Read these instructions, heed all warnings and keep for future reference.
•
Do not use this apparatus near water.
•
Clean only with a dry cloth.
•
Do not block any ventilation openings; a minimum distance of 10mm around the entire apparatus is required for sufficient ventilation.
•
No naked flame sources, such as lighted candles, should be placed on or near the apparatus.
•
Attention should be drawn to the environmental aspects of battery disposal.
•
The apparatus is to be used in moderate climates only.
•
Do not install near any heat sources such as radiators, heat registers, stoves or other apparatuses (including amplifiers) that produce heat.
•
Protect the power cord from being walked on or pinched, particularly at the plugs and convenience receptacles, and at the point where they exit from the
•
apparatus.
Only use attachments/accessories specified by the manufacturer.
•
Unplug this apparatus during lightning storms or when unused for long periods of time.
•
Refer all servicing to qualified service personnel. Servicing is required when the apparatus has been damaged in any way, such as the power supply •cord or plug is
damaged, liquid has been spilled or objects have fallen into the apparatus, or the apparatus has been exposed to rain or moisture, does not operate normally, or has
been dropped.
To be completely disconnected from the power input, the main plug of the AC/DC adapter shall be disconnected from the main.
•
The main plug of the AC/DC adapter should not be obstructed OR should be easily accessed during intended use.
•
The marking information is located at the bottom of the apparatus.
•
The battery shall not be exposed to excessive heat such as sunshine, fire or the like.
•
The apparatus and AC/DC adapter shall not be exposed to dripping or splashing, and no objects filled with liquids, such as vases, shall be placed on the apparatus
•
and AC/DC adapter.
TO PREVENT THE RISK OF ELECTRIC SHOCK, DO NOT REMOVE THE COVER (OR BACK). THERE ARE NO USER-SERVICEABLE PARTS INSIDE THIS UNIT. PLEASE
•
REFER SERVICING TO QUALIFIED HARMAN CONSUMER GROUP, INC., SERVICE PERSONNEL.
Never remove grille covers in order to service the speaker system. The speaker system does not contain any user-serviceable parts.
•
IMpOrTanT nOTE fOr all ElEcTrOnIc prODUcTs:
Before inserting or unplugging audio cables from the source device’s headphones or line-level output jacks, it is good practice to turn off the device
first. This will prolong the life of your unit, help protect your device from static electricity and prevent potential damage.
2
jbl On TIME 200iD UsEr GUIDE
3
fcc sTaTEMEnT anD WarnInG
This device complies with Part 15 of the FCC Rules. Operation is subject to the following two conditions: 1) this device may not cause harmful interference, and
2) this device must accept any interference received, including interference that may cause undesired operation.
This equipment has been tested and found to comply with the limits for a Class B digital device, pursuant to Part 15 of the FCC Rules. These limits are designed to
provide reasonable protection against harmful interference in a residential installation. This equipment generates, uses and can radiate radio frequency energy
and, if not installed and used in accordance with the instructions, may cause harmful interference to radio communications. However, there is no
guarantee that interference will not occur in a particular installation. If this equipment does cause harmful interference to radio or television reception, which
can be determined by turning the equipment off and on, the user is encouraged to try to correct the interference by one or more of the following measures:
Reorient the receiving antenna. •
Increase the separation between the equipment and receiver. •
Connect the equipment into an outlet on a circuit different from that to which the receiver is connected. •
Consult the dealer or an experienced radio/TV technician for help. •
Any special accessories needed for compliance must be specified in the instruction manual.
MODIFICATIONS NOT EXPRESSLY APPROVED BY THE MANUFACTURER COULD VOID THE USER’S AUTHORITY TO OPERATE THE EQUIPMENT UNDER FCC RULES.
The normal function of the product may be disturbed by strong electromagnetic interference. If so, simply reset the product to resume normal operation by
following the instruction manual. In case the function could not resume, please use the product in another location.
English
THE LIGHTNING
FLASH AND
ARROWHEAD
WITHIN THE
TRIANGLE IS A
WARNING SIGN
ALERTING YOU
TO DANGEROUS
VOLTAGE INSIDE
THE PRODUCT.
CAUTION
rIsK Of ElEcTrIc
sHOcK — DO nOT OpEn
CAUTION: TO REDUCE
THE RISK OF SHOCK, DO
NOT REMOVE COVER. NO
USER-SERVICEABLE PARTS
INSIDE. REFER SERVICING
TO QUALIFIED SERVICE
.
PERSONNEL
THE EXCLAMATION
POINT WITHIN
THE TRIANGLE IS
A WARNING SIGN
ALERTING YOU
TO IMPORTANT
INSTRUCTIONS
ACCOMPANYING
THE PRODUCT.
WarnInG: TO PREVENT FIRE OR
ELECTRICAL SHOCK HAZARD, DO NOT EXPOSE
THIS PRODUCT TO RAIN OR MOISTURE.
WarnInG: THE APPARATUS SHOULD
NOT BE EXPOSED TO DRIPPING OR SPLASHING
AND NO OBJECTS FILLED WITH LIQUID, SUCH AS
VASES, SHOULD BE PLACED ON THE APPARATUS.
IMpOrTanT:
THE APPROPRIATE ADAPTER MUST BE INSTALLED BEFORE
INSERTING YOUR iPod INTO THE JBL
THAT THE CONNECTOR FOR THE iPod IS PROPERLY ALIGNED
WITH THE JBL PRODUCT’S CONNECTOR WHEN INSTALLING
YOUR iPod. FAILURE TO DO SO MAY CAUSE PERMANENT
DAMAGE TO THE CONNECTOR FOR THE iPod, RENDERING
THE iPod INOPERABLE.
®
PRODUCT. MAKE SURE
WWW.jbl.cOM
jbl On TIME™ 200iD
The JBL On Time™ 200ID high-performance loudspeaker dock and clock radio for iPod will revolutionize the way you listen to your radio,
use your iPod, and wake from a good night’s sleep.
The JBL On Time 200ID system is a revolution in time travel. Imagine waking up to music on your favorite station or your iPod, with no
more buzzer or bad radio reception. The compact time machine and sound center, when connected to your iPod, MP3 player or other
music source, produces clean, powerful sound while providing time-keeping, alarm and radio features. The system is the world’s first
time machine with an intuitive user interface that is easier than ever to navigate.
The JBL On Time 200ID loudspeaker dock has full ability to navigate your iPod via IR remote. Also, not only can you wake up to your
favorite radio station or song on your iPod, but with the multiple alarm setting option, you can set up to seven different alarms for “His”
and “Hers,” at whatever day or frequency needed.
OnEpOInT DEsIGn
The OnePoint connectors provide the connection to your computer. Connect the standard cable for iPod to the rear of
the JBL On Time 200ID unit, and every time you dock your iPod, you’ll have a connection for synchronizing.
EvErcHarGE TOpOlOGy
The JBL On Time 200ID speaker dock charges your iPod, even when it’s not connected to the computer or the system is off. The system’s
memory is maintained by a backup battery. Even with the power out, it will provide the alarm function.
cOE (cOMpUTEr-OpTIMIzED EqUalIzaTIOn)
The JBL On Time 200ID system equalization is computer-optimized to provide a rich, complete soundstage.
OcT (OpTIMIzED cOMprEssIOn TOpOlOGy)
The JBL On Time 200ID radio and loudspeaker dock utilizes a proprietary compression technology to ensure clean, accurate sound at
high output levels.
DIsplay
The large, backlit LCD enables easy viewing and menu navigation. Automatic dimming sets the correct brightness level in any
room environment.
4
jbl On TIME 200
iD UsEr GUIDE
5
FM ANT
AM ANT
AUX-INUSB
DC 15V
FM ANT
AM ANT
AUX-INUSB
DC 15V
UnpacKInG yOUr jbl On TIME™ 200iD
Carefully unpack your speaker system and identify all its components:
IR remote
FM antenna
English
JBL On Time
™
200IDPower supplyAM antenna
Adapters for iPod
Audio cable
qUIcK sETUp InsTrUcTIOns
Choose the appropriate adapter for iPod and place it into the docking station. Then place your iPod into the adapter.
•
For backup memory, install three AAA batteries in the battery compartment underneath the unit.
•
Connect the external AM antenna for better reception.
•
Unwind the FM antenna and straighten the wire for the best reception.
•
Plug the power adapter into the “DC In” jack and then plug the adapter into a wall outlet.
•
If an additional audio source is used, connect the source to the “Aux In” jack.
•
AAA
AAA
AAA
Aux InDC In
WWW.jbl.cOM
Loading...
+ 11 hidden pages
You need points to download manuals.
1 point = 1 manual.
You can buy points or you can get point for every manual you upload.