JBL 2.4G User Manual
JBL®ON AIR
CONTROL®2.4G
OWNER’S GUIDE
®
FEDERAL COMMUNICATIONS
C
OMMISSION INTERFERENCE
STATEMENT
This equipment has been tested and found to comply with the limits for a
Class B digital device, pursuant to Part 15 of the FCC Rules. These limits are
designed to provide reasonable protection against harmful interference in a
residential installation.
This equipment generates, uses and can radiate radio frequency energy and, if
not installed and used in accordance with the instructions, may cause harmful
interference to radio communications. However, there is no guarantee that
interference will not occur in a particular installation. If this equipment does
cause harmful interference to radio or television reception, which can be
determined by turning the equipment off and on, the user is encouraged to try
to correct the interference by one of the following measures:
• Reorient or relocate the receiving antenna.
• Increase the separation between the equipment and receiver.
• Connect the equipment into an outlet on a circuit different from that to
which the receiver is connected.
• Consult the dealer or an experienced radio/TV technician for help.
FCC Caution: To assure continued compliance, any changes or modifications
not expressly approved by the party responsible for compliance could void the
user’s authority to operate this equipment. (Example – use only shielded interface cables when connecting to computer or peripheral devices.)
FCC Radiation Exposure Statement
This equipment complies with FCC RF radiation exposure limits set forth for an
uncontrolled environment. This equipment should be installed and operated
with a minimum distance of 20 centimeters between the radiator and your body.
This device complies with Part 15 of the FCC Rules. Operation is subject to the following
two conditions: (1) This device may not cause harmful interference, and (2) This device
must accept any interference received, including interference that may cause undesired
operation.
We, Harman Consumer Group International
2, route de Tours
72500 Ch
France
declare in own responsibility that the product
described in this owner
with technical standards:
EN 61000-6-3:2001
EN 61000-6-1:2001
Declaration of Conformity
âteau du Loir
s manual is in compliance
’
Declaration of Conformity
We, Harman Consumer Group International
2, route de Tours
âteau du Loir
72500 Ch
France
declare in own responsibility that the product
described in this owner’s manual is in compliance
with technical standards:
EN 55013:2001+A1:2003
EN 55020:2002+A1:2003
EN 61000-3-2:2000
EN 61000-3-3:1995+A1:2001
EN 60065:2002
EN 301489-1 V 1.6.1:2005
EN 301489-17 V 1.2.1:2003
EN 300328 V 1.6.1:2004
Harman Consumer Group International
Laurent Rault
Ch
âteau du Loir, France 2/07
Harman Consumer Group International
Laurent Rault
Ch
âteau du Loir, France 2/07
2
READ FIRST! Important Safety Precautions!
13. Unplug this apparatus during lightning
torms or when unused for long periods
s
of time.
14. Refer all servicing to qualified service
ersonnel. Servicing is required when the
p
apparatus has been damaged in any way,
uch as power-supply cord or plug is dam-
s
aged, liquid has been spilled or objects have
fallen into the apparatus, the apparatus has
een exposed to rain or moisture, does not
b
operate normally, or has been dropped.
15. Do not use attachments not recommended
y the product manufacturer, as they may
b
cause hazards.
16. This product should be operated only
from the type of power source indicated on
the marking label. If you are not sure of the
type of power supply to your home, consult
your product dealer or local power company.
For products intended to operate from battery
power or other sources, refer to the operating instructions.
17. If an outside antenna or cable system
1. Read these instructions.
2. Keep these instructions.
3. Heed all warnings.
4. Follow all instructions.
5. Do not use this apparatus near water.
6. Clean only with a dry cloth.
7. Do not block any ventilation openings.
Install in accordance with the manufacturer’s
instructions.
8. Do not install near any heat sources such
as radiators, heat registers, stoves or other
apparatus (including amplifiers) that produce
heat.
9. Do not defeat the safety purpose of the
polarized or grounding-type plug. A polarized
plug has two blades with one wider than the
other. A grounding-type plug has two blades
and a third grounding prong. The wide blade
or the third prong is provided for your safety
the provided plug does not fit into your outlet,
consult an electrician for replacement of the
obsolete outlet.
10. Protect the power cord from being
walked on or pinched, particularly at plugs,
convenience receptacles and the point
where they exit from the apparatus.
Only use attachments/accessories
11.
specified by the manufacturer
.
