Control
Professional Series
Key Features:
䉴
High impact, 150 Watt direct radiating
pendant subwoofer with built-in passive
crossover for up to four satellite speakers.
䉴
200 mm (8 in) long-excursion driver.
䉴
8 ohm (150 Watt) and 70V/100V (100 Watt)
operation.
䉴
Hanging hardware with 4.5 m (15 foot)
galvanized steel cable and easy to adjust
clamp.
䉴
Stylish design, available in black or
white (-WH).
䉴
UL listed (speaker and hanging cable
system).
Applications:
The Control 60PS/T pendant subwoofer
loudspeaker provides bass extension and high
impact for high-fidelity sound systems in a
wide variety of applications including
restaurants, retail stores, music cafes, health
clubs, theme bars, leisure venues, and other
locations where full-range high fidelity
foreground/background music systems are
utilized. Featuring 150 Watt power handling
and low distortion, the long-excursion 200 mm
(8 in) low frequency driver features butyl
rubber surround for well-damped, tight sound
quality and long-term reliability, and a
polypropylene-coated cone for humidity
protection. The high-temperature 50 mm (2 in)
voice coil and low-mass fiberglass coil former
ensure good bass transient response and
excellent stability under high power, high dutycycle, working conditions.
The Control 60PS/T may be driven by itself
(or with other subwoofers) on an amplifier
channel, sending it either a signal that has
been actively low-passed earlier in the signal
chain via DSP or a full-range signal, utilizing
the built-in passive 125 Hz low-pass filter. The
included passive crossover also provides highpassed satellite outputs for use with either two
or four satellite loudspeakers (not for one or
three satellite speakers), resulting in a fullrange, wide-bandwidth, passively-crossed,
mono subwoofer-satellite system. Using the
built-in passive crossover is best suited for
satellite speakers with sensitivities in the 82 dB
to 86 dB (2.83V @ 1m) range, resulting in a
well-balanced overall frequency response.
A 100 Watt multi-tap, wide-bandwidth, lowsaturation transformer allows the speaker to be
used on either a 70V/100V distributed speaker
system or as a direct low-impedance 8⍀
speaker. If satellite speakers are used on the
70V/100V settings, the satellite speakers should
be low-impedance (8⍀ to 16⍀ each).
A loop out connector is provided on the
subwoofer for looping the full-range input
signal to other loudspeakers or to other
subwoofer/satellite systems. Rubber boot
covers for each locking connector protect the
terminals and the optional MTC-PC60 full-top
cover accessory adds additional terminal
protection for when using outdoors.
®
Pendant Subwoofer
60PS/T
with Crossover
Specifications:
System:
Transducer: 200mm (8 in) polypropylene-coated paper cone with butyl rubber
Enclosure:
1
Full-space (suspended)
2
Continuous Pink Noise rating is IEC-shaped pink noise with a 6 dB crest factor for 100 hours continuously. Continuous
Program power is conservative expression of the system’s ability to handle normal speech and music program material,
and is defined as 3 dB above the Continuous Pink Noise Rating.
JBL continually engages in research related to product improvement. Changes introduced into existing products without
notice are an expression of that philosophy.
Frequency Range (-10 dB)1: 42 Hz – 350 Hz
Frequency Response (± 3 dB)1: 55 Hz – 125 Hz
Nominal Sensitivity (2.83V/1m): 88 dB
Subwoofer-Satellite Hookup: For either two or four satellite speakers (not for one or three satellite
Power Capacity2: 300 Watts Continuous Program Power, 100 hrs
Rated Maximum SPL: 107 dB @ 1 m (3.3 ft) average, 113 dB peak
Rated Impedance: 8 ohms
Transformer Taps: 110W, 55W, 30W (& 15W@70V). Set via rotary tap-selector switch
Transformer Insertion Loss: 0.98 dB @ 15W, 0.99 dB @ 30W, 0.94 dB @ 55W, 1.10 @ 110W
Standalone Hookup: Connect to Input connector; built-in low-pass filter permanently engaged.
