JBL 2.4G AW User Manual

JBL®ON AIR

CONTROL®2.4G AW (230V)

OWNER’S GUIDE

English

FEDERAL COMMUNICATIONS COMMISSION INTERFERENCE STATEMENT

This equipment has been tested and found to comply with the limits for a Class B digital device, pursuant to Part 15 of the FCC Rules. These limits are designed to provide reasonable protection against harmful interference in a residential installation.

This equipment generates, uses and can radiate radio frequency energy and, if not installed and used in accordance with the instructions, may cause harmful interference to radio communications. However, there is no guarantee that interference will not occur in a particular installation. If this equipment does cause harmful interference to radio or television reception, which can be determined by turning the equipment off and on, the user is encouraged to try to correct the interference by one of the following measures:

• Reorient or relocate the receiving antenna.

• Increase the separation between the equipment and receiver.

• Connect the equipment into an outlet on a circuit different from that to which the receiver is connected.

• Consult the dealer or an experienced radio/TV technician for help.

FCC Caution: To assure continued compliance, any changes or modifications not expressly approved by the party responsible for compliance could void the user's authority to operate this equipment. (Example - use only shielded interface cables when connecting to computer or peripheral devices).

FCC Radiation Exposure Statement

This equipment complies with FCC RF radiation exposure limits set forth for an uncontrolled environment. This equipment should be installed and operated with a minimum distance of 20 centimeters between the radiator and your body.

This device complies with Part 15 of the FCC Rules. Operation is subject to the following two conditions: (1) This device may not cause harmful interference, and (2) This device must accept any interference received, including interference that may

cause undesired operation.

We, Harman Consumer Group Inc.

2, route de Tours 72500 Chateau du Loir

France declare in own responsibility that the products described in this owner’s manual are in compliance with technical standards: EN 61000-6-3:2001 EN 61000-6-1:2001

Declaration of Conformity

We, Harman Consumer Group Inc.

2, route de Tours 72500 Chateau du Loir

France declare in own responsibility that the product described in this owner’s manual is standards:

EN 55013:2001+A1:2003 EN 55020:2002+A1:2003 EN 61000-3-2:2000 EN 61000-3-3:1995+A1:2001 EN 60065:2002 EN 301489-1 V 1.6.1:2005 EN 301489-17 V 1.2.1:2003 EN 300328 V 1.6.1:2004

in compliance with technical

Laurent Rault

Harman Consumer Group Inc.

Chateau du Loir, France 6/08

Laurent Rault

Harman Consumer Group Inc.

Chateau du Loir, France 6/08

IMPORTANT SAFETY INSTRUCTIONS

13. Unplug this apparatus during lightning storms or when unused for long periods of time.

14. Refer all servicing to qualified service personnel. Servicing is required when the apparatus has been damaged in any way, such as power-supply cord or plug is damaged, liquid has been spilled or objects have fallen into the apparatus, the apparatus has been exposed to rain or moisture, does not operate normally, or has been dropped.

Do not expose this apparatus to

15.

dripping or splashing and ensure that no objects filled with liquids, such as vases, are placed on the apparatus.

16. To completely disconnect this

apparatus from the AC Mains, disconnect the power supply cord plug from the AC receptacle.

17. The mains plug of the power supply

cord shall remain readily operable.

18. Do not expose batteries to excessive

1. Read these instructions.

2. Keep these instructions.

3. Heed all warnings.

4. Follow all instructions.

5. Do not use this apparatus near water.

6. Clean only with a dry cloth.

7. Do not block any ventilation openings. Install in accordance with the manufacturer’s instructions.

8. Do not install near any heat sources such as radiators, heat registers, stoves or other apparatus (including amplifiers) that produce heat.

9. Do not defeat the safety purpose of the polarized or grounding-type plug. A polarized plug has two blades with one wider than the other. A grounding-type plug has two blades and a third grounding prong. The wide blade or the third prong is provided for your safety. If the provided plug does not fit into your outlet, consult an electrician for replacement of the obsolete outlet.

10. Protect the power cord from being walked on or pinched, particularly at plugs, convenience receptacles and the point where they exit from the apparatus.

11. Only use attachments/accessories specified by the manufacturer.

12. Use only with the cart, stand, tripod, bracket or table specified by the manufacturer or sold with the apparatus. When a cart is used, use caution when moving the cart/apparatus combination to avoid injury from tip-over.

heat such as sunshine, fire or the like.

Figure A. Example of Antenna Grounding as per National ElectricalCode ANSI/NFPA 70

English

THANK YOU FOR CHOOSING JBL

INPUTMUTE

VOL









CODE

1234

TO RIGHT SPEAKER

+–









LEFT-CHANNEL SPEAKER

SUB-OUT LINE-IN

DC 20V

+–



RIGHT-CHANNEL SPEAKER

TO LEFT SPEAKER

CODE

1234







INPUT

For more than 60 years, JBL has been involved in every aspect of music and film recording and reproduction, from live performances to the recordings you play in your home, car or office.

We’re confident that the JBL system you have chosen will provide every note of enjoyment that you expected – and that when you think about purchasing additional audio equipment for your home, car or office, you will once again choose JBL.

Please take a moment to register your product on our Web site at www.jbl.com. It enables us to keep you posted on our latest advance-ments, and helps us to better understand our customers and build products that meet their needs and expectations.

The JBL

On Air Control®2.4G AW is an advanced wireless loudspeaker system that allows you to enjoy your favorite music in remote locations around your home, or to add surround speakers to your home theater system without running wires to the back of the room. To ensure trouble-free performance, please carefully read these instructions completely before connecting or using the system.

UNPACKING THE SYSTEM

Carefully unpack the system. If you suspect damage from transit, report it immediately to your dealer and/or delivery service. Keep the shipping carton and packing materials for future use. Open the package and verify the following contents:

Included

1 x Transmitter module

1 x Power supply for transmitter 1 x 230V 2-Prong AC power cord for transmitter power supply 1 x Wall-mount bracket for transmitter with 2 x panhead

M3 x 4 machine screws for attaching wall-mount bracket to transmitter

4 x Small round self-adhesive feet – to be attached on transmitter’s left side panel if transmitter is to be used vertically

1 x Active speaker/receiver (left-channel speaker)

1 x Power supply for active speaker/receiver 1 x Wall-mount holder for active speaker/receiver universal

power supply 1 x Passive speaker (right-channel speaker) 2 x Terminal covers for active and passive speakers 6 x M3 x 8 self-tapping screws to attach terminal covers 2 x Wall-mount rotatable brackets for active and passive speakers

(includes bar wrench and backup cords) 1 x Remote control 1 x Interconnect cable (1m/3.3 ft. RCA – RCA) 1 x Interconnect cable (1m/3.3 ft. RCA – 3,5mm (1/8-inch) mini plug) 10m/33 ft. x Speaker wire 1 x Owner’s manual (multilanguage)

Remote Control

Left/Active Speaker (Rear)

Right/Passive Speaker

Wireless Transmitter

+ 8 hidden pages