Jazz DV151 Instruction Manual

JJaazzzz DDVV115511
IInnssttrruuccttiioonn MMaannuuaall
2
GGeenneerraall NNootteess// PPrreeccaauuttiioonnss::
Please read this Instruction Manual fully in order to become familiar with your camera; enjoy maximum performance and preserve its service life.
u Camera must first have 2 AA batteries and SD card (or MMC card) installed in order to
operate. These are NOT supplied included. Video clips can be recorded only when card is inserted. SD Memory cards and AA alkaline batteries are readily available at most stores.
u SD cards must NOT be exposed to heat, moisture or strong magnetic field as the
memory could be lost or damage. Do not bend or force SD card when inserting into the camera slot as card is a delicate electronic device that needs careful handling
u Remove batteries if you do not plan to use camera for a few weeks u Avoid exposing camera to direct sunshine or excessively high temperatures (such as
inside parked car).
u Avoid exposing camera to dirty, sandy or wet environments or harmful chemicals. u Carefully clean sand or dust from the surface of the camera if contaminated, Use soft
rag or tissue for cleaning lens if required. Avoid use of any solvent to clean camera and lens.
u TV programs, movies, music, pictures and other records may be subject to copyright
protection.
u It is your responsibility to comply with copyright regulations.
3
FCC statement
FCC part 15.21
Warning: Changes or modifications to this unit not expressly approved by the party responsible for compliance could void the users authority to operate the equipment.
FCC part 15.105
Note: This equipment has been tested and found to comply with the limits for a Class B digital
device, pursuant to Part 15 of the FCC Rules. These limits are designed to provide reasonable protection against harmful interference in a residential installation. This equipment generates, uses, and can radiate radio frequency energy and, if not installed and used in accordance with the instructions, may cause harmful interference to radio communications. However, there is no guarantee that interference will not occur in a particular installation. If this equipment does cause harmful interference to radio or television reception, which can be determined by turning the equipment off and on, the user is encouraged to try to correct the interference by one or more of the following measures:
- Reorient or relocate the receiving antenna.
- Increase the separation between the equipment and receiver.
- Connect the equipment into an outlet on a circuit different from that to which the receiver is connected.
4
SSyysstteemm rreeqquuiirreemmeennttss
Please note that your computer must comply with minimal system requirements as stated below in order to operate properly with your camera:
System Requirements Operating System
Microsoft Windows Me, 2000, XP, Vista
Central Processing unit
Intel Pentium 166MHz or above
Available Memory
Above 128 MB
Sound Card,
Video Card
Sound Card / Video C
ard shall support
DirectX8 or higher version. CD Drive 4 times speed or above Hard Disk Available space above 500 MB Other Available standard USB 1.1 or USB 2.0 port
5
Cameras package contains
Camera Applied CD user manual USB cable TV cable
6
GGeettttiinngg kknnooww yyoouurr ccaammeerraa
Key definition:
1 LCD screen 2 Direction buttons 3 Playback/Stop button 4 Power on/off switch 5 Shutter button 6 Delete button 7 Battery cover 8 Battery cover release 9 USB Slider Switch 10 Lens 11 Front cover trim patch 12 Busy light 13 Speaker 14 LCD (Fold out LCD panel) 15 SD/MMC Card slot 16 USB port 17 TV Output Socket 18 Tripod socket
7
UUssiinngg yyoouurr ccaammeerraa
mm IInnssttaalllliinngg bbaatttteerriieess
To open depress the Battery Cover release (8) and simultaneously slide down the Battery Cover (7). Insert two, fresh AA Alkaline batteries carefully matching battery polarity with the plus and minus terminal markings.
m Installing SD/MMC ccaarrdd (not supplied)
Camera works with SD / MMC memory card up to 2GB capacity Insert card carefully into the SD / MCC Card Slot according to the Direction Mark. Do NOT force. Press down until it locks; push it down again to remove / replace the card.
Note: l SD Card has a tiny LOCK slider on the side. You can not record any video clip when the card is in locked position - slide the switch to unlock the card.
Stop recording / playback before you attempt to remove / replace the SD Card.
mm TTuurrnniinngg ccaammeerraa OONN
Press and momentarily hold down the Power on / off switch. Camera becomes active and LCD screen displays images in Preview mode. In this Mode you can adjust /
select desired zoom setting for your intended picture – press UP or DOWN Direction Buttons to set desired effect. Please notice 1.0X digit indicating the initial zoom setting. 1.0X is the Default setting – no digital zoom is activated.
Loading...
+ 14 hidden pages