Enclosure Material: High impact polystyrene
Environmental: Exceeds Mil Spec 810 for humidity, salt spray, temperature & UV. IP44
Termination: Six removable locking 2-pin connectors with screw-down terminals.
Suspension: Two identical suspension cable systems (one as main suspension cable
Safety Agency: Speaker listed per UL1480 (UEAY), transformer registered per UL1876. In
Dimensions: 333 mm (13.1 in) diameter, 344 mm (13.6 in) height to top of cabinet.
Net Weight: 7.6 kg (16.7 lb)
Shipping Weight: 17.6 kg (38.7 lbs) per pair-packed carton
Included Accessories: Two suspension cable systems (see “suspension”, above), six removable
Optional Accessories: MTC-PC60 full top panel / terminal cover. Wire access holes in plastic
150 Watts Continuous Pink Noise, 100 hrs
(70V/100V taps along with direct 8⍀ setting) on top terminal panel
Loop Out in parallel with Input connector (pre low-pass filter) for
sending to additional speakers.
speakers). With two satellite speakers, must connect to Sat 1 and Sat 2
terminals only (NC to Sat 3 and Sat 4 terminals). Satellite outputs highpassed. Suggested satellite speakers include Control 62P (pendant),
Control 52 (surface-mount on-wall) and Control 42C (in-ceiling). Satellite
speakers to be low-Z type (8 to 16⍀) regardless whether tap selector is
set to low-Z or 70V/100V. Loop Out in parallel with Input connector (pre
low-pass filter) for sending to additional speakers.
surround, 50 mm (2 in) high-temperature copper voice coil, vented
fiberglass resin voice coil former.
Grille: Zinc-plated steel grille with powder-coat finish, foam backing (grille and
grille backing are removable for painting)
capability per IEC 529 – splash-proof rating
Input, Loop Out, Sat 1, Sat 2, Sat 3, Sat 4. Max wire 12 AWG (2.5 mm2).
Rubber terminal covers included.
and the other as safety cable), each consisting of 4.5 m (15 ft) long, 2
mm (0.077 in) high-tensile galvanized-steel wire rope suspension cable
with spring-clips for clipping onto the loudspeaker bracket and Gripple™
brand adjustable-height cable fasteners for infinitely adjustable height.
Cable has SWL rating of 45 kg (99 lb).
accordance with IEC60849/EN60849. Suspension system and Gripple®brand cable fastener listed per UL1598 and UL2239, TUV, and CSA Class
3426-01 & Class 3426-81.
369 mm (14.5 in) to top of suspension bracket.
locking 2-pin euro-block connectors, six rubber cover boots for euroblock connectors.
cover to be drilled by installer to suit the number and dimensions of
wire.
Colors: Available in black or white (-WH). Paintable.
䉴 Control 60PS/T 8” Pendant Sub-Woofer with Crossover
370
[14.6]
343
[13.5]
Ø3 3 3
[Ø13.1]
Frequency Response:
Full Space (4), suspended
100
90
80
70
60
20 100 1000 10000 20000
Frequency (Hz)
Dimensions:
Impedance:
100
10
Impedance (Ohms)
1
20 100 1000 10000 20000
Using 2 Control 62P
Satellite Loudspeakers
-
+
Frequency (Hz)
-
-
-
IN
-
+
+
Sat 3
Sat 4
-
+
+
Sat 1
Sat 2
-
+
+
Loop
IN
Thru
+
-
Dimensions in mm (in)
-
From Power Amplifier
+
Using Four Control 62P
Satellite Loudspeakers
-
+
-
+
-
+
From Power Amplifier
-
-
Sat 3
-
Sat 1
-
IN
+
+
Sat 4
-
+
+
Sat 2
-
+
+
Loop
IN
Thru
+
-
+
-
JBL Professional
8500 Balboa Boulevard, P.O. Box 2200
Northridge, California 91329 U.S.A.
© Copyright 2014 JBL Professional
www.jblpro.com
SS C60PST
CRP
05/14