of the room. To ensure trouble-free performance, please carefully read these instructions completely before connecting or using the system.

UNPACKING THE SYSTEM

Carefully unpack the system. If you suspect damage from transit, report it immediately to your dealer and/or delivery service. Keep the shipping carton and packing materials for future use. Open the package and verify the following contents:

Included

1 x Transmitter module

1 x Universal power supply for transmitter 1 x 120V 2-Prong AC power cord for transmitter power supply 1 x 230V 2-Prong AC power cord for transmitter power supply 1 x Wall-mount bracket for transmitter with 2 x panhead

M3 x 4 machine screws for attaching wall-mount bracket to transmitter

4 x Small round self-adhesive feet – to be attached on transmitter left side panel if transmitter to be used vertically

1 x Active speaker/receiver (left-channel speaker)

1 x Universal power supply for active speaker/receiver 1 x 120V 3-Prong AC power cord for active speaker/receiver

power supply 1 x 230V 3-Prong AC power cord for active speaker/receiver

power supply 1 x Wall-mount holder for active speaker/receiver universal

power supply 1 x Passive speaker (right-channel speaker) 2 x Wall-mount rotatable brackets for active and passive speakers

(includes bar wrench and backup cords) 1 x Remote control 1 x Interconnect cable (1m/3.3 ft. RCA – RCA) 1 x Interconnect cable (1m/3.3 ft. RCA – 1/8-inch mini plug) 10m/33 ft. x Speaker wire 1 x Owner’s manual (multilanguage) 1 x USA warranty sheet

THANK YOU FOR CHOOSING JBL

Remote Control

Wireless Transmitter

Left/Active Speaker (Rear)

Right/Passive Speaker

INPUTMUTE

VOL

CODE

1234

TO RIGHT SPEAKER

+–

LEFT-CHANNEL SPEAKER

SUB-OUT LINE-IN

DC 20V

+–

RIGHT-CHANNEL SPEAKER

TO LEFT SPEAKER

CODE

1234

INPUT

34199_Control_2_4G_Eng 02/08/07 14:07 Side 4

+ 8 hidden pages