www.jbctools.com
Flux Brush
Ref. FL-A
Packing List
The following items should be included:
Flux Brush .................... 1 unit
Ref. FL-A
Features
FL-A is a flux brush designed
to be used in the preparation
of printed circuits prior to
soldering an SMD component,
especially flat pack integrated
circuits.
2
Manual ........................... 1 unit
Ref. 0011278
www.jbctools.c om
Flux Brush
Ref. FL-A
All you need to do is fill the
barrel with the flux.
Our pens have a retractable
valve in them so you have
complete control of how much
flux you release by gently
squeezing the barrel.
Filling the barrel
www. jbcto ol s.c om
1. Unscrew the brush cap
from the barrel.
1
3. Completely fill with flux and
reseal with the filter cap.
Use JBC Flux and follow the
safety instructions.
2. Remove the filter cap that
seals the flux in the barrel.
2
filter cup
3
3
Specifications
- Capacity: 5.5 ml
Warranty
JBC’s 2 year warranty covers this device
against all manufacturing defects,
including the replacement of defective
parts a nd labour.
Warrant y does not cover product wear
due to use or mis-use.
In order for the warranty to be valid,
equipment must be returned, postage
paid, to the dealer where it was
purchased.
This product should not be thrown in the garbage.
In accordance with the European directive 2002/96/EC,
electronic equipment at the end of its life must be
collected and deposited at an authorized recycling facility.
www.jbctools.com
0011278/0615
Loading...