Page 1
www.jbctools.com
INSTRUCTION MANUAL
Rework Left Hand Support
Ref. HRL-A
Page 2
Packing List
The following items are included:
Tool Arm .................................................... 1 u nit
Ref. HRL-A
Manual ......................................................... 1 un it
Re f. 0 0 24160
www.jbctools.com
INSTRUCTION MANUAL
Rework Left Hand Support
Ref. HRL-A
Height adj. Knob...................................... 1 unit
Ref. 0023991
2
Page 3
Assembly
Setting up the Tool Arm
Insert the height adjuster and the arm on the
shaft and adjust the knob.
In case of using both left and right arms, set
them as shown in the picture, according with
the letter back of the arm support, to keep the
supports at the same height.
Height Adjustment
The support allows adjustment for different
heights according to your work needs through
the vertical axis.
Slide the arm to the appropriate height and
secure by tightening the knob to guarantee
stability.
www.jbctools.com
Knob
Maintenance
- Check periodically that the Hand Support is
clean,especially the sliding parts and the shaft.
- Use a damp cloth when cleaning. Alcohol
can only be used to clean the metal parts.
- Replace any defective damaged parts.
Use original JBC spare parts only.
Not leave up the Arms over the PH
when PH is working.
Keep the sliding
parts clean
3
Page 4
Work Position Adjustment
The RHB-A arm allows adjustment for different positions according to your work needs.
The articulated arm covers all work areas.
Top view
See the work correct position of the hand in the following images.
4
Page 5
Accessories
Hot Air Heater Arm
Ref. 0024368
www.jbctools.com
Shaft for Hot Air Heater Arm
Ref. 0024369
Rework Right Arm Support
Ref. HRR-A
IR Preheater Support
Ref. PHB-SA
5
Page 6
Safety
It is imperative to follow safety guidelines to prevent electric shock, injury,
fire or explosions.
- Do not use the equipment for any purpose other than PCB rework. Incorrect use may cause fire.
- The temperature of accessible surfaces may remain high after the unit is turned off. Handle with care.
- Be careful with the fumes produced when soldering.
- Keep your workplace clean and tidy. Wear appropriate protection glasses and gloves when
working to avoid personal harm.
- Not leave up the arms directly above heat surfaces
- Utmost care must be taken with liquid tin waste which can cause burns.
- This appliance can be used by children over the age of eight as well as persons with reduced
physical, sensory or mental capabilities or lacking experience provided that they have been given
adequate supervision or instruction concerning use of the appliance and understand the hazards
involved. Children must not play with the appliance.
- Maintenance must not be carried out by children unless supervised.
6
Page 7
Notes
www.jbctools.com
7
Page 8
Specifications
- Total weight: 1,2 kg (2.65lb)
- Arm lenght: 444,5 mm (17.5 in)
Complies with CE standards
ESD Safe
Warranty
JBC’s 2 year warranty covers this equipment against
all manufacturing defects, including the replacement
of defective parts and labour.
Warrant y does not cover product wear or misuse.
In order for the warranty to be valid, equipment must
be returned, postage paid, to the dealer where it was
purchased.
Register your warranty within 30 days of purchase
in www.jbctools.com/productregistration
This product should not be thrown in the garbage.
In accordance with the European directive 2012/19/EU, electronic equipment at the end of its life
must be collected and returned to an authorized recycling facilit y.
www.jbctools.com
0024160-0120
Loading...