JBL AP-2A, AP-1A Reference Manual

Reference Guide

AP

SOLDERING FEED

STATION

www.jbctools.com

2

AP/SOLDERING FEED STATION

CONTROL UNIT

AP-2A

TOOL

AP-A

Connectable tools: AP

CONTENTS

INSTALLATION / I.E.CONNECTION

Cartridge C130

Reference Guide

WORK

220

time

SLEEP

220

time

HIBERNATION

room

temperature

JBC stations intelligently manage the tool temperature:

Work mode: When the tool is used, pre-set work temperature is 350º C.
Sleep mode: When the tool is in the stand, the temperature goes down to 220º C.

Hibernation mode: After longer periods of inactivity (pre-set i.e 30 minutes), the power is cut off and

the tool cools down to room temperature.

The advantage of this heat management is lifespan increase which ensure low cost of ownership.

HEAT MANAGEMENT

AP

SOLDERING FEED

STATION

350O C ACTUAL T.

TOOL: T245/AP

ORIGINAL PIN: 0105

SELECT

CHANGE STATION
PARAMETERS S

Language?
ENGLISH S

Tool Select
DS-A S

Total Hours
xxxxx S

Temperature Unit

CELSIUS/FAHRENHEIT S

Fix Temp. Levels
OFF/ON S

Work Hours
xxxxx S

Max. T= [400oC]
Min. T= 90oC S

Sleep Dealy Time
x MINUTES S

Sleep Hours
xxxxx S

Max. T= [400oC]
Min. T= [ 90oC] S

Sleep Temperat.
x oC/oF S

Hibern. Hours
xxxxx S

Change PIN

YES/NO

Hibernation
x MINUTES S

Sleep Cycles
xxxxx S

Temperat. Adjust
+/- xx oC/oF S

Save Changes?
YES/NO S

Save Changes?
YES/NO S

CHANGE TOOL
PARAMETERS S

COUNTERS READ

S
RESET PARAMETERS

S

EXIT SETUP

S

S

SELECT key 2 seconds

to enter Menu

3

WORKING

SETTINGS

Decrease & move down

Selection

Increase & move up

Selected temperature

Working tool model

ENGLISH / WARRANTY

The JBC 2 years warranty, guarantees this equipment against all
manufacturing defects, covering the replacement of defective parts
and all necessary labour.

Warranty does not cover product wear due to use or mis-use.
In order for the warranty to be valid, equipment must be returned,

postage paid, to the dealer where it was purchased enclosing this,
fully filled in, sheet.

SERIAL N`

STAMP OF DEALER

DATE OF PURCHASE

0008803/0310

TECHNICAL SPECIFICATIONS

- Temperature selection from 90 to 450°C (±5%).

- Power: 75W.

- Safety transformer, mains separator and double isolation, with integrated temperature protection fuse.

- AP-2A 230V control unit. Input: 230V 50Hz. Output: 24V.

- AP-1A 120V control unit. Input: 120V 60Hz. Output: 24V.

- Total weight of unit: 2.5Kg.

- Complies with CE standards on electrical safety, electromagnetic compatibility and ESD protected housing
“skin effect”.

- RoHS compliant.

- Equipotential connector and the tool tip are connected to station mains ground supply for ESD protection.

This product should not be
thrown in the garbage.

MORE INFORMATION

www.jbctools.com