12. Use only with the cart, stand, tripod,
bracket or table specified by the
manufacturer or sold with the
apparatus. When a cart is used,
use caution when moving the
cart/apparatus combination to
avoid injury from tip-over
.
is connected to the product, be sure the
antenna or cable system is grounded so as
to provide some protection against voltage
surges and built-up static charges. Article
810 of the National Electrical Code, ANSI/
NFPA 70, provides information with regard to
proper grounding of the mast and supporting
structure, grounding of the lead-in wire to an
antenna discharge unit, size of grounding
conductors, location of antenna-discharge
unit, connection to grounding electrodes, and
requirements for the grounding electrode.
See Figure A.
18. An outside antenna system should not be
located in the vicinity of overhead power
lines or other electric light or power circuits,
or where it can fall into such power lines or
circuits. When installing an outside antenna
system, extreme care should be taken to keep
from touching such power lines or circuits, as
. If
contact with them might be fatal.
Figure A.
Example of Antenna Grounding as per National
Electrical Code ANSI/NFPA 70
19. Do not overload wall outlets, extension
ords, or integral convenience receptacles,
c
as this can result in a risk of fire or electric
shock.
0. Never push objects of any kind into this
2
product through openings, as they may touch
angerous voltage points or short-out parts,
d
which could result in a fire or electric shock.
Never spill liquid of any kind on the product.
21. The apparatus shall not be exposed to
dripping or splashing, and no objects filled
with liquids, such as vases, shall be placed
n the apparatus.
o
22. Do not attempt to service this product
yourself, as opening or removing covers may
expose you to dangerous voltage or other
hazards. Refer all servicing to qualified
service personnel.
23. When replacement parts are required,
be sure the service technician has used
replacement parts specified by the manufacturer or that have the same characteristics
as the original part. Unauthorized substitutions may result in fire, electric shock or
other hazards.
24. Upon completion of any service or repairs
to this product, ask the service technician to
perform safety checks to determine that the
product is in proper operating condition.
25. The product should be mounted to a
wall or ceiling only as recommended by the
manufacturer.
3
THANK YOU FOR CHOOSING JBL
RL
ID
CODE
1234
A
B
CD
INPUT
I
+–
9
RIGHT-CHANNEL SPEAKER
TO LEFT SPEAKER
ID
CODE
1234
TO RIGHT SPEAKER
+–
4
5
68
9
7
LEFT-C HANNEL SPEAKER
R
SUB-OUT LINE-IN
DC 20V
I
NPUTMUTE
VOL
1
2
0
3
For more than 60 years, JBL has been involved in every aspect of music and
film recording and reproduction, from live performances to the recordings you
play in your home, car or office.
We’re confident that the JBL system you have chosen will provide every note
of enjoyment that you expected – and that when you think about purchasing
additional audio equipment for your home, car or office, you will once again
choose JBL.
Please take a moment to register your product on our Web site at www.jbl.com.
It enables us to keep you posted on our latest advancements, and helps us
to better understand our customers and build products that meet their needs
nd expectations.
a
®
emote Control
R
he JBL
T
®
n Air Control
O
®
.4G is an advanced wireless loudspeaker system
2
that allows you to enjoy your favorite music in remote locations around your
home, or to add surround speakers to your home theater system without
running wires to the back of the room. To ensure trouble-free performance,
please carefully read these instructions completely before connecting or using
the system.
UNPACKING THE SYSTEM
Carefully unpack the system. If you suspect damage from transit, report it
immediately to your dealer and/or delivery service. Keep the shipping carton
and packing materials for future use. Open the package and verify the following contents:
Included
1 x Transmitter module
1 x Universal power supply for transmitter
1 x 120V 2-Prong AC power cord for transmitter power supply
1 x 230V 2-Prong AC power cord for transmitter power supply
1 x Wall-mount bracket for transmitter with 2 x panhead M3 x 4 machine
screws for attaching wall-mount bracket to transmitter
4 x Small round self-adhesive feet – to be attached on transmitter left
side panel if transmitter to be used vertically
1 x Active speaker/receiver (left-channel speaker)
1 x Universal power supply for active speaker/receiver
1 x 120V 3-Prong AC power cord for active speaker/receiver power
supply
1 x 230V 3-Prong AC power cord for active speaker/receiver power
supply
1 x Wall-mount holder for active speaker/receiver universal power
supply
1 x Passive speaker (right-channel speaker)
2 x Wall-mount rotatable brackets for active and passive speakers
(includes bar wrench and backup cords)
1 x Remote control
1 x Interconnect cable (1m/3.3 ft. RCA – RCA)
1 x Interconnect cable (1m/3.3 ft. RCA – 1/8-inch mini plug)
10m/33 ft. x Speaker wire
1 x Owner’s manual (multilanguage)
1 x USA warranty sheet
4
Left/Active Speaker
Rear)
(
Wireless
Transmitter
Right/Passive
Speaker
Loading...