JBL CONTROL1X BLK, CONTROL 1X User Manual

CONTROL 1X
Personal-Size Monitor Loudspeaker
5 – 6 ft.
involved in every aspect of music and film recording and reproduction, from live performances to the recordings you play in your home, car or office.
We’re confident that the JBL loudspeakers you have chosen will provide every note of enjoyment that you expected – and that when you think about purchasing additional audio equipment for your home, car or office, you will once again choose JBL.
Please take a moment to complete the enclosed profile card. It enables us to keep you posted on our latest advancements, and helps us to better understand our customers and build products that meet their needs and expectations.
JBL Consumer Products
included
features
• Rugged, high-impact molded-plastic cabinet
• Video-shielded
• Optional adjustable wall­mount brackets available
one. Speaker Placement
As front speakers
As rear speakers
two. Speaker Connections
– +– +
Front or Rear Speaker Outputs
LEFT RIGHT
LEFT
RIGHT
+
+
connection tips
Speakers and electronics terminals have correspond­ing (+) and (–) terminals. It is important to connect both speakers identically: (+) on the speaker to (+) on
the amplifier and (–) on the speaker to (–) on the amplifier. Wiring “out of phase” results in thin sound, weak bass and a poor stereo image.
three. Wall-Mounting
The Control 1X loud­speakers may be wall­mounted. This product is not intended for ceiling mounting. Optional
adjustable wall-mount brackets are available from JBL. Contact your dealer or call 800-336-4JBL for a dealer near you.
Troubleshooting
A Harman International Company
If there is no sound from any of the speakers:
• Check that receiver/ amplifier is on and a source is playing.
• Review proper operation of your receiver/amplifier.
If there is no sound coming from one speaker:
• Check the “Balance” control on your receiver/ amplifier.
• Check all wires and con­nections between receiver/ amplifier and speakers.
• Make sure all wires are connected. Make sure none of the speaker wires are frayed, cut or punctured.
If the system plays at low volumes but shuts off as volume is increased:
• Check all wires and con­nections between receiver/ amplifier and speakers.
• Make sure all wires are connected. Make sure none of the speaker wires are frayed, cut or punctured.
Specifications
High-Frequency Driver 1/2" Titanium-laminate, shielded
Low-Frequency Driver 4", Shielded
Crossover Frequency 4,000Hz
Frequency Response 80Hz – 20kHz
Sensitivity 89dB
Nominal Impedance 8 Ohms
Recommended Amplifier Power Range 10 – 80 Watts
Dimensions (H x W x D) 9 x 6-1/16 x 5-7/16"
Weight (each) 5.2 lbs/2.4 kg
228 x 155 x 139mm
• If more than one pair of main speakers is being used, check the minimum imped­ance requirements of your receiver/amplifier.
If there is no (or low) bass output:
• Make sure the polarities (+ and –) of the left and right “Speaker Inputs” are connected properly.
Notice to Purchaser:
JBL assumes no responsibility or lia­bility for injuries or property damage – direct, indirect or consequential – resulting from the improper installa­tion of Control 1X loudspeakers.
Declaration of Conformity
We,JBL Europe A/S
Kongevejen 194B DK-3460 Birkerød DENMARK
declare in own responsibility, that the product described in this owner’s manual is in compliance with technical standards: EN 50081-1:1992 EN 50082-1:1992
Steen Michaelsen
Birkerød. DENMARK. 8/99
JBL Europe A/S
JBL Consumer Products 250 Crossways Park Drive, Woodbury, NY 11797 8500 Balboa Boulevard, Northridge, CA 91329 1-800-336-4JBL (4525) (USA only) www.jbl.com
©1999 JBL, Incorporated.
JBL is a registered trademark of JBL, Incorporated.
8/99 Part No. 1111-CTRL1XOM
Loading...