5628
Ultra-Long-Excursion, High Power, Dual 460 mm (18 in) Cinema Subwoofer
SPECSHEET
Key Features:
• 2 x 2269H 18” Differential Drive® dual voice coil, dual gap, neodymium magnet
transducers
• 2000 W AES 2-hour power rating at 4 ohms
• Ultra-long excursion capability
• Large vent area for high output with low distortion
Description:
The 5628 is a high power, lightweight, front-loaded, vented subwoofer enclosure housing two of JBL’s exclusive 2269H ultra-long excursion 18”
Differential Drive® woofers. The 2269H woofer features a neodymium magnet, dual voice coils, JBL’s exclusive Vented Gap Cooling™ and an ultra-
robust composite cone for high excursion and extra-long life. The woofer is capable of a peak-to-peak maximum excursion of 89 mm (3.5”). The
enclosure is constructed of dense stock and is extensively braced on all panels.
Specifications:
System
Frequency Range (-10 dB) 2 pi: 18 Hz – 1.63 kHz
Frequency Response (± 3 dB) 2 pi: 24 Hz – 155 Hz
Input Modes Drivers, Discrete
Power Handling
(AES 100-Hour Rating)
Power Handling
(AES 2-Hour Rating)
Maximum Continuous Output
Free-Field Sensitivity 95 dB (1 W/1m), ref 2.0 V
Half-Field Sensitivity 101 dB (1 W/1m), ref 2.0 V
Maximum Peak Output 140.5 dB SPL (1m)
Nominal Impedance 4 ohms (in parallel)
Minimum Impedance 3 ohms (in parallel) @ 27.4Hz
2
2
Transducers
Low Frequency Transducers 2 x 2269H; 460 mm (18 in) diameter; 100 mm
4 pi: 19 Hz – 1.75 kHz
4 pi: 27 Hz – 1.5 kHz
800 W @ 8 ohms, 1600 W @ 4 ohms (80 Vrms),
IEC/pink
1000 W @ 8 ohms, 2000 W @ 4 ohms (89 Vrms),
IEC/pink
3
134.5 dB SPL (1m)
(2x) 8 ohms in (discrete drive)
(2x) 6 ohms (discrete drive)
(4 in) dual-coil, dual-gap neodymium Differential
Drive® VGC™ drivers
Physical
Enclosure 19 mm (0.75 in) particle board with 25 mm (1 in)
Input Connector (2x) +/-Push Terminals for up to 12 AWG wire
Dimensions (H x W x D)
(Vertical Cabinet Orientation)
Net Weight 90.5 kg (199 lb)
Shipping Weight 99.5 kg (219 lb)
1
AES standard, one decade pink noise with 6 dB crest factor within device’s
operational band, free air. Standard AES 2-hr rating plus long-term 100-hr rating are
specified for low-frequency transducers.
2
Calculated based on power rating and sensitivity, exclusive of power compression.
JBL continually engages in research related to product improvement. Some materials,
production methods and design refinements are introduced into existing products
without notice as a routine expression of that philosophy. For this reason, any current
JBL product may differ in some respect from its published description, but will always
equal or exceed the original design specifications unless otherwise stated.
baffle and back panel; extensive bracing on all
panels
762 x 1219 x 610 mm
(30.0 x 48.0 x 24.0 in)
Note: specifications are subject to change without notice. 12/2018. © 2018 Harman International. www.jblpro.com
5628
Electrical Input Impedance (parallel mode)
Frequency response is measured on-axis at a distance referenced to 1 watt (2.0 Vrms) input @ 1 m;
measured in half-space (2
Ultra-Long-Excursion, High Power, Dual 460 mm (18 in) Cinema Subwoofer
SPECSHEET
Dimensions:
Dimensions inches (mm)
Graphs:
π, dotted line) and full-space (4 π, solid line) environments.
110
100
90
SPL (dB)
80
70
20 100 1000 10000 20000
100
10
Impedance (Ohms)
1
20 100 1000 10000 20000
Frequency (Hz)