Jaypro Sports PB-75 User Manual

JAYPRO SPORTS

7 ½’ PLAYER’S BENCH, PB-75

LIST OF MATERIALS

PIECE #
1 AR5046 SEAT PLANK 1
2 PB751 BENCH LEG 2
3 HN5046 5/16” FLANGE NUT 4
4 EP0018 2” x 2” END PLUG 8
5 HB196 5/16”-18 x 1 ¼” CARRIAGE BOLT 4
6 AR5044 HOLD DOWN CLIP 4
7 AR5045 END CAP 2
8 HS5035 #8 PAN HEAD SCREW x ½” 4

TOOLS REQUIRED: Phillips Screwdriver Bit With Electric Drill (1),
½” Socket Wrench Or Adjustable Wrench (1)

1) Slip the end caps (7) snugly onto each end of the plank (1). Using the electric

2) For easiest assembly, position seat plank (1) on a level raised surface such

3) ,Position the legs as shown and loosely assemble the hardware illustrated in

4) Stand the unit upright and assemble the backrest plank (8) as illustrated.

PART # DESCRIPTION QTY

ASSEMBLY INSTRUCTIONS

drill, assemble a self-drilling screw (8) through the cap and into the flange of
the plank. Two screws are required per end cap.

as a desk top, bleacher seat or work bench. Place the carriage bolt (5) and
bolt clips (6) approximately into place within the slots of the plank. Note that
the legs should be no more than 8” from the plank edge.

detail ‘A-A’. Do not fully tighten the hardware at this time.

Level the bench and make sure the legs are adequately spaced apart.
Tighten all fasteners fully.