JAYPRO SPORTS
PVB-130C
CENTER STANDARD MULTI-PURPOSE ALUMINUM NET SYSTEM
LIST OF MATERIALS
ITEM PART # DESCRIPTION QTY
1 PVB130C CENTER STANDARD UPRIGHT 1
2 PVWINCH WINCH 1
3 VBA-4 VOLLEYBALL ANTENNA 1
4 PVBN-6 VOLLEYBALL NETS 1
5 PVB-13-8 TOP ROLLER CLAMP COLLAR 1
6 PVB-13-9 BOTTOM SLIDING COLLAR 2
7 PVB130C2 DOUBLE TOP COLLAR 1
8 HS294 3/8 – 16 x 4 ½ ‘’ HX HD SCREW 1
9 HN265 3/8-16 LOCK NUT 1
10 HM5019 CARABINER 3/8 x 4 2
11 CN0001-24 CHAIN 24 INCHES 1
BEFORE YOU START
THIS TWO COURT SYSTEM IS MADE UP OF A MULTI PURPOSE VOLLEYBALL SYSTEM MODEL
PVB-1350 ALONG WITH THE PVB-130C CENTER STANDARD PACKAGE. SINCE BOTH OF THESE
PACKAGES ARE NORMALLY PURCHASED AND ASSEMBLED AT THE SAME TIME THESE
INSTRUCTIONS TAKE YOU THROUGH THE ASSEMBLY OF BOTH PACKAGES AS A SINGLE
PACKAGE.
UNPACKING
1. UNPACK ALL PARTS AND CHECK AGAINST THE LISTS TO ENSURE THAT ALL PARTS
HAVE BEEN INCLUDED.
2. INSPECT FOR DAMAGE. REPORT ANY AND ALL DAMAGES TO TRUCKING COMPANY.
UPRIGHT ASSEMBLY
1. ASSEMBLY OF UPRIGHTS IS DONE MOST EASILY WITH THE HELP OF A COUPLE OF SAW
HORSES OR A SIX-FOOT FOLDING TABLE. LAY THE THREE UPRIGHTS ON THE SAW
HORSES. (BE CAREFULL THE UPRIGHTS DO NOT ROLL OFF AS THEY COULD CAUSE
SERIOUS INJURY) YOU WILL NOTICE THAT THEY ARE ALL IDENTICAL AND THE END
WITH THE WHITE PLASTIC PLUG IS THE FOOT.
2. ASSEMBLE THE WINCHES ON TWO OF THE UPRIGHTS (SEE THE WINCH ASSEMBLY
DIRECTIONS PVB SERIES AND FOLLOW INSTRUCTIONS FOR THE 3 1/2 INCH UPRIGHT).
THE WINCHES ARE ADDITIONALLY SECURED TO THE UPRIGHTS WITH 4 1/2 INCH LONG
BOLTS AND NUTS THAT ARE PROVIDED WITH THE UPRIGHTS. SEE DETAIL AA
3. ON EACH OF THE TWO UPRIGHTS YOU’VE JUST ATTACHED WINCHES, SLIDE A BOTTOM
SLIDING COLLAR AND A TOP ROLLER CLAMP COLLAR. PLACE THESE COLLARS AT
THEIR APPROXIMATE PLAYING POSITION (SEE DIAGRAM) AND LOOSELY TIGHTEN. YOU
WILL FINE TUNE THEIR LOCATION LATER
4. ON THE REMAINING UPRIGHT FROM THE TOP (IN THIS ORDER) SLIDE TWO BOTTOM
SLIDING COLLARS, THE ANCHOR END CLAMP, AND LASTLY THE DOUBLE TOP COLLAR.
PLACE IN THEIR APPROXIMATE PLAYING POSITION AND AGAIN JUST LOOSELY TIGHTEN.
T:\documents\MFG Installs\PVB-130C.doc UPDATED 2/3/2011