Jaypro Sports PB-95SM User Manual

Jaypro Sports

976 Hartford Turnpike

Waterford, CT 06385 USA

[phone]

www.jaypro.com

[phone] Fax

MODEL NO.:

PRODUCT NAME:

EFFECTIVE DATE:

DRAWN BY: MT

2/2/2011

8

7

7

SEE VIEW
A-A

1

2

4

9" TYP

EACH END

VIEW A-A

6

5

3

NOTE

DUE TO THE WIDE VARIATIONS IN

FLOOR CONSTRUCTION AND MATERIALS,

LEG ANCHORS AND ASSOCIATED HARD-

WARE ARE NOT PROVIDED. IT IS THE

INSTALLERS RESPONSIBILITY TO

DETERMINE THE SUITABILITY OF THE

FASTENERS.

REPLACEMENT, PLEASE CALL YOUR DEALER

MENT MAY BE HAZARDOUS. FOR REPAIR OR

3) ALTERATION OR MODIFICATION OF EQUIP-

INTENDED, MAY BE HAZARDOUS.

2) USE OF THIS EQUIPMENT OTHER THAN

PERFORMED BEFORE EACH USE

INSPECTION AND MAINTENANCE MUST BE

HIGH PERFORMANCE FROM THIS EQUIPMENT,

1) FOR SAFE OPERATION AND CONTINUED

PLEASE NOTE:

PB-95SM

27' PLAYERS BENCH

76 1/2" TYP

CTR TO CTR

JAYPRO SPORTS

27’ PLAYER’S BENCH, PB-95SM

LIST OF MATERIALS

PIECE # PART # DESCRIPTION QTY.
1 AR5111 SEAT PLANK 27’ 1
2 SML BENCH LEG 5
3 HN5046 5/16” FLANGE NUT 10
4 EP0018 2” x 2” END CAP 10
5 HB5030 5/16”-18 x 3” CARRIAGE BOLT 10
6 AR5044 HOLD DOWN CLIP 10
7 AR5045A END CAP 2
8 HS5035 #8 PAN HEAD SCREW x ½” 4

ASSEMBLY INSTRUCTIONS

TOOLS REQUIRED: PHILLIPS SCREWDRIVER BIT W/ ELECTRIC DRILL (1),
½” SOCKET WRENCH OR ADJUSTABLE WRENCH (1)

1) Slip the end caps (7) snugly onto each end of the plank (1). Using the electric
drill, assemble a self-drilling screw (8) through the cap and into the flange of
the plank. Two screws are required per end cap.

2) For easiest assembly, position seat plank (1) on a level raised surface such
as a desk top, bleacher seat or work bench. Place the carriage bolt (5) and
bolt clips (6) approximately into place within the slots of the plank. Note that
the legs should be no more than 8” from the plank edge or 9” from edge to
center leg.

3) Position the legs as shown and loosely assemble the hardware illustrated in
detail ‘a-a’. Do not fully tighten the hardware at this time. Level the bench
and make sure the legs are adequately spaced apart. Tighten all fasteners
fully.

4) Locate assembled bench into position and carefully mark the hole locations
for each mounting plate. Use fasteners (minimum 3/8” diameter) appropriate
for your surface material. Follow manufacturer’s instructions fully.

REV- 5/9/2011