Jaypro Sports PVB-1350 User Manual

JAYPRO SPORTS

POWER VOLLEYBALL, PVB-1350

LIST OF MATERIALS

PIECE NO. PART NO. DESCRIPTION QTY.

1 VB-1350U UPRIGHT 2
2 VBWINCH WINCH 1
3 VBA-4 VOLLEYBALL ANTENNA 1
4 PVBN-6 VOLLEYBALL NET 1
5 PVB-13-7 ANCHOR END CLAMP COLLAR 1
6 PVB-13-8 TOP ROLLER CLAMP COLLAR 1
7 PVB-13-9 BOTTOM SLIDING COLLAR 2
8 HN265 3/8”-16 NYLON LOCK NUT 1
9 HS294 3/8”-16 x 4 ½” HX HD CAP SCREW 1
10 HM5019 CARABINER 3/8 x 4 1
11 CN0001-24 CHAIN 24 INCHES 1

ASSEMBLY INSTRUCTIONS

1) Assemble winch assembly to upright with hole as shown.

2) Place uprights in sleeves (see instructions included in with the sleeves for their installation).

3) Place bottom sliding collars over the poles approximately 3 feet beyond where top net height will be. Tighten
wing bolts just enough to hold in place. You will need to fine tune their location later.

4) Place top roller clamp collar on pole and position top of clamp approximately ¾” higher than the desired net
height. For example if you are setting net to women’s volleyball height, (7’-4 1/8”) set the top of the collar to
7’-4 7/8”. Align clamp collar with winch assembly and tighten securely.

5) Place top anchor end clamp collar on the pole and position approximately 1 ¼” higher than desired net height
(see above). Tighten securely.

6) Slip the net dowels into the side pockets on each end of the net. Position the net between the 2 uprights.

7) Thread the webbing strap from the winch over the roller clamp and connect the end of the cable to the snap
buckle. Connect the other end of the net to a Carabiner and the length of chain provided and attach that end
of the chain to the top anchor end clamp (step 5) with the other Carabiner.

8) Adjust the length of the chain as necessary to center net on court.

9) The net will stretch ~6-8 inches when tension is applied so you must factor this in before applying tension and
when centering the net.

10) Slowly tension the top webbing strap by cranking the winch with the winch handle. Adjust chain as
necessary to keep the net centered.

11) Verify net heights and net centering. The uprights will deflect inward and downward due to net tension; you
may need to adjust heights and /or re-center the net. Warning: Release tension from the net before
loosening any hardware from the uprights.

12) Attach the bottom net straps by wrapping the long ends of the net side straps around the uprights below the
bottom sliding collars and fasten them through the buckles located on the opposite side. Wrap the Velcro
straps around buckles for additional player safety. For best results, adjust the side straps so that the volleyball
net will be centered within the playing area.

13) Raise the center of the net to the full official net height by cranking the handle. Adjust all net side straps to
further tension the net.

14) When releasing the tension on the unit unfasten the bottom straps first, then release the tension on the top.

15) To remove the unit for storage, disconnect the net from the 2 uprights and carefully lift each upright from the
floor sleeve.

16) For player safety cut any excess chain before putting system into service.

INSTALLATION AND USE CONSIDERATIONS

1) The unit is designed for high level competition play. Consequently, when installed and operational, the unit is
subject to considerable stress loads. It is essential to inspect all parts before each use.

2) Do not use this equipment without the protective upright padding properly fastened in place.

T:\documents\MFG Installs\PVB-1350.doc UPDATED 12/3/